You are here: Forums SUVs Jeep Cherokee and Jeep Grand Cherokee Jeep Grand Cherokee Start Stall Idle Problems

Jeep Grand Cherokee Start Stall Idle Problems

589 messages,  Last post on Nov 26, 2009 at 4:03 PM

You are in the Jeep Cherokee and Jeep Grand Cherokee Forum. Your Hosts are steve_ & tidester

What is this discussion about? Jeep Grand Cherokee

Messages Page 54 of 59 1 ... 51 52 53 54 55 56 57 ... 59 Prev Next Last

Go To Msg # Search This Discussion

#530 of 589 Re: 1996 Jeep GC will not run [jeepercreepe] by harpplaya Jun 04, 2009 (12:37 pm)
Replying to: jeepercreepe (Mar 22, 2009 10:36 am) Hey Buddy, Did you ever figure out what the problem was? I have the exact same problem with my 96 GC 4.0 six. 191000 miles. Mine stopped in the middle of a 4 hour trip by the side of the highway though!    To the response from tuggajb, my fuses are straight, would the ignition switch kill the vehicle and the guages while running down the highway?   Thanks for any help all. Replies to this message: murfdog13 (Aug 16, 2009 7:58 am) 96jeep2 (Aug 16, 2009 6:06 pm)
#531 of 589 Re: 01 Grand Cherokee ignition issues [ihornsby] by ihornsby Jun 08, 2009 (4:05 am)
Replying to: ihornsby (Jun 03, 2009 3:39 am) Ok, It ended up being a loose connection on the starter i guess, I took the starter off to be tested and it tested fine, i cleaned all connections and put the starter back on, its working fine.
#532 of 589 Re: cold start stalling problem [dlunge] by eric784254 Jun 16, 2009 (10:43 am)
Replying to: dlunge (Nov 26, 2007 7:20 pm) was looking at my haynes manual & i dont see a mat sensor, i found a map sensor which is located on the side right hand side of the throttle body (facing front of vehicle. do you have the inline 6 cylinder ? what manual do you have ? mine is 93 -04 haynes manual #50025
#533 of 589 Re: 1996 JGC hard-start & stalls while driving [sarwarrior] by eric784254 Jun 16, 2009 (10:59 am)
Replying to: sarwarrior (Nov 08, 2006 4:09 pm) did you check for fuel pressure ? you might have a vacuum leak also. try your plug gap .035 is whats recommended i think. refer to your label in front of the the radiator or call your local parts supplier for info.
#534 of 589 Re: HELP!!! 96 Country won't start [ElTejano] by eric784254 Jun 16, 2009 (11:01 am)
Replying to: ElTejano (Dec 06, 2008 3:13 pm) check your battery temp sensor, i think it located under the battery in the tray
#535 of 589 Re: 94 JGC Starting, Idle and running problems [lewisj] by eric784254 Jun 22, 2009 (1:02 pm)
Replying to: lewisj (Jun 02, 2009 6:36 pm) im having some similar problems with my 98 jgc, rough idle no codes. chased wires, replaced sensors. no codes. called a junk yard, told me 25 if i pull the part. skeptical about electrical parts from a junk yard though, but its my only choice. the pcm is on the firewall on the passenger side right ? could you tell me what it looks like ? my wife wants me to sell it but im not givin up on it yet ! i would like to solve this prob before i loose my mind. she doesnt know it yet, but if i can solve this puzzle, im givin it to her for her b-day. dazed & confused for now. any help would be greatly appreciated. thanks.
#536 of 589 wont start by keystone82 Jul 14, 2009 (4:53 am)
have 94 jgcl drove down highway worked fine came home died hit the gas kept on going then it died again had to pull over and it started up fine got home went out to start next day nothing it turned over u can hear the pump and smell gas but nothing came out later started right up drove around ok then did same thing now its sitting in my driveway running .sumtimes it just turns over and nothing and other times as soon as i turn key it starts i dont lose any power cuz my radio works any help
#538 of 589 JEEP GRAND CHEROKEE 5.2 4x4 PCV IDLE PROBLEMS!!! by sirpilla Jul 14, 2009 (12:16 pm)
I have a 1994 Jeep Grand Cherokee Lerado 4x4 all wheel drive with a 5.2 Liter(318) engine. Computer only throws an end code when trying to read with key turned 3 times and Auto Zone and Advanced Auto both said it's too old to read the codes with their meter. Last year I replaced the Cap and rotor along with the spark plugs and wire and now Within 2 weeks I have Replaced the Spark Plugs, Trottle Position Sensor, Air Idle Control Sensor, fuel filter, fuel pump checks out fine, PCV and hose that connects it to the engine were replaced twice in a week, cleaned all 8 fuel injectors and replaced all 16 of their O-Rings. fuel rail pressure is and was before cleaning injectors, exactly in spec 31 psi off and 39 psi when started. being despirate to try anything we added SeaFoam to the Valve cover and gas tank as a last resort and yet STILL after all of this it has a rough shaking my Jeep idle! When the PCV hose is hooked up, it starts and stalls, when you disconnect the PCV from the hose it stays running with the sluggish rough idle but it is the only way to keep it running! The minute you plug in the PCV the engine dies and doesn't want to restart until it's unplugged again! HELP ME PLEASE, I LOVE MY JEEP!!!
#539 of 589 09 stalling issue by raelinda Jul 22, 2009 (9:26 am)
2009 grand Cherokee (14K miles) stalls when slowing down for off ramps or lights dealer has replaced computer and ignition - did 3rd attempt for lemon law but they can not make it die so nothing wrong with it - we can not make it happen but it has died since computer fixed. now waiting for lemon cases to move forward due to sale of Chrysler.   Any other ideas of what we can check to prove there is an issue?

Messages Page 54 of 59 1 ... 51 52 53 54 55 56 57 ... 59 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Jeep Cherokee and Jeep Grand Cherokee Jeep Grand Cherokee Start Stall Idle Problems