Last post on Dec 10, 2013 at 12:34 PM
You are in the Chevrolet Colorado and GMC Canyon
What is this discussion about?
Chevrolet Colorado, GMC Canyon, Engine, Truck
#695 of 717 '04 Canyon finally runs right!
Apr 13, 2013 (4:36 pm)
My 04 Canyon I-5 5sp 2wd had rough idle problems especially after adding fuel and also a major bog when shifting since new. Dealers were never able to find anything wrong. I finally changed the vapor purge solenoid valve ($14.00 O'Reilly) located on the left side of the engine. It had been stuck wide open for 140,000 miles. Motor runs like new. Installing a big battery also finally resolved a 2-3 year period of heater-A/C blower & light bulb problems. Note that this truck has at least 15,000 miles towing a fairly light 16.5' boat & 10,000 miles pulling a 2 axle car trailer at up to 4,500 lbs. A lower rear axle ratio would be really nice for the towing. The best fuel mileage using 87 octane Arco (California junk gas w/alcohol) is 28.3 MPG.
A quick summary on this truck:
Heater blower has burned up 2 wire looms, 3 resistors, & 2 connector repair kits.
5 sets of 235/75R15 tires (original junk smaller Generals, 3 sets Yokohama Avid's, 1 set General Grabber HTS, & currently trying a set of Firestone Discovery LE2.
First ever front brake pads & rotors at 140,551 miles. I might do the rears next year! Amazing.
Outer tie rod ends replaced today 144,655 miles. I set the toe -3/16".
Other than a BIG Costco group 65 battery, oil, filters, wiper blades, a few light bulbs, cleaning throttle body, cleaning MAF, 2 broken windshields, and 1 set of spark plugs everything else is from the factory.
Due to the clunky handling & uncomfortable seats I would rate the truck a 5-6 out of 10.
#696 of 717 Re: 2008 Canyon engine [aaronmiller]
Apr 14, 2013 (1:27 pm)
See my post #695, it could be the same vapor purge solenoid problem that I had for so long. It never did create a CEL & it may be that the diagnostics only look for a failed valve coil and cannot determine that the valve is stuck in the open position.
#697 of 717 2006 Colorado and Dealer Attitude
Apr 23, 2013 (6:32 am)
I Have a 2006 Colorado with 55,000 miles on it. I took it into the local GMC dealer and they replaced a Manifold gasket and told me it also needed a valve job. I take great care of the truck. Why does it need a manifold and a valve job?
Anyway, I paid the bill for the manifold and have not had the valve job done yet. I asked about warranty coverage and was told the warranty expired two weeks prior.
I read the warranty that came with my truck and think that there may be coverage available under the emission warranty because of some extremely vague language in it. I filed a complaint with the GM people asking them about it and was rebuffed and treated rudely.
I asked the dealership about it and set up a meeting with their regional representative to see if any help or relief was available given the low mileage and recent expiry of the warranty.
I waited an hour past my scheduled appointment, and was then taken to the back of the service bays where the rep and manager insisted no help would be given. They could not answer my questions about the warranty with anything more than, "The warranty expired." I felt brow beaten. After I stormed out, the manager followed me to the parking lot of the dealership and blocked me from leaving while he yelled at me.
I am planning to sue, citing the warranty language, unless I can get some help somewhere. I came across this website and there is mention of people with similar problems with their Colorados and a possible warranty extension. Is there some help available without turning to small claims court?
#698 of 717 Re: 2006 Colorado and Dealer Attitude [69camaro1]
Apr 23, 2013 (12:42 pm)
If you send me your VIN number I can look up your vehicle history and figure out if you indeed have the Emission Select Warranty you mentioned previously, and we can work towards seeking a more satisfactory resolution for your concern. You can continue to message me at socialmediagm.com ATTN Amber. I look forward to your response.
GM Customer Care
#699 of 717 Re: 2006 Colorado and Dealer Attitude [gmcustsvc]
Apr 23, 2013 (1:11 pm)
You are at the eighth person from GM who has not answered my question. Can you not look up the warranty on a 2006 Colorado? None of the other seven I spoke to bothered to do that either. What do you consider the conditions for having the warranty apply? Is there or is there not an extended courtesy warranty for these engine failures? At this point, I feel like I am about to embark on another fruitless conversation with a GM flak and I am pretty much fed up. I swore I would never buy another GM after the door fell off my Baretta, but I was fooled and now I'm sorrowful.
By the way, I have no idea what it means to message you.
#700 of 717 Re: 2006 Colorado and Dealer Attitude [69camaro1]
by KCRam@Edmunds HOST
Apr 23, 2013 (2:50 pm)
They need the VIN to look up your Colorado because it may have equipment that will either qualify or disqualify the truck for the warranty extension. It's apparently not an across-the-board warranty.
"Messaging" Amber means contact her via email at the address in her post, with the subject line to her attention.
kcram - Pickups/Wagons/Vans+Minivans Host
#701 of 717 Re: 2006 Colorado and Dealer Attitude [69camaro1]
Apr 23, 2013 (4:20 pm)
I can look up the warranty on a 2006 Colorado, but I do need your VIN number in order to do this. As kcram mentioned, the warranties do apply on a case by case basis. By providing your VIN I can see what warranties are still current for your vehicle. If you'd like to "message" me, we are available through email at the following address: socialmediagm.com (ATTN Amber). Please let me know if you have any further questions.
GM Customer Care
#702 of 717 Colorado P0017
May 16, 2013 (10:50 am)
I own currently has 32,500 miles on it. I follow all recommended maintenance schedules and use only full synthetic oil. About a month ago, a check engine light came on producing a P0017 code. A quick search of the web showed this to be a popular problem with your vehicle.
While trying to diagnose the problem the following was replaced:
-Oil was changed (early of schedule),
-Camshaft actuator solenoid valve
-Camshaft position sensor
-Exhaust Cam Actuator
The dealership said that they have heard of “this problem” and have seen other Colorado’s like mine, but could not tell me why a Timing Chain would fail so early in the life of a vehicle. I have driven other GM vehicles and always have been happy with what I thought was a quality, affordable American vehicle. In the case of my Colorado, I feel as though I have unluckily bought a truck that will continue to break down. I have found many Technical Support Bulletins online describing the variety of related problems, but have found nothing as to why these problems continue. Is the design of the engine or production of the parts at fault?
To say the least, I’m unhappy with the quality of vehicle you have produced and am considering selling it before it breaks down again and my power train warranty expires in the upcoming months. Can anything be done to restore my faith in your product and company?
#703 of 717 Re: Colorado P0017 [jlenhard]
May 16, 2013 (12:46 pm)
I apologize that you have not been satisfied with your GM vehicle. I can certainly research more on your concerns in order to answer more questions for you. Could you please email me at socialmediagm.com [ATTN Amber], and I will look further into this for you. I look forward to your response.
GM Customer Care
#704 of 717 exhaust/intake odd noises with reduced performance
May 17, 2013 (1:26 pm)
My 2004 Canyon has started to make a noticable hissing sound instead of the usual turbo whine liken noise lately and I have also noticed the torque has been reduced as well,I apologize i dont know much about trucks and im trying to learn on my own.I really cant afford mechanic shops and i have some tools so any wise willing persons out there please help.thank you!