252 messages,
Last post on May 08, 2013 at 6:49 PM
You are in the
Chrysler Sebring Forum.
What is this discussion about?
Chrysler Sebring
Go to NHTSA to file a safety complaint.
Or call Monday-Friday (8 am to 8 pm ET) (888) 327-4236 TTY: (800)424-9153
#205 of 252 Re: 97 Sebring Stalls upon acceleration [bsmommy]
by usefullogic
Jul 27, 2011 (6:41 pm)
I'm having this similar problem with my brother's 1999 sebring convertible...I've been doing a lot of research on this, and we are trying to replace the sensors, today he tried replacing the Throttle Position sensor and there was an issue with idling too fast, so reading all the other posts on here we are going to see if it's the idle air control, and use the seafoam cleaner next. It may be too much carbon buildup in the throttle body or air intake and other people said they would try the Seafoam spray, first to clean everything. Just some information I collected from reading countless posts on the computer.
#206 of 252 Re: 97 Sebring Conv. Loses power/stalls when accelerating. [dano853]
by usefullogic
Jul 27, 2011 (6:51 pm)
Have you tried to clean the throttle body with Seafoam Yet? I'm going to try this tomorrow on a 1999 convertible sebring with the same problems....we replaced the TPS today and there is a fast idle that can't be slowed unless you put your hand over the air intake...if it's not the idle air sensor it's because it's dirty? So I'll post back after we try that to see what happens.
#207 of 252 Re: 97 Sebring Stalls upon acceleration [usefullogic]
by bsmommy
Jul 27, 2011 (7:38 pm)
That has been done by a mechanic. Today I drove the car and it did not sputter or stall at all BUT the check engine light came back on. I hooked up our code scanner and it displayed "can not link". Luckily, my dad was able to find me a free PCM.. major bonus for me because I was about to sell the car out for parts and take on a car payment. Hopefully the new PCM will take care of the problem. I've been reading through millions of posts and it seems that I have replaced every thing possible. If the PCM doesn't take care of the problem I will just try to sell the car. Someone suggested to me that it may be the distributor or a wiring problem but all of that was replaced new recently. I have all new sensors. UGH this is such a major pain and I am still lost on what it could possibly be. I'm crossing my fingers that it's just a bad PCM.
#208 of 252 96 sebring will not run
by hightech24
Aug 25, 2011 (6:10 am)
i have a 96 sebring jxi convertable, the car will start and shut down after about 4 seconds of running, the headlights are flashing and a small red light is also flashing on the dash. i think its a security problem anyone have any ideas on how to reset or isolate the problem.
the car will crank and not start if you do not turn the key totally off, but if you turn the key to off, then the car will start and run for the 4 seconds
#209 of 252 Re: 96 sebring will not run [hightech24]
by chettimarelli
Aug 25, 2011 (9:08 am)
Try unlocking the car from passenger side door...otherwise go into dealer and just ask the Service Manager
#210 of 252 Re: 96 sebring will not run [hightech24]
by rbender
Aug 25, 2011 (10:07 am)
Do you have and after market alarm system? Sounds like your alarm system ignition cut out is kicking in. Dispable the alarm system and see it that helps
#211 of 252 Re: 96 sebring will not run [rbender]
by hightech24
Aug 25, 2011 (10:18 am)
no just whatever the car came with
#212 of 252 1997 Chrysler Sebring
by bvaldes67
Aug 25, 2011 (8:18 pm)
I have a 1997 Chrysler Sebring. It did not run for about three months because i was out of town. i just got it working now. The car runs fine while it is cold. As soon as the temperature reaches halfway the car will hicup and eventually stall. If i pour cold water into the radiator after a few miuntes it will start. Does anyone have any idea what could be the problem. All help and suggestions will be greatly appreciated.
Thank you
bernardo valdes
#213 of 252 Re: 2004 sebring with noise from front end [babydolls]
by glues4wood
Sep 12, 2011 (3:58 pm)
Check the motor mounts mine was making some weird noises there also
have a video of the sound here http://www.youtube.com/watch?v=LfN8HgU5Ero
well hopefully it wasn't as much of a pain in the
$$ as mine was after some parts modifying and some grinding to the frame there in now and quiet as a church mouse
#214 of 252 1999 Sebring Convertable Loses power and dies
by snowdogdt
Sep 20, 2011 (3:43 pm)
It acts like it is the alternator, however we have replaced it along with the battery, after charging it will run fine for a while then the lights dim, radio shuts off, lights go out and it starts losing power. I am completely stumped. Any one have any ideas?