Last post on Aug 21, 2013 at 9:57 AM
You are in the Chrysler Town & Country/Dodge Grand Caravan
What is this discussion about?
Chrysler Town and Country, Van
#61 of 70 Re: 2006 T&C Touring [packerfan65]
Jun 01, 2011 (4:54 am)
Should I be concerned?
If the van is running fine, I would not be concerned.
Also, can I still get the codes to come up if the check engine light isn't presently coming on
Any OBD-II reader/scan diagnostic tool should be able to pull any stored codes, even if the CEL is not currently on.
#62 of 70 Re: 2006 T&C Touring [srs_49]
Jun 01, 2011 (5:30 am)
Good news! Thanks for responding so fast.
#63 of 70 Re: 2006 T&C Touring [packerfan65]
Jul 18, 2011 (8:04 am)
turn the key 2 or 3 times and look at the odometer it wiull give your the codes, you will get p1684 and maybe 2 or 3 others which are for the evap system, I have had it fo 2 years on my car with no problems. there is a leak in a hose somewhere and the only way to find is with a smoke tester. also check under your hood at the front left (by grill)by the fan belt there are 2 hoses going into a small container i forget the name, ill find out for you. see if that is detached or those hoses have a hole in it. could also be your gas cap.
#64 of 70 2001 T&C w/ 2.8l v6 multiple engine codes
Sep 16, 2011 (3:45 pm)
my 2001 Chrysler T&C has engine codes PO601,PO122.PO123.PO118,PO106,PO206,P1478,P1496 it was running fine all day and suddenly started bucking and surging missfiring and has a burning smell outside the van are most of these codes because of the engine control module also can smell raw fuel coming from tailpipe HELP
#65 of 70 2002 chrysler town and country
Apr 07, 2012 (9:20 am)
I have pulled the trannny to put a new torque converter seal in. I put it all back together and it wont start. It was running fine before, just leaking fluid. The only code to come up is p1684. I bought a code reader and it says no codes but the odometer reads p1684. can anyone give me any advise as to how to fix.
#66 of 70 Service Engine Soon light with no code
Jun 20, 2012 (11:30 am)
1999 T & C. Service Engine Soon light on. OBD II reader says no codes. Light won't turn off. Ideas??
#67 of 70 Re: 2002 chrysler town and country [wcgreer]
by KCRam@Edmunds HOST
Jun 20, 2012 (5:08 pm)
P1684 just means the battery has been disconnected within the last 50 starts. Not an error, just documenting the event. You likely disconnected the battery when you pulled the trans.
kcram - Pickups/Wagons/Vans+Minivans Host
#69 of 70 Re: 2002 chrysler town and country [wcgreer]
Mar 29, 2013 (10:55 pm)
Did you put the crank position sensor back? It sits at the top of the tranny bell-housing and you must have at least unplugged it. If you didn't remove it, you might have damaged it in getting the tranny out. You won't get any fuel flow without it because the injectors fire from that signal, similar to how you wouldn't get spark in an old car without the distributor turning. The sensor tip needs to sit very close to the slots on the "toner ring" since a magnetic "Hall-effect" sensor.
When you pulled the tranny, you should have checked the flexplate. Mine was cracked all around the bolt holes and rotated ~20 deg, which you wouldn't see without removing the clamp ring. I understand a common problem. My engine had ~170K miles. Indeed, I would always replace the rear engine seal during this job, so you would have seen that.
#70 of 70 Chrysler T&C 2007 LX
Aug 21, 2013 (9:57 am)
Engine starts up as usual, except all the dash gauges go all the way to the right then return to normal position.
Also, radio/CD does not work. And remote door lock does not work, and the door lock button does not work unless engine is on. All other components work as usual.