You are here:
Forums
Vans & Minivans
Ford Windstar
Ford Windstar Warning Lights/Codes

73 messages, Last post on Nov 24, 2009 at 5:35 PM
You are in the Ford Windstar Forum. Your Host is Karens
|
Replying to: seloo (Feb 19, 2007 3:59 pm) |
|
|
Codes P1537 & P1538 came up on my 1998 3.8 Windstar. Advance told me the codes mean that one or both of the Input Manifold Runner Controls might be stuck. Sure enough, one was bad. I replaced both and verified that they both work. But the P1537/P1538 codes have popped up again. Also, the engine idles rough after having run hard for a while. Any help would be greatly appreciated. |
|
|
The warning light that indicates that an exterior bulb has burned out is on but all the lights appear to be working fine. Anyone any ideas on what else we could check? Thanks.
|
|
I have a 2001 windstar LX. I have been having problems with my (HAND BRAKE) and (ABS) lights coming on in my dash at the same time always. These warning lights come just 15 or so seconds after I start it up and sometimes more than that (5 minutes) . The hand brake works fine actually when those two lights are off yet and I use the manual brake "HAND BRAKE" light comes on; and the brake work fine too, What could be the issue?
|
|
|
if anyone has the ohms value for the egr pressure sensor please let me know asap its a 02 windstar |
|
|
|
|
Replying to: fausto_g (Apr 23, 2007 9:18 pm)
|
|
|
Replying to: jtalley337 (Apr 24, 2007 5:56 pm) Good Luck |
|
|
Yesterday I check brake fluid level and it is ok (this is one of the root causes according several comments.....) and today in the morning I drove to my job (around 12 miles) and both lights never came on , this has never happened lights ussually come on after 1.5 miles aprox, is there some connector at the brake fluid tank that I could have touch and it was missconnected before? Before today I thought this issue may has to do with some part of brakes getting hot, these warning lights come on just 15 seconds or so after I start it up -- if the car was used recently -- ; or after 7 or 8 minutes after I start it up by first time in the morning when car is completely cold. |
|
| The engine oil on my Windstar 2000 is changed but the warning light remains on. How can I reset that warning? | |
|
You must reset this using the computer on the dash. The details are covered in your owner's manual. It is not difficult. |
|
You are here:
Forums
Vans & Minivans
Ford Windstar
Ford Windstar Warning Lights/Codes
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2003 Ford Windstar
2003 Ford Windstar Cargo



Browse by Board
Browse by Topic
Today's Chats