Last post on Nov 10, 2010 at 6:44 PM
You are in the Chrysler/Plymouth Voyager, Dodge Caravan
What is this discussion about?
Dodge Caravan, Chrysler Voyager, Plymouth Voyager, Van
#87 of 89 Front end vibration and driverside tire wear
Jul 12, 2008 (4:18 pm)
I have a 2002 Dodge Grand Caravan that has a slight front end vibration that cannot be found but is tearing through tires. HELP! I have replaced the struts, sway bar bushings and end links, tie rods and most recently the entire rack. The van has 122k on it and has been great up till now and it is just one thing after another with the front end. I recently took the van in as the front left (drivers) tire was wearing out very quickly and I had noticed a slight vibration in the front end. I was told the rack was bad causing the vibration and the tire wear problem. After spending $1300.00 on repairs and two front tires the vibration is still there and I am now wearing out the new left tire. Dodge cannot find the problem and says everything looks and appears to be in good condition and again has no answer for the vibration and tire wear. The alignment has been re-done 4 different times to no avail/ with solving the problem. The last dodge mechanic said there is a very slight vibration on the front drives side axel possibly causing the problem but again not sure. Of course they want another small fortune to tear into the van with no guarantee it will solve the problem. Please help
#88 of 89 Re: 01 DGC EX Front Suspension Clunking Again [harpitect]
Nov 28, 2008 (1:41 pm)
What kind of life should one expect from the sway bar and control arm bushings? 25K, 50K, 100K, for standard suburban roads and driving? My 05 GC has less then 40K and I replaced the sway bar links and bushings 2 years ago and now the control arm bushings are worn. Seems to me that someone needs to redesign a suspension, since I had a 92 GC that ran flawlessly to 150K before I had to do maintenance beyond oil changes and replacing mufflers, tires, and shocks. This 05 GC is not the 92!
#89 of 89 Shaking Grand Voyager
Nov 10, 2010 (6:44 pm)
I Have a 1998 Plymouth G.V. and it has developed a shake in the rear at about 60-70 MPH below that it is fine.We have replaced tires rims brake drums shocks and drums.We have even gone so far as removeing the rear brakes and drums and it is still the same.Disconnecting the rear shocks causes the symtoms to occur at a lower speed indicating to me the problem is definately in the rear.The last thing we did was replace rear wheel bearings, same thing. It will keep vibrating at 60mph with the trans in neutral and the engine idleing,I am at the end of my rope.Is it possible panhard bar bolts and bushings could be causeing this?