You are here:
Forums
Sedans
Jaguar XJ-Series
Jaguar XJ-Series Electrical Glitches

69 messages, Last post on Aug 24, 2009 at 8:17 AM
You are in the Jaguar XJ-Series Forum. Your Hosts are pat & karens
|
|
|---|---|
|
Replying to: goodkitty (Aug 06, 2009 7:51 am) I am not sure I ended up replacing the whole wiring harness on the drivers side. This solved a lot of problems, very expensive but now it all works. not sure if that helps or not. If you want a harness try car-part.com they are a salvage yard type thing and you can put in what you are looking for. With the jags one bad wire and the whole car is NFG, Good luck Brian |
|
|
I have a 1996 XJ6, 4.0 116k miles. I tried starting it and heard a click but nothing happened at the switch. Checked the battery and found it to be low at 9.3V so I added another battery but every thing acted like it was in a low voltage mode at the panel. Installed a new battery but still no response. Guages etc. now bright but no dome, trunk or head lights. I do have little lights on at the bottom of the head lights. I then shorted the starter and car started but I couldn't take it out of park. I removed the lock pin and put in nuetral to see if it would start but nothing. Checked every fuse this car has which are everywhere and they were all good. I do hear some relays clicking in the battery compartment when someone turns the switch. A real nightmare to say the least. I don't think it's the shifter module perhaps it's the computer I don't know. I bought the Jaguar parts and service manual off Ebay but it dosen't offer good trouble shooting help or identify and follow the serries of relays and modules as to what they do or how to test them. CAN ANYONE OFFER SOME HELP? Thanks, Goodkitty |
|
|
|
|
Replying to: Mr_Shiftright (Nov 05, 2006 1:28 pm)
|
|
|
|
|
Replying to: jaguar13126 (Aug 09, 2009 6:13 pm) Have you check the brake light switch itself for loose wires, etc? I'm not sure if yours is brake pedal activated or master cylinder activated (mechanical switch or hydraulic pressure switch).
|
|
|
|
|
Replying to: Mr_Shiftright (Aug 09, 2009 8:15 pm)
|
|
|
|
|
Replying to: jaguar13126 (Aug 10, 2009 6:42 pm) |
|
|
|
|
Replying to: goodkitty (Aug 06, 2009 7:51 am) - Scott |
|
|
My car too low light came on and after a while my suspension failure light came on just trying to find if someone had this issue before and what to do? The dealer said it might be the compressor 2005 JXL |
|
|
|
|
I have an issue with the turn signal. The turn signal does not work when the brake is applied. I have replaced the rear lamp module with used part and the same thing still happens. I still get the lamp out warning in the driver information center. are there any fixes for this with updated modules? Any suggestions? |
|
|
|
| I've only had the car for a few months, the oil pressure gage has never worked. It goes from 0 to MAX as it pleases. I suspect the sending unit is flakey. Does anyone know the specs on the sending unit, the resistance range it uses? These sending units are almost impossible to get and very expensive. I would like to try to adapt one from another car. If I can find one that works, I would be happy to share the info. | |
You are here:
Forums
Sedans
Jaguar XJ-Series
Jaguar XJ-Series Electrical Glitches
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2008 Jaguar XJ-Series
2000 Jaguar XJR



Browse by Board
Browse by Topic
Today's Chats