497 messages,
Last post on Mar 11, 2013 at 11:04 AM
You are in the
Dodge Dakota-2010 and older Forum.
What is this discussion about?
Dodge Dakota, Electrical, Truck
#490 of 497 starter problems
by soldout1
Apr 01, 2012 (9:23 pm)
need two trace ground wire for starter on 2001 dodge dakota. I think the ground is keeping it from starting
#491 of 497 Re: window trouble [dakota4x42003]
by pops37
Jun 23, 2012 (10:55 am)
I see this is several months old but thought I would toss in an idea anyway. 1st ck to see if the LED on the other window switch buttons goes on and off when you push the window lockout off & on at the driver door. If not then maybe your window lock out switch is broke. 2nd if the LED lights work then you have power and the lockout switch is working. next is to remove the inside door panel (4 screws) on one of the doors and disconnect the switch connector then test the connection points. let me know if you do not have the pin outs and I'll post it for you.
#492 of 497 2001 Dodge Dakota ignition issues
by bobh1027
Aug 14, 2012 (3:22 pm)
I have a 2001 Dodge Dakota, SLP, 4.7 L, V8. I am having an issue with the drivers side bank not firing. I have checked the coils and PCM and they are fine. I do not have any engine codes other than when I have unplugged a coil or an injector. The engine will start but run rough and unplugging a coil or injector on the drivers bank does not change it. It seems to run better at faster RPM's. Has anyone had issues like this and any answers or suggestions.
#493 of 497 Re: 2001 Dodge Dakota ignition issues [bobh1027]
by pops37
Aug 15, 2012 (7:23 am)
Howdy, just to be sure did you also unplug coil or injector in other side and was it worse? Have you cleaned (real well) the TB(throttle body) and IAC (idle air control). There are 2 capacitors in the circuit but I am not sure where they are located. Inspect all related wiring for cut, loose or questionable ground.
good luck
pops
#494 of 497 Electrial problem
by floyd73
Sep 01, 2012 (2:48 pm)
I have a 2001 dodge dakota,and the dash lights will not dim, I replaced the light switch,removed the pos.batt. cable removed the ecm cleaned all connectors with a tooth brush and crc replaced the ecm and reconnected the batt. cable still unable to dim the dash lights, any ideas?
Floyd
#495 of 497 98 Dakota tail light not working
by 98dakota2wd
Feb 25, 2013 (10:44 am)
#496 of 497 98 Dakota tail light not working
by 98dakota2wd
Feb 25, 2013 (10:44 am)
I have a 98 Dakota that the tail light isn't working. I've tried replacing the bulb and still nothing. When the head lights are on, the right tail light is out. When I brake, it lights up and when I turn on the signal, it blinks fast. I've changed one front turn signal bulb and changed the rear last night and it still does not work. Any help would be great...
#497 of 497 Re: Electrial problem [floyd73]
by tiffney
Mar 11, 2013 (11:04 am)
Sorry for delay in response. New to this forum. We had the same exact issue with our 2001 dakota. Turned out we had to replace the computer. In the drivers side floorboard, there is a kick panel. If you remove the kick panel, your computer is under that. We had trouble finding one for a reasonable price. The cheapest one we could find was at www.mopar-wholesale.com for $263.09. Hope this helps.