- #46 of 69
-
Re: 2007 Yukon Battery and Electrical Problems [tampapi]
by rsht
-
Jun 19, 2008 (10:14 am)
-
|
|
Replying to: tampapi (Jun 19, 2008 4:45 am)
"The CD/Nav disk motor constantly runs" is not right. Mine shuts totally off as soon as I open my driver side door (with the ignition key already turned off of course). Perhaps ask your service department to double check the CD's wiring? I have an 07 Denali, I must say that I have been very lucky, it can sit in my garage for 3 weeks (the longest I have ever tried - due to an over sea business trip) and still starts just fine when I got back.
BTW, has your Yukon been through the recall service called "BCM Reprogramming for Battery Drain"? When I had mine done just more than a year ago, my service department also reprogrammed the the RCDLR and RKE Modules...
|
- #47 of 69
-
Re: Keyless Entry has quit working..... [bigchuckwagon]
by cch2
-
Jun 20, 2008 (12:05 pm)
-
|
|
Replying to: bigchuckwagon (Feb 07, 2008 6:36 pm)
I am having the same problem with our 2007 yukon. Have you been able to find the problem?
|
- #48 of 69
-
Re: 2007 Yukon Battery and Electrical Problems [rsht]
by tampapi
-
Jun 20, 2008 (1:13 pm)
-
|
|
Replying to: rsht (Jun 19, 2008 10:14 am)
I just called the dealer and asked if they did the BCM - they said yes, it was done during my last oil change earlier this year. However, they did not repro the RCDLR. Since you mentioned it, I did some research and see that this was a big issue on the Vette and Tahoe, but I didn't see a bulletin regarding the Yukon.
I called them back and they said they were not instructed to repro the RCDLR on the Yukons. They didn't understand what it would have to do with the battery run-down issue. But from what I'm reading, it's more of a software issue. Do you think I should make them do this?
I was under the impression we have run-down protection anyway, so if something such as the disk motor is running, why isn't the run-down protection kicking in?
|
- #49 of 69
-
Re: 2007 Yukon Battery and Electrical Problems [tampapi]
by rsht
-
Jun 24, 2008 (7:49 am)
-
|
|
Replying to: tampapi (Jun 20, 2008 1:13 pm)
When I visited my dealership for the BCM re-program, they told me that since I was there and there is a newer version of the software available they might just as well re-program the RCDLR all in one visit. I am not all that sure what each re-programming does and to what extend the sensitivity level in the new software is (if at all different/adjusted from the previous version) as far as detecting the electrical drain and etc... All I can tell you, since the re-programming, I have not experienced any issue with the battery running out of juice, even I have parked my 07 Denali for 3 consecutive weeks.
|
- #50 of 69
-
Re: 2007 Yukon Battery and Electrical Problems [rsht]
by tampapi
-
Jun 24, 2008 (8:12 am)
-
|
|
Replying to: rsht (Jun 24, 2008 7:49 am)
What does your battery meter in the dash read normally? Before they did the re-program, were you experiencing flucuations in your meter? From what I understand the normal reading should be around 15 volts. Mine has been resting at around 11/12 but will flucuate down toward 9 volts. When I'm stopped, it will go lower, when I'm moving - especially on the interstate, it will go back up to 15. So there is obviously an issue with the output from the alt. Did you experience any of this?
|
- #51 of 69
-
Re: 2007 Yukon Battery and Electrical Problems [rsht]
by tampapi
-
Jun 24, 2008 (8:16 am)
-
|
|
Replying to: rsht (Jun 24, 2008 7:49 am)
I just found another message on the board regarding the CD reading noise I've been hearing - I think this pretty much explains that issue, so I don't think that has anything to do with my battery running down.
#10 of 50 What's the noise I hear when I open the door? by 10mikeymike Jul 25, 2007 (3:46 pm) Save | Reply
I just took delivery of a new 07 Yukon Denali. It has the navigation system and every time I open the door, I hear a faint sound like an autofocus camera focusing. The only thing I can think it is would be the navigation system rreading the disc, but the vehicle isn't running. Has anyone else noticed this?
Replies to this message:
valvestud (Jul 25, 2007 7:25 pm)
mikestgerm (Dec 08, 2007 2:59 pm)
gaserup (Feb 22, 2008 9:06 pm)
#11 of 50 Re: What's the noise I hear when I open the door? [10mikeymike] by valvestud Jul 25, 2007 (6:25 pm) Save | Reply
Replying to: 10mikeymike (Jul 25, 2007 4:46 pm)
Anytime you open a door on the vehicle when it's been sitting for some time, the NAV unit spins up and gets ready to do it's thing. It will also run for a while after shutdown.
|
- #52 of 69
-
Re: 2007 Yukon Battery and Electrical Problems [tampapi]
by rsht
-
Jun 24, 2008 (10:19 am)
-
|
|
Replying to: tampapi (Jun 24, 2008 8:12 am)
Before the re-program, my battery/voltage meter has been pretty steady at 15 almost every time when I looked at it. Since the re-program, there has been more movement between 15volts and ~12volts if I have been driving for a while... Nothing lower than 12 has ever been observed in my case.
|
- #53 of 69
-
2001 Yukon XL Noise
by jaccicarpio
-
Jun 24, 2008 (10:31 am)
-
|
|
Recently my yukon will make a noise that sounds like a chirping or a plastic bag caught in a fan. It only makes it when the A/C is on and it is very hot outside. It only makes the noise while driving/accelerating. If I let off the gas the noise stops. Also, once the car has been drving a bit it doesn't make it. Any thoughts?
|
- #54 of 69
-
Re: 2007 Yukon Battery and Electrical Problems [rsht]
by tampapi
-
Jun 24, 2008 (5:06 pm)
-
|
|
Replying to: rsht (Jun 24, 2008 10:19 am)
From what I understand, there should be no flucuation of that meter. If anything is operating property, it should read a steady 15volts. But I guess if you are running a DVD player, GPS and all the toys, it might make a difference.
|
- #55 of 69
-
Silencing 2008 Denali NAV audible beep
by chriswynn
-
Jun 29, 2008 (10:06 am)
-
|
|
How do you turn off the audible beep when using the touch screen on the NAV/Radio in the 2008.
|