You are here:
Forums
SUVs
Jeep Liberty and Jeep Liberty Diesel
Jeep Liberty Starting and Stalling Difficulties
Jeep Liberty Starting and Stalling Difficulties
157 messages,
Last post on Nov 06, 2009 at 1:02 PM
You are in the Jeep Liberty and Jeep Liberty Diesel Forum.
Your Hosts are steve_ & tidester
What is this discussion about?
Fuel System, Electrical, Engine, Diesel, SUV
- #155 of 157
-
Re: Stalling Issues 2003 jeep liberty renegade [pktechgirl]
by jrlopez14
-
Oct 12, 2009 (12:51 pm)
-
|
|
Replying to: pktechgirl (Oct 11, 2009 10:02 pm)
i had similar problems too but mine wasnt with turns or stops but the codes did tell us that it was the camshaft and crankshaft sensor and we bought then and we did it ourselves its really easy...when we took our sensors off the were rusted on.
|
- #156 of 157
-
Re: Stalling Issues 2003 jeep liberty
by jar452
-
Nov 05, 2009 (10:18 am)
-
|
|
Replying to: jrlopez14 (Oct 12, 2009 12:51 pm)
So, I had the same issues: my speedometer was at 0 when going about 70 and the jeep would stall when I was coming to a stop. I just got it back from my mechanic and it's all fixed. Here is the problem: there was no slack in the wire that runs out to the speed sensor at the top of the rear differential. I must've hit a bump that knocked it loose. My mechanic was able to re-route the wires and allow for some slack and the jeep runs like normal now (no stalling and the speedometer works again). If the re-route is not possible, there is a Chrysler repair kit ( part # 05013995aa ) that basically includes some longer wires. Hope this helps!
(Other things to check: replace the speed sensor itself)
|
- #157 of 157
-
Re: Stalling Issues 2003 jeep liberty [jar452]
by caribou1
-
Nov 06, 2009 (1:02 pm)
-
|
|
Replying to: jar452 (Nov 05, 2009 10:18 am)
I was told that the rear differential sensor cable must remain out of reach from the hand brake cables. It's one of the hand brake cables that tears the sensor wires.
|
You are here:
Forums
SUVs
Jeep Liberty and Jeep Liberty Diesel
Jeep Liberty Starting and Stalling Difficulties