Last post on Dec 03, 2013 at 5:05 AM
You are in the Chrysler Sebring
What is this discussion about?
Go to NHTSA to file a safety complaint.
Or call Monday-Friday (8 am to 8 pm ET) (888) 327-4236 TTY: (800)424-9153
#228 of 269 Re: 98 Chrysler Sebring Stalls on highway rpms drop and dies [buffetfan6999]
Dec 23, 2011 (8:05 pm)
I read that your dad is a mechanic and you have the same year sebring i have. I would like to know what is draining my battery. if i do not start my car at least every two days the battery dies. had the battery tested and it is good
#229 of 269 Re: 97 Sebring Convertible JX Frustrations for last 6 months [fibreheart]
Jan 10, 2012 (10:56 am)
its most likely a map sensor or the crank sensor found out the hard way
#230 of 269 08 sebring shutting off
Jan 11, 2012 (6:39 pm)
08 sebring. 2.4 engine. It shut off at a red light today, no warning, no engine light. I know there was a recall about the wiring and TMS but I called Chrysler and they said it had been fixed. Called a dealer next. They said not to even bring it in unless the engine light was on. I seen there were a lot of complaints about this. I can't really drive a car that shuts off. Any one know what the problem is?
#231 of 269 Fast Idle and no power
Jan 11, 2012 (10:01 pm)
Hello, I have a 97 LXI sebring with the 2.5 v-6. I have had it to a reputable garage for very fast idle of 1400-1500rpm's. When driving it seems to have no power , The garage showes no codes, and is getting good fuel pressure through the lines. I am not sure where to go at this point, it is in excellent condition with 146,000 miles, I did not get into replacing wires and plugs just yet due to the removal of the intake, but am hesitant only to do that because I have never seen that cause a motor to run fast, but thats why I am looking for help, there is an aweful lot I do not know yet, which way should I go to troubleshoot this problem further. Thanks
#232 of 269 car just will not start
Feb 26, 2012 (4:41 am)
I have a 2007 sebring... when I went to work the car was fine when i got off that night went to the store to put gas in went to started the car it didn't start. all the lights come on, radio and horn work but the will not started i tried to jump it to see if is the battery but no help, This is first time it ever did that. SOMEONE PLEASE HELP ME OUT!!! mother for 3 kids my only cay
#233 of 269 Re: car just will not start [keikei7115]
Feb 26, 2012 (9:55 am)
I've had several older Sebrings. Every time that's happened, it's been a wire or connector has come loose somewhere. Visually inspect everything for that. And/or have it checked for a code. A parts store will do that for free - if you can get it there. If it starts and runs, by accident, have it tested anyway - cause it may do that again. Wish I had a 2007....
#234 of 269 Re: Starting problems after car is warm [josepe]
Mar 03, 2012 (6:51 pm)
Ok everyone here it is my 2001 sebring wouldnt start when the engin was warm... i would disconnect the negitive battery wire,reconnect it and it would start and run fine but when i shut it off and try to restart it i could hear clickig under the hood checked the fuse/relay box opened it and the relays were clicking and you could feel the relays clicking so i replaced 2 or 3 also replaced the camshaft position sensor no luck took it to an auto parts store had them hook it to diagnostic and only read abs huh not that either. took it to an auto mech and they said it was likely the ecc that is the electric control computer in the car bought a new or reconditioned ecc from napa auto parts for $435.93 .Core deposit was $62.69 after core $373.24 then had to bring the car and the ecc to the chrysler dealer to have it flashed /programmed with my car they installed Rick hendricks chrysler jeep dealer in sc savana hwy they charged me a total of $144.30 so all in all $517.54 the car runs starts and makes me love the car again!! hope this helps
#236 of 269 Re: error code "done" [mlbeary]
Jun 14, 2012 (7:26 pm)
Hi, I have just got home from leaving my car in the store carpark as when I got in to start the thing I got the donE message that you had. Did you ever find out what this message means? I am searching online, but no luck finding out so far... hope you can let me know if you found anything out...
#237 of 269 Re: error code "done" [mcallaghan]
Jun 16, 2012 (5:02 pm)
Done error code usually means the memory has been cleared or that no codes were found