You are here:
Forums
Pickups
Dodge Dakota
Dodge Dakota Engine and Underhood Questions

377 messages, Last post on Nov 23, 2009 at 5:17 PM
You are in the Dodge Dakota Forum. Your Host is kcram
|
|
|---|---|
| I have a 1999 Dakota 3.9L and i am experience problems at a higher RPM both in gear and in nuetral. The truck just won't rev above 3,500 RPM's like it cuts out. But runs fine at low RPM's. Any ideas????? | |
I have a 1990 dakota with 5.2L. I want to put a 5.9L in it. The 5.2L is internnaly balanced, and the 5.9L is externnaly balanced . What else has to be changed? Jeg has a flex plate for 5.9L w/904tf, will this bolt to the A500 converter? Or does the converter/flex got to be switched? The engine is also getting a cam upgrade. Where can the computer get upgraded? Or can I leave it?
|
|
|
|
|
my 1999 Dodge Dakota start fine but after running a minute or two will act like its running out of gas, it will backfire, and create a smelly exhaust. This occures for maby 15 seconds then you can drive the truck for hours with no problems unless you shut it off for a few minutes. Does not seen to be as bad when the engine is real cool or after you fill up the gas tank. |
|
I recently replaced the engine with a used one, everything went well in the change and started right up, but the Idle is very high, almost wide open, is this something to do with the computer settings, this was my first engine change and Im not up to date on the newer stuff with computers. Can anyone help me out?
|
|
|
Replying to: kmk894 (Dec 05, 2007 8:43 am) |
|
|
|
| used to be when the truck got hot sitting in traffic (temp gauge past center/normal) fan would sound like it was slipping or "whirring" as soon as i started moving air, it would stop and normal engine sounds and temp would resume. now it does it all the time. i could be wrong but i heard the fan had a "gel" type coupling that would "melt" when the engine temp got hot(ter) is it the fan? I dont know....a little help??? | |
|
|
|
Very nice forum! I recently rebuilt the oil pump in my 98 Dakota 2.5-liter. But, I can't get any oil pressure. Do I need to prime it first? (is there an easy way?). Or, is there another possible cause? I'm pretty sure the oil pressure sensor is ok. Thanks! |
|
|
I have a 1993 Dakota with a V6 and standard shift, I bought a wrecked 1995 with a 318 in it and a auto shift. I used all the wiring from the truck the 318 came out of and the computer also. The install went easy and the truck runs awesome, BUT now the code 12 Mem power loss and all the transmision codes for the automatic comes up because the whipes were left unhooked. Now the truck will run fine but when putting it in the forward gears it will drive for a undetermined length of time or distance and shut right down, the tach drops to 0 and the engine slowly dies down to nothing. Now I took it for a ride last week and it did ok but it of course died and wouldnt stay running when shifted from park to 1st gear etc. , I tried it in revearse and it ran great and I drove it in revearse all the way home about 5 miles and it didnt die out at all untill I pulled in the driveway and went to pull it forward into the parking spot and it died. HELP!!! I want my dakota back for the winter, Thanks ahead of time for any replies |
|
|
|
|
My cruise control doesn't work. I checked the fuse and it's fine. I have a 93 dodge dakota V6. 3.9L I've been searching for seven years on how to fix the problem. Any help would be appreciated. Thanks
|
|
|
Replying to: rolandtignor (Dec 17, 2007 7:33 am) |
|
You are here:
Forums
Pickups
Dodge Dakota
Dodge Dakota Engine and Underhood Questions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2009 Dodge Dakota



Browse by Board
Browse by Topic
Today's Chats