Ask the Car People.SM


Chevy Colorado and GMC Canyon Accessories and Mods

26 messages,  Last post on Apr 21, 2010 at 6:29 PM

You are in the Chevrolet Colorado and GMC Canyon Forum.

What is this discussion about? Chevrolet Colorado, GMC Canyon, Exterior, Performance Mods, Truck

Messages Page 3 of 3

#17 of 26 Transmission gauge by stoltz

Apr 21, 2008 (9:58 am)

Just bought a 08 Z71 crew cab with the 3.7 eng.
I want to install a trans temp gauge and I was hoping someone could let me know who sells a A-pillar mount?
Checked with Summit already.
Thanks

#18 of 26 programmer by puregreen

May 29, 2008 (4:32 pm)

Has anyone used a programer to increase fuel milage yet?

#19 of 26 Re: Intake [puregreen] by northpack99

Jun 21, 2008 (2:58 pm)

Replying to: puregreen (Mar 16, 2008 4:30 pm)
Hi,
 
 I have a 2008 Colorado Reg Cab, 4cyl and can't find a cold air intake for it....they only have intakes for 5 cyl. What model and style is yours???
 
Thanks, Ed

#20 of 26 Re: Intake [northpack99] by puregreen

Jun 23, 2008 (11:35 am)

Replying to: northpack99 (Jun 21, 2008 2:58 pm)
I have an 05 crew z71 4x4 ls . They have them in stock at performance products.com for $300.00 or call 1-800-752-6268 ext7601 Travis is who i have been dealing with, they dont make programmers yet but im gonna order the magnaflow exhaust from them. good luck

#21 of 26 Re: Intake [northpack99] by pondscum

Jun 23, 2008 (2:53 pm)

Replying to: northpack99 (Jun 21, 2008 2:58 pm)
Better check this a bit further. I was myself all ready to order the big buck K&N kit today, right up to the point I checked their web site and found dyno test charts. The charts substantiate a near-10% HP increase as advertized, but specs are actually slightly less at "normal" rpm ranges 1-3K and the better breathing benefit doesnt take effect until 4K+ RPM! Dont know about you, but in trying to same a bit of gas, I try to keep out of hyperdrive.

#22 of 26 bull bars? by cbusrado

Mar 26, 2009 (7:55 am)

so ive got an 05 crew cab z71 and its already equipped with the chrome step bars. but im thinkin about throwin on a bull bar on the front? but i had to replace the bumper lip piece awhile back and some of the underneath supports are crack( which are not visible because the bumper lip piece covers it) but if i geta bull bar will it have to come off?

#23 of 26 insight by cbusrado

Mar 26, 2009 (12:06 pm)

anyone have any helpful suggestions on the topic as a whole. just wanted to see what the thing was about and whether the bumper lip has to come off or not

#24 of 26 Electric Fans by plutac

May 07, 2009 (1:29 pm)

I'm looking to replace that crappy stock clutch fan on my 04 I5. does anyone know how bad one is to install, things look pretty tight. I'm thinkin the flex-o-lite brand. Can anyone tell me if its a do it yourself or no? THANKS.

#25 of 26 need a larger tire by jlosee

Sep 15, 2009 (5:24 pm)

anyone know the largest and most aggressive tire i can put on my colorado 2wd without a lift?

#26 of 26 transmission cooler installation by guitarplay

Apr 21, 2010 (6:29 pm)

I purchased an aftermarket trans cooler for a 2004 colorado with 3.5L engine and the directions say to install it on the incoming flow side to the radiator but I have read it can go on the the return side which has a 6 inch section of rubber hose the can be cut and spliced into to make it easier.Anyone with any suggestions please help.

Messages Page 3 of 3

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement