Last post on Feb 27, 2013 at 10:58 PM
You are in the Jeep Liberty and Jeep Liberty Diesel
What is this discussion about?
Jeep Liberty, Lights, Electrical, Diesel, SUV
#248 of 372 Re: Body Control Module vs Low Beam Relay 2005 Jeep Liberty [libertygirl13]
Oct 08, 2009 (6:16 am)
Had you used the highbeams AT ALL, prior to the flickering, Libertygirl13? I have not had a problem in 4 months, since eliminating TOTAL use of my mine. Unfortunately, living in a somewhat country area, this can prove to be a littel frustrating. I am searching for answers BEFORE bringing it to a dealer and will let everyone know, my progress.
FYI - I have 104,000. miles and have had the issue for about the last 15,000.
#249 of 372 Re: Body Control Module vs Low Beam Relay 2005 Jeep Liberty [wezwe]
Oct 08, 2009 (3:46 pm)
Thank you, Wezwe, for your good comments
I hadn't used the highbeams before it happened....Now, I know that it's not my imagination and I'll keep tabs on what else is going on in the car when this happens again. I'm like you, and won't bring my car in for this problem unless it becomes a hazard... I'll post when I have any more info. Thanks!
#250 of 372 Re: Jeep Liberty: Electrical & Lighting Questions [Mr_Shiftright]
Oct 15, 2009 (7:58 pm)
The turn signals and emergency flashers on my 2003 Liberty are not working. When I press the flasher button, it lights very dimly but does not flash. I could not find a flasher relay in the owner's manual. Any suggestions?
#251 of 372 Re: Jeep Liberty: Electrical & Lighting Questions [cane59]
by Mr_Shiftright HOST
Oct 16, 2009 (11:26 am)
The combination flasher for this model is integral to the hazard switch located in the center of the instrument panel, just above the radio. The combination flasher is a smart relay that functions as both the turn signal system and the hazard warning system flasher. It cannot be adjusted or repaired.
You might check to see if your directional signals are blinking at a higher rate that usual--this would indicate a bad bulb rather than bad relay.
#252 of 372 Re: Jeep Liberty: Electrical & Lighting Questions [Mr_Shiftright]
Oct 16, 2009 (6:07 pm)
Thanks. The signals do not flash at all. I will check out the hazard module and let you know.
#253 of 372 Fan stays on after the key is out
Oct 19, 2009 (6:19 am)
I have a 2002 Jeep Liberty with 56K and the fan stays on after the car is turned off and the key is out of the ignition so I have to ensure that before exiting the vehical that the fan is in the off position if not I have a dead battery. I own other jeep/chrysler products and the fan will only run if the key is in the ignition and in the on position no matter what.
#254 of 372 Re: Fan stays on after the key is out [ddingeman]
by Mr_Shiftright HOST
Oct 19, 2009 (10:05 am)
Only thing I can think of to do is go to the Power Distribution Center. There you'll find the heater blower motor relay, and also a spare relay of the same type next to it. If you could switch out the 2 relays---see if that cures the problem.
#255 of 372 Gauges zero out when air is on.
Oct 28, 2009 (4:37 pm)
I've had my 2003 Jeep Liberty for about three years now. Shortly after I got it the speedometer would drop to zero and then return to normal. I brought it back to dealership twice and both times they told me nothing was wrong with it. Now the the speedometer doesn't work at all. When the air is on the doors won't lock automatically and the temp, RPM, and gas gauge all drop to zero until I turn the air off. Odometer also doesn't work when the air is going. What is going on?
#256 of 372 Re: Fan Blower Control Problem [3rdcndjeep]
Nov 07, 2009 (10:07 am)
i have a 07 with same problem can you test the resistor before replacin it
#257 of 372 Re: Flashing interior lights [yojupiter7]
Nov 14, 2009 (9:53 am)
I have an 04 jeep liberty and am experiencing the same problem. The headlights and all interior lights blink off and on quickly, I also hear clicking noises while this ocurs, as I am driving. I too noticed it usually happens when it's cold out. Maybe the weather has something to do with it??? I noticed someone had mentioned their problem stopped after not using their highbeams, I have not used them in a long time, I know that is not the problem for my situation. I am looking for a solution as well, if anyone finds out anything please pass the word!