You are here: Forums Vans & Minivans Ford Windstar Ford Windstar Transmission

Ford Windstar Transmission

128 messages,  Last post on Dec 01, 2009 at 9:07 AM

You are in the Ford Windstar Forum. Your Host is Karens

What is this discussion about? Ford Windstar, Ford Windstar Cargo, Van

Messages Page 11 of 14 1 ... 8 9 10 11 12 13 14 Prev Next Last

Go To Msg # Search This Discussion

#93 of 128 1995 windstar tranny problems by bertclark Mar 15, 2009 (6:15 pm)
my 95 windstar is doing the same thing. however, i changed the fluid and filter and it still will not shift out of 1 st gear only if i manually shift out of 1 into 2, but then it will not go into high gear. what can be wrong? Replies to this message: jeff371 (Mar 18, 2009 6:13 pm) boss302j (Mar 18, 2009 6:56 pm) conquest (Mar 19, 2009 4:20 am)
#94 of 128 Re: 1995 windstar tranny problems [bertclark] by jeff371 Mar 18, 2009 (6:13 pm)
Replying to: bertclark (Mar 15, 2009 6:15 pm) I have 1998 windstar that starts and runs perfect. It will not pull in any gears it just quit pulling going down the road with no signs at all....Dropped the tranny pan and it was clean with no shavings or anything. Is there a sensor that would cause this? Replies to this message: boss302j (Mar 18, 2009 6:56 pm)
#95 of 128 Re: 1995 windstar tranny problems [jeff371] by boss302j Mar 18, 2009 (6:56 pm)
Replying to: jeff371 (Mar 18, 2009 6:13 pm) It sounds like you might have the same problem I had, the torque converter stripped out. You could pull the trans cooler lines off of the tranny and start it up and see if it shoots fluid out or take off the side tranny pan and take the valve body/pump off. there is a shaft that runs from the converter to the pump, If you can turn it with little effort the converter is probably stripped out. supposed to be a common problem. If that is the case all you need is a converter.
#96 of 128 Re: 1995 windstar tranny problems [bertclark] by conquest Mar 19, 2009 (4:20 am)
Replying to: bertclark (Mar 15, 2009 6:15 pm) had to replace mine,pump was gone and a bearing, 2200.00 later
#97 of 128 windstar trans. by louisg47 Apr 18, 2009 (3:45 am)
I replaced a trans in a 99 w/3.8 with a running unit from a wreck-I found out later that there are two different trans. for that year-the one i took out was working,but slipping --the new one will not go forward unless the overdrive plug is disconnected-its probably the other trans-is there anything i can do with the wiring or plug etc. to make this trans work==thanks
#98 of 128 another transmission question by maroonedsailor May 16, 2009 (6:49 pm)
This one is a bit weird. This is a 2000 Windstar with an xaod metric. Same transmission my 98 has (17 bolt pan) but with the 3.8 instead of the 3.0 liter engine. Starts and runs like normal for about 1/2 mile, gets hot, starts flashing the od light and slipping. Stop and it pukes brown fluid all over the ground which does not smell burned. The fluid in the trans itself is still bright red. Let it cool down, add fluid and repeat every 1/2 mile (more going down hill . This is acting like one of the cooling lines is pinched but I can't see anything wrong. Fluid seems to be coming from top of the transaxle. Anyone got an idea? This is the "s" trans not the "n" one with 19 bolt pan. It will probably need to be rebuilt regardless after overheating but I'd still like to understand the cause.
#99 of 128 Windstar transmission match up by kringering May 29, 2009 (4:10 pm)
I have a 99 windstar with a 3.8 engine with a bad trans I have a friend with a 97 with a 3.0 will the transmission match up
#100 of 128 Windstar transmission match up by kringering May 29, 2009 (4:10 pm)
I have a 99 windstar with a 3.8 engine with a bad trans I have a friend with a 97 with a 3.0 will the transmission match up
#101 of 128 remving transmission by trounda Jun 15, 2009 (2:52 pm)
just wondering do i have to remove the cowl to take the tranny out it looks like ihave to remove the sub frame thanks Replies to this message: boss302j (Jun 21, 2009 8:22 am)
#102 of 128 Re: remving transmission [trounda] by boss302j Jun 21, 2009 (8:22 am)
Replying to: trounda (Jun 15, 2009 2:52 pm) Yes you do have to remove the subframe. I believe I did remove the cowl . Not sure if it is a must though.

Messages Page 11 of 14 1 ... 8 9 10 11 12 13 14 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Vans & Minivans Ford Windstar Ford Windstar Transmission