You are here: Forums Pickups Chevrolet Avalanche Chevrolet Avalanche Brake Questions

Chevrolet Avalanche Brake Questions

16 messages,  Last post on Oct 28, 2009 at 5:03 AM

You are in the Chevrolet Avalanche Forum. Your Host is kcram

What is this discussion about? Chevrolet Avalanche, Brakes, Truck

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

#12 of 16 Re: 2002 avalanche reversing problems [bialke24] by bialke24 Jan 06, 2009 (5:22 pm)
Replying to: bialke24 (Jan 06, 2009 4:50 pm) I just changed my brake padsa week before Christmas and they are fine it just when I put thetruck into reverse when I have the problems. Has anyone had problems stating their truck in the morning? Cause when I go to start it it doesnt want to start so I turn the key and wants to turn so I shut it off and turn the key again and it fires right away I havent had this problem since after I changed the brakes.
#13 of 16 2007 Ava 4x4 changing front rotors by gar6 Jun 04, 2009 (4:53 am)
I have been having brake problems on my 2007 avalanche 4x4, In an attempt to change the rotors I could not get the calaper bracket removed. The bolts seemed to be almost welded, I broke a braker bar and socket trying to remove this. Is there something special about the Avalanche and changing the rotors. Please help Replies to this message: erickpl (Jun 10, 2009 7:09 am)
#14 of 16 Re: 2007 Ava 4x4 changing front rotors [gar6] by erickpl Jun 10, 2009 (7:09 am)
Replying to: gar6 (Jun 04, 2009 4:53 am) Avalanche brakes are no different in conceptual design than any other rotor setup. Remove caliper, lift away, remove rotor.   The bolts may be tight or a bit rusted. May have used loc-tite on the original bolts at the factory.   -Paul
#15 of 16 torque wrench size needed for front brake pads by bauchaik Oct 26, 2009 (1:09 pm)
I'm not wanting to go buy a whole set but just want to purchace the required size torque wrench for my 2002 Avalanche front brake pads. Anywone know that size? Thank you. Replies to this message: erickpl (Oct 28, 2009 5:03 am)
#16 of 16 Re: torque wrench size needed for front brake pads [bauchaik] by erickpl Oct 28, 2009 (5:03 am)
Replying to: bauchaik (Oct 26, 2009 1:09 pm) Um, the wrench itself is not a specific size. you use sockets, just like you do for any other socket set. A standard socket set SHOULD have the size you need. I don't think it is an overly large one. I was to say about 17mm - assuming you're talking about the bolts for the calipers vs the caliper mount bracket.   -Paul

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Chevrolet Avalanche Chevrolet Avalanche Brake Questions