Sign In Join 



Honda Prelude 1992-1996

60 messages,  Last post on Oct 16, 2009 at 10:48 AM

You are in the Honda Prelude Forum. Your Host is claires

What is this discussion about? Honda Prelude, Coupe


Messages Page 6 of 6
1
2
3
4
5
6
Prev
Next
Last
Go To Msg #
Search This Discussion

#51 of 60
Re: not sure and everyone i ask has no clue [higashiyama] by rogue4life
Jun 18, 2009 (7:04 am)
Reply

Replying to: higashiyama (Dec 15, 2007 4:35 pm)

yes the light should turn on when you turn the vehicle on and after a few seconds it shuts off like a test light lets ya know its working if it stays on its not working
#52 of 60
Re: Hard 2 find honda engine [czarvibe] by rogue4life
Jun 18, 2009 (7:06 am)
Reply

Replying to: czarvibe (May 06, 2008 11:55 am)

It ended up bein a vacuum line bein that when you hook up a diagnostic to our old ludes it gives you a broad variety of things to consider for the idle fluxuation. Spent alot of money doin the is it this item nope on to the next one knock sensor yea 250 bucks
#53 of 60
Re: 2.3 auto prelude [rogue4life] by thatguy3
Jun 18, 2009 (3:12 pm)
Reply

Replying to: rogue4life (Jun 18, 2009 7:01 am)

thanks for the info, mine runs about the way you stated. another question. how are the automatics when u put a ram air system in them? found one cheap just not sure if i should put it in or not my car is sittin up in the 200 000 ks. is it alright to put one in with so many kms? and what about putting full synthetic oil in when its been regular oil for a long time?
#54 of 60
prelude 2.3 auto by thatguy3
Jun 18, 2009 (3:29 pm)
Reply
how can you raise the horse power in the automatics? oh ya if any one lives in ontario, Canada theres an awesome store in Cobourg ( streetbling.ca ) they have a drifter style body kit and a Hiro style lip kit both around $500.00 the kits are for the 92 -96 ludes. they also have a couple upgrades for under the hood. if interested you should check it out. i think im getting the drifter kit, hopefully by mid summer. theres also ( extremeparts.ca ) in toronto and dont forget about the ( torontojdm.com ) its full of lots of cool stuff. just thought id let people know and if your lookin for a motor or trans. ( japanautoparts.com) is the place to go. all motors and trans have less than 50 000km. shipped in from japan
#55 of 60
timing belt by thatguy3
Aug 20, 2009 (12:53 pm)
Reply
my timing belt broke while i was driving 100 km/hr. there was no bang or noise's. the car went dead and i pulled off the road. my mech. tells me thats the motor is garbage, with out even checking the inside or changing the timing belt. i've asked a lot of peoples opinions on this and they all tell me that the valves will be broke no matter what. any info on this topic would be helpful. do you think my motor is ruined on a scale of 1 to 10 thanks
#56 of 60
Re: timing belt [thatguy3] by shmang
Aug 21, 2009 (10:40 am)
Reply

Replying to: thatguy3 (Aug 20, 2009 12:53 pm)

Most probably, you have several bent valves, and a few rods. Since the engine has 16 valves and if 2-3 are damaged, you are looking at a bill of $1200 - 2000 (if you are lucky and no rod is bent).
 
When the belt broke, were you coasting or driving? What was the RPM at the time - about 3000 - 3200 rpm? Then I would say it probably cost you the same to get a replacement low mileage motor and installed (Make sure to have the belt, tensioner and water pump replaced before installation).
#58 of 60
92 prelude by mlwest99
Sep 26, 2009 (5:58 pm)
Reply
when i put my car in drive after a few minutes the light starts to blink, and sometimes the check engine light comes on. recently fixes a transmission fluid leak but it is full now. any help
#59 of 60
Re: 92 prelude [mlwest99] by shmang
Sep 27, 2009 (8:25 am)
Reply

Replying to: mlwest99 (Sep 26, 2009 5:58 pm)

when i put my car in drive after a few minutes the light starts to blink
After a few minutes of what? which light blink?
 
When the check engine light is on, what code does it have?
#60 of 60
Re: someone please help me! [tg_357] by gear_wrench
Oct 16, 2009 (10:48 am)
Reply

Replying to: tg_357 (Jun 17, 2007 7:46 am)

Same thing happen to me... I ended up replacing the slave cylinder located on the transmission, it's got rubber boot with a line connected to it...

Messages Page 6 of 6
1
2
3
4
5
6
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement