Ask the Car People.SM


Chevrolet Cobalt General Care & Maintenance

138 messages,  Last post on Sep 12, 2010 at 4:59 PM

You are in the Chevrolet Cobalt Forum.

What is this discussion about? Chevrolet Cobalt, Oil, Paint, Coupe, Sedan

Messages Page 6 of 15

#47 of 138 Re: How to change your Cobalts oil... [wookie1] by grosloup

Jun 26, 2007 (10:26 am)

Replying to: wookie1 (Jun 26, 2007 5:18 am)
My vehicule is a 2005 Chevrolet Equinox. I figure all G.M. products works the same. This is how the reset is explained in my owners manual.
 
 1. Turn the ignition key to RUN with the engine off.
 2. Fully press and release the accelerator pedal tree
    times to the floor within five seconds.
 The change engine oil light will flash while the system is resetting.
 3. Turn the key to lock position.
 
    If the change engine oil light comes back on and stays on when you start your vehicule, the engine oil life system has not reset. Repeat the procedure.
 
 Keep me in touch, I would like to know if the Cobalt's oil light resetting is the same as the Equinox. Just curious.
Good Luck.

#48 of 138 Transmishion by rlenker

Jul 07, 2007 (10:29 am)

I have a new 2007 LT. I looked for a Automatic transmission dip stick, as I read there is none. If you have trouble take it toi the dealer. Can I check the fluied leavle in the transmishion?

#49 of 138 Re: Transmishion [rlenker] by grosloup

Jul 07, 2007 (4:18 pm)

Replying to: rlenker (Jul 07, 2007 10:29 am)
Automatics with No Dipsticks
 
According to automobile manufacturer research, a certain percentage of automatic transmission failures are caused by over-filling and/or using the incorrect transmission fluid. It is important to remember to NEVER over-fill the transmission assembly and to ALWAYS use the recommended transmission fluid. To discourage over-filling, some vehicle manufacturers have eliminated the dipstick on the transmission. Unfortunately, this also makes it hard to tell if the fluid level is low.
 
On automatic transmissions that do not have a dipstick to check the fluid level or add fluid, a fill plug is usually located on the left side or right side of the transmission. On some, there may also be a drain plug on the bottom of the transmission.
 
To check the fluid level, the transmission must be warm and the vehicle must be parked on a level surface or raised on a lift. Jacking up the front wheels will tilt the vehicle and give an inaccurate indication of the fluid level. Therefore, all FOUR wheels must be raised off the ground and the vehicle must be properly supported by four jack stands. NEVER crawl under a vehicle unless it is safely supported by jack stands.
 
When the fill plug is removed, some fluid should dribble out of the hole if the fluid is at the proper level (flush with the bottom of the fill plug hole). If no fluid comes out, add fluid to bring it up to the level of the hole.
 
Below are some of the automatic transmissions that do not have a dipstick:
 
5-SPEED 2004-UP ACURA TL, RL, RSX
5L40/5L50E 2004-05 CADILLAC CATERA
AISIN 81-40LE 2004-05 CHEVROLET AVEO
4T40/45E 1997-UP CHEVROLET CAVALIER, COBALT
42RLE 2005-UP CHRYSLER 300 3.5L 2WD
NAG-1 2005-UP CHRYSLER 300 3.5L AWD
AF33 2005-UP CHEVROLET EQUINOX
5R55N/S/W 2005-UP FORD CARS
AISIN RNJ 1998-05 ISUZU NPR DIESEL
ZF-6SHP-26 2005-UP LINCOLN NAVIGATOR 5.4L
5F31J 2004 MAZDA MPV W/5SPD
N4AEL 2004 MAZDA MIATA
AF23 2004-05 SATURN ION
4/5-Speed 2004-05 SATURN VUE

#50 of 138 Re: How to change your Cobalts oil... [ray_h1] by harrisblack

Jul 14, 2007 (12:28 pm)

Replying to: ray_h1 (Oct 21, 2006 8:07 am)
How do you know Champion Labs makes oil filters for AC-Delco? Do they make any other products for them?

#51 of 138 Magnetic drain plug by cmhj2000

Jul 27, 2007 (5:28 pm)

Am getting an 07 LT 1 next week. Does anyone know the thread size of the drain plug? Would like to install a magnetic plug ASAP.
 
tia

#52 of 138 Brake Fluid Level by harrisblack

Aug 23, 2007 (4:52 pm)

What is the proper level for the brake fluid in the master cylinder? How do you know if it is too low? Do you go by the two dots on the master cylinder? This is for the 2.2 engine.

#53 of 138 Re: Brake Fluid Level [harrisblack] by okko1

Aug 23, 2007 (6:58 pm)

Replying to: harrisblack (Aug 23, 2007 4:52 pm)
not a good idea to top off master cylinder. as this is a good visible cue as to the condition of your brake pads. as they become more worn the level of fluid in the master cylinder decreases.if the reservoir is 50% then check the disc pads for wear. also look for signs of fluid loss.

#54 of 138 Re: Brake Fluid Level [okko1] by poncho167

Aug 24, 2007 (2:59 pm)

Replying to: okko1 (Aug 23, 2007 6:58 pm)
I would always top it off when needed and check brake wear on occasion by looking at the brakes. I wouldn't rely on a reservoir.

#55 of 138 Re: Brake Fluid Level [poncho167] by okko1

Aug 24, 2007 (3:53 pm)

Replying to: poncho167 (Aug 24, 2007 2:59 pm)
a properly functioning brake system is not designed to be topped off it is a closed system. thats why there is a min. & max. level line. topping off the master cylinder is good for the brake business. it is one of the best ways to generate rotor work. much rather see that light come on for low fluid than just keep adding.

#56 of 138 fuel filter by harrisblack

Aug 29, 2007 (11:59 am)

How and when do you change the fuel filter? There is no mention of it in the owners manual.

Messages Page 6 of 15

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement