Sign In Join 



Jeep Cherokee Start Stall Idle Problems

180 messages,  Last post on Nov 18, 2009 at 5:07 PM

You are in the Jeep Cherokee and Jeep Grand Cherokee Forum. Your Hosts are steve_ & tidester

What is this discussion about? Jeep Cherokee, Transmission, SUV


Messages Page 18 of 19
1
...
13
14
15
16
17
18
19
Prev
Next
Last
Go To Msg #
Search This Discussion

#167 of 180
Re: i can't get a reading [hatingthisjeep] by lunghd
Aug 11, 2009 (8:17 pm)
Reply

Replying to: hatingthisjeep (Aug 11, 2009 10:18 am)

Crankshaft position sensor is likely culprit (CKS).
Could be camshaft position sensor (CPS) but less likely.
Reasonably easy to test - pain in the butt to replace but doable with a collection of extensions & the right socket.
 
Your HO engine has a different sensor than my RENIX XJ but test procedure is basically the same - check my onsite & off site tech indexes plus the downloads area. Disconnect the CKS harness connector - near firewall, rear of head, driver side area.
Use a digital volt meter set to low voltage AC - you are basically checking for a low AC voltage pulse generated as the engine is cranked with the starter. This pulse signals the computer where the engine TDC is at so the computer can control engine ignition. fuel etc.
You can also measure resistance but that's less reliable of an indicator as these things often fail when hot, only on Tuesdays or when your mechanic is on vacation... in other words: The CKS can be intermittant.
 
Check out the links on my site http://www.lunghd.com and if you still have questions post back or contact me via my web form and I'll try to help ya out.
#168 of 180
1992 Jeep Cherokee 4.0l 5spd no high idle by jod1289
Aug 19, 2009 (1:27 pm)
Reply
Well when I go to start my Jeep it turns over kinda rough then it starts but begins to idle rough till the check engine light comes on. Any suggestions??
#169 of 180
loading problem by ledend
Sep 13, 2009 (8:31 pm)
Reply
how much time need to start up engine at morning,cherokee 95 SE a/t after key ON position? my cherokee need 5-10 minute. what's problem wth my cherokee? and no problem if the car engine is hot/after drive to going somewhere....just first start at morning.....
#170 of 180
Re: loading problem [ledend] by tidester HOST
Sep 13, 2009 (10:05 pm)
Reply

Replying to: ledend (Sep 13, 2009 8:31 pm)

Can you describe exactly what happens when you first turn the key in the morning? Do you hear any sounds? Do lights flash?
 
tidester, host
SUVs and Smart Shopper
#171 of 180
Re: loading problem [tidester] by ledend
Sep 14, 2009 (4:56 pm)
Reply

Replying to: tidester (Sep 13, 2009 10:05 pm)

just "klik"..... i think is relay or something like that at under steering, and on panel just parking lights ON...after 5-10 minutes ABS and CHEK ENGINE lights ON then fuel pump
#172 of 180
Re: loading problem [ledend] by tidester HOST
Sep 14, 2009 (9:05 pm)
Reply

Replying to: ledend (Sep 14, 2009 4:56 pm)

Check your battery, starter solenoid, cables and the starter itself.
 
Anyone with hands on experience, please feel free to jump right in here!
 
tidester, host
SUVs and Smart Shopper
#173 of 180
Re: loading problem [tidester] by ledend
Sep 20, 2009 (5:28 pm)
Reply

Replying to: tidester (Sep 14, 2009 9:05 pm)

i'm use dry cell battery(50amp) maybe the cranksaft sensor problem? cause the loading time betwen key ON to fuel pump ON is 5-7minute....
#174 of 180
Re: loading problem [ledend] by tidester HOST
Sep 20, 2009 (5:35 pm)
Reply

Replying to: ledend (Sep 20, 2009 5:28 pm)

Can any Cherokee owners offer ledend some suggestions? I'm stumped!
 
tidester, host
SUVs and Smart Shopper
#175 of 180
Re: 1996 jeep cherokee sport 4.0 [hatingthisjeep] by robp1115
Nov 03, 2009 (9:36 am)
Reply

Replying to: hatingthisjeep (Aug 10, 2009 12:20 pm)

try replacing the crank position sensor 1st if not then try the cam position sensor
#176 of 180
03 GCL Starting problem by robp1115
Nov 03, 2009 (9:44 am)
Reply
Last night I drove to the hospital and back with no prob. Parked the car and the next morning tried to start and it didn't want to. Turned key, engine turned over and didn't start. Tried again while giving gas and started up but all interior light dimmed and as soon as i let the gas pedal go car completely shut off. Any suggestions?

Messages Page 18 of 19
1
...
13
14
15
16
17
18
19
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement