You are here: Forums Sedans Dodge/Plymouth Neon Dodge-Plymouth Neon Starting/Stalling

Dodge-Plymouth Neon Starting/Stalling

92 messages,  Last post on Oct 10, 2009 at 7:30 AM

You are in the Dodge/Plymouth Neon Forum. Your Hosts are pat & karens

What is this discussion about? Dodge Neon, Plymouth Neon, Dodge Neon SRT-4, Engine, Sedan

Messages Page 6 of 10 1 ... 3 4 5 6 7 8 9 10 Prev Next Last

Go To Msg # Search This Discussion

#46 of 92 Shalling by chevygirl99 Mar 04, 2008 (1:07 pm)
I have a 96 neon, sometimes when i am driving it will just turn off. The oil light is the only light that comes on. It ususally happens when im slowing down or when i am idoling. I thought maybe it had to do with the amount of fuel going into the engine, so i had my fuel filter cleaned and my fuel pump checked and everything checked out fine. I was just wondering if anyone else has had this problem or knows what i can do to fix it...
#47 of 92 96 neon stalling and occassionally not starting by rileyfinn112 Mar 23, 2008 (1:06 pm)
My 96 neon recently started to stall out while idoling, and then would have issues restarting. I noticed the 'charging system light' would come on right before the stall, and a few times, by revving the engine, or just giving it gas to go, it would stop sputtering, and the light would go off. Any advice or experience in this problem? Replies to this message: BIGDADDYHORTON (Dec 05, 2008 11:04 pm)
#48 of 92 update to #40 starting problem by andrle97 Mar 23, 2008 (5:29 pm)
i have not found the problem yet but now that the weather is getting better i can pull the car out and dig into it if i find any thing i will post it here.....
#49 of 92 neon stalling by ronc59 Mar 25, 2008 (5:58 pm)
Hello everyone, I'm new to this forum. I have the same problem with a 97 2.0 DOHC. It will run gr8 for 2 or 3 days then boom. I've been working on this car for 2 months now. When it stalls, if you don't turn the key off but try to start it, you get no rpm,cam or crank sensor readings on a Snap-on scan tool, no spark and no injector signal. but if you turn the key off (for 5 min.) it will start and run gr8, till it stalls again that is. I've changed the cam and crank sensors, egr valve, pcm (reprogramed it) asd relay, battery terminals, pulled and cleaned all fuses inside and out,and cleaned the throttle bore. I've checked the tps, map, repaired the crankshaft sensor wiring under the exhaust, and cleaned the contacts at the pcm. I'm running out of ideas. If anyone has run into this problem I'd like to hear about it. Fuel psi and ignition are fine. There are no TSBs on Mitchell's on demand about this problem.I'm hoping it's something stupid that I'm overlooking. If you didn't figure it out yet, I do run a small independent repair garage and yes this one has me stumped. sorry this was so long. Replies to this message: june_clemons (Mar 26, 2008 4:18 am) ronc59 (Apr 03, 2008 6:43 pm)
#50 of 92 Re: neon stalling [ronc59] by june_clemons Mar 26, 2008 (4:18 am)
Replying to: ronc59 (Mar 25, 2008 5:58 pm) Hi my name is June I have had a number of problems with the same my 97 dodge neon. I have put it in the shop a number of times only to find out that the brain might be whats wrong. I do have an extra brain there hard to find if you go to a parts store you will pay almost 300 dollars for one. If your interested please contact me june_clemons200412yahoo.com. I also have contact with a person that specializes in dodge neons. I spent well over hundres of dollars trying to figure out what was wrong with mine I can give you some input.
#51 of 92 Here is what was wrong with mine by june_clemons Mar 26, 2008 (5:17 am)
I have a 97 dodge neon single over head cam 5 speed. I had the same problem you are haveing. I replaced every censor just like you have except the wireing. Im not a eletrician when it comes to cars and several machanics said to me its the wireing. I even put it on a machine to find this out. After spending hours of my time and talking with dodge dealers and putting it in the shop I found a person that Napa gave me right here in my own town. He specializes in hard to figure out cars. Well as I was saying I changed everything. Even dodge was stuped and couldnt figure this out. You need to check your cam pin mine was broke and replaced it for 3 dollars lol yes the pin . Now my car is running perfect. But like I said I do have 2 brains one for a automatic and one for a 5 speed and they are hard to find. Replies to this message: ronc59 (Mar 26, 2008 1:13 pm)
#52 of 92 Re: Here is what was wrong with mine [june_clemons] by ronc59 Mar 26, 2008 (1:13 pm)
Replying to: june_clemons (Mar 26, 2008 5:17 am) THIS PIN I KEEP READING ABOUT, IS IT THE ONE IN THE TIMING BELT SPROCKET? I DON'T KNOW IF CAM TIMING WOULD CAUSE MY PROBLEM OR NOT CAUSE OF THE WAY YOU HAVE TO TURN THE KEY OFF FOR AWHILE BEFORE IT WILL RESTART, BUT AT THIS POINT I'M WILLING TO TRY ANYTHING. ALSO I DID PUT A NEW BRAIN IN IT ALREADY.
#53 of 92 Stalling by bessiesmom Mar 26, 2008 (1:18 pm)
I have a 97 Neon that is misfiring and then stalling out. She particularly doesn't like left hand turns. If the gas tank is full she runs better but as soon as it gets to 3/4 of a tank it just gets worse and worse. I recently had to have a seal replaced because tranny fluid was leaking out. I think it was the cam shaft seal. I read on this site that cam shaft pin being broken can cause similar problems. Any thoughts...please help. I have already spent over $500.00 trying to fix this problem. At this point I think I am just being taken advantage of. Replies to this message: menick (Jun 13, 2008 10:04 pm) dawn1012 (Aug 23, 2008 12:23 am)
#54 of 92 Re: neon stalling [ronc59] by ronc59 Apr 03, 2008 (6:43 pm)
Replying to: ronc59 (Mar 25, 2008 5:58 pm) Thought someone might like to know what I found with my 97 2.0 DOHC, To recap, it would just shut down at any given time and wouldn't restart till you shut the key off then re started. The problem turned out to be the entire wiring harness. it looked fine on the outside but once opened I found all the wires were kinda melted together. had to strip the harness and separate and reinsulate all the wires. the main ones were the cam and crank sensor wires. My local dealer told me that is common, although I messed with this problem for 2 months and couldn't get any answers from anyone. So if you loose your crank signal, look at your wiring, all of it.
#55 of 92 losing power by jdoucette Apr 22, 2008 (2:44 pm)
Hi . My granddaughter has a 1998 plymouth neon that every now and then loses power. Everything keeps running but the car will not move. Can anyone help with this as it is getting expensive. Thank you My email is joedoucetteeastlink.ca

Messages Page 6 of 10 1 ... 3 4 5 6 7 8 9 10 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Sedans Dodge/Plymouth Neon Dodge-Plymouth Neon Starting/Stalling