75 messages,
Last post on Feb 02, 2012 at 10:15 AM
You are in the
Mazda MPV Forum.
What is this discussion about?
Mazda MPV, Auto Repair, Van
#72 of 75 Re: MPV Would Crank But Not Fully Start - IAC Valve [stuartstu2b]
by jipster
Jul 21, 2011 (7:42 pm)
Sits right on top, silver, held in by 2 bolts. Easiest do it yourself there is on the MPV.
#73 of 75 IAC valve
by buzzk
Jul 21, 2011 (8:09 pm)
I just bought one tonight [been following this on another blog] tho years ago I readjusted the throttle stop to largely obviate the problem. AutoZone had it for $46.99 + tax. The sleepy-sounding guy at Oreilly said they don't carry the part. Buy it & look at it's appearance & you'll see the original near the top of the engine, held on by 2 small bolts & plugged into a fairly simple electrical connector. Remember it's bolted into aluminum so be careful unbolting & rebolting. make sure you use a good quality METRIC socket the correct size; not an almost-right SAE size, NOR an open-end wrench & DON'T over-tighten.. Should be pretty easy. Good Luck, BK
#74 of 75 Engine Revs up at Start-up
by ngnbldr
Jan 30, 2012 (11:57 am)
One in about every 5 times when I start the engine on my 2003 MPV the engine revs up real high. I am not pushing down on the accelator pedal at all. I also never push on it prior to starting the engine. I am thinking it might be the position switch but dont know why this happens intermittenly. Any help would be greatly appreciated.
Thanks,
Nick
#75 of 75 Re: Engine Revs up at Start-up [ngnbldr]
by jipster
Feb 02, 2012 (10:15 am)
Just a guess, but your idle air control valve could be sticking. They can get carbon build up on the inside. Easy repair, sits right on top with 2 screws holding it in. You could either clean it or replace it ($60)
If you've never replaced, may be worth giving it a try. It has been a bit of sore spot with MPV owners. I replaced mine a couple years ago.