70 messages,
Last post on Dec 18, 2012 at 12:39 PM
You are in the
Dodge Magnum Forum.
What is this discussion about?
Dodge Magnum, Transmission, Wagon
Jan 10, 2009 (7:42 am)
In the book it says it has a saftey deley where it has to be warmed up or it will go into saftey mode... but now i went to start my car this morning and it idioled for about 2 seconds then shut off... i tried giveing it gas but it still shut off. The security light is on and will not go off... think it is a defect with the securtiy
#40 of 70 Re: Transmission 411 [batmobile2]
by jacc335
Mar 05, 2009 (10:39 am)
Do you know the part # for the dipstick & how remove the dipstick tube cap? I have been told the trans is sealed &draws in water & will not let it evatorate out
#41 of 70 Re: Transmission 411 [pancha252000]
by dtray50
Mar 16, 2009 (2:09 pm)
I have a 2006 sxt dodge magnum that is giving me the same issues (exact issues) that you are experiencing. Have you located the cause or had the issues resolved?
#42 of 70 Re: Transmission 411 [dtray50]
by jacc335
Mar 17, 2009 (6:05 am)
I'm Jacc335,I got your email of Mar 16. I have not had any issues with my trans in my 05 magnum. I removed the fill tube cap, got dip stick from junk yard, I'm going to add trans cooler later this summer .The sealed trans draws in water but does not vent it out.
#43 of 70 Re: Transmission 411 [jacc335]
by noocyt
Mar 18, 2009 (8:16 am)
2006 SRT8 MAGNUM WHAT IS THE PART # OR AFTER MARKET PLACE TO GET A DIPSTICK AND HOW DO I UNSEAL THE PRESENT ONE . I HAVE TRANSMISSION OIL ON MY GARAGE FLOOR ALSO WHAT TYPE OIL ??
#44 of 70 Dodge Magnum
by jacc335
Mar 18, 2009 (12:48 pm)
The part # is9336 I found it on internet for $109. I got one at junk yard for $1.00. Turn the fill tube cap slow,to left ,as you push down. cut the dip stick to fit. Mine is about "28.25..I will use top brand of oil. You can email oil co.
Apr 03, 2009 (10:31 am)
Well carried car to dealer and they said that it was ""veh had codes P0700, P0703 in correct gear ration. Codes are not current cleared codes and test drove if codes come back trans will need further diagnoses""... I was not told what the codes were or anything just rying to dig deeper into my pocket.. Looked codes up on net and found that P0700 is Transmission Control System Malfuction..P0703 is Brake Switch Circuit Malfuction... Has any one had such a thing happen Please let me know what the fix was??? Thanks
#46 of 70 Re: Clunks into Second [friscomagnum]
by kraygolf
May 21, 2009 (1:52 pm)
I have a 2008 SXT that I bought 3 weeks ago with 22K on it. Within 3 days I had this exact same issue. The shift from first to second gear in low RPM (around 1800) will clunk or even shudder. Best way I can describe is when you're driving a manual transmission and you shift at too low of an RPM and the car almost stalls. Took it to the dealership twice already, and they ran a TSB on it to flash the transmission computer as well as a quick learn. Still does it. And now I can feel it when it shifts in other gears. Also, it seems to slip at higher gears but only at low RPMs. Anyone else have this "fixed" and can give me some advice?
#47 of 70 Re: Transmission Slipping [scarab22]
by gerardl
Jun 02, 2009 (10:16 am)
think i have the same think . at about 140 miles the rpm will start going up and at 200 miles it just stops moving . i pull over stop shut off engine wait a min or so start up and go for a mile as it starts slipping to a stop well its been in the shop, was said the trans filter was not seated correct. that happen six day after i drove off the car lot now six day later the same thing just about 200 miles i drove .so now its back in the shop.I have 50000. mile on my used rt love the car hope they find a real fix hate to have to give it up please some one find a fix. just got a call from dealer said car is fixed after six days had said replaced tourgue converter and pump did a extensive road test and i should have no proplems so said. hey guys ill be back to give an up date.love my RT.oh it' an 2005