You are here:
Forums
SUVs
Isuzu Trooper
Isuzu Trooper Alarm Systems

13 messages, Last post on Nov 01, 2009 at 1:51 PM
You are in the Isuzu Trooper Forum. Your Hosts are steve_ & tidester
|
I just purchase a 01 trooper with 82k miles. It had an omega al 100h alarm added to it. It would go off periodically. I'd have to use the valet mode to prevent this. I first unplugged the impact sensor . Next day at work the alarm just went off. I unplugged the omega control box. I thought I had a bad sensor. Early the next morning the horn on the trooper went off . Neighbors are getting upset. The battery is good and hot. I've checked all the doors with the dome light. The all work. I checked the hood latch and the back doors. I would appreciate any suggestions thank in advance GR |
|
|
|
|
The alarm on our 2000 Trooper is also going off in the middle of the night or early in the morning. We just want to disconnect the alarm, but we don't know how to do this. How do you disconnect the alarm? Thanks boe
|
|
|
|
i have a 1994 isuzu trooper...the alarm started going off when i closed the rear door...i have been unable to reset the alarm and it appears to have disabled the ignition...can you please tell me how to reset the alarm or how to disable it so the vehicle will start?thank you...
|
|
|
Replying to: soonerpops (Feb 17, 2008 6:52 pm) |
|
|
I just purchased this vehicle and it did not come with a remote so, I went out on ebay and bought a remote for this car. I have tried to program the remote many times and even went back and asked for a replacement for the remote and got the secone one and tried to program it and nothing. 1. What is the proper way to program the remote? 2. Where is this unit so if I want to replace it I can? 3. Are there any tests that I can perform to know if the unit working correctly? Thanks for any and all help. Popz |
|
|
Hi When I push the Torque on Demand button on the dash of my 2000 Trouper instead of the display going to Auto and everything turning green, I get a red error where it usually would show Auto. Does anyone have any thoughts as to what is no working correctly? and hopefully it won't cost a fortune to repair the problem. Thanks for any of your help. Popz |
|
| Help! I have a 2000 Trooper and for some reason, while driving, the alarm goes off, lights flashing, horn blowing. I have to put the transmission in park, turn the key off, then re-start the engine. But after a mile or so the alarm goes off again! Sometimes the alarm goes off when just parked in the driveway without the key. For my nieghbors' peace I've pulled the fuse to disable the horn but the lights still flash, confusing other drivers (not to mentioin I look like an idiot)! DOes anyone have a solution? Is there a way to disable the alarm? I tried pulling the fuse for it but that doesn't seem to work! Any and all ideas will be of great help! Thanks! | |
|
|
|
Replying to: boeasterly (Aug 17, 2007 6:21 am)
|
|
|
Replying to: pseuperfly (Nov 01, 2009 11:12 am) Never have found what is causing this and also not being able to program my remote or when I want to put it in "Auto 4 wheel drive" I get an error and it just stays in rear wheel drive. |
|
|
Replying to: pseuperfly (Nov 01, 2009 11:12 am) |
|
You are here:
Forums
SUVs
Isuzu Trooper
Isuzu Trooper Alarm Systems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2002 Isuzu Trooper



Browse by Board
Browse by Topic
Today's Chats