Last post on Nov 27, 2013 at 7:43 AM
You are in the Chrysler Sebring
What is this discussion about?
Chrysler Sebring, Convertible, Sedan
#97 of 110 Re: heater core replacement [nixonii]
Jan 28, 2013 (4:29 pm)
I replaced the heater core on a 2000 Sebring Conv. Hours were approx. 10 hrs. for a 'DYI'. I had another car to use so I took my time. Wasn't too bad but had a Chiltons manual to help guide me. If you are used to working on cars and can take time it isn't too bad a job. I also did the heater core in my 1994 T&C Van which was quite the job. That was more like a week job - had to strip down the entire interior.
#98 of 110 Re: Climate controller [teneeds1]
Jan 28, 2013 (4:29 pm)
I had the same problem on a 2000 Sebring Conv. I replaced the entire control unit - heat/blower/ac knob unit. Bought a replacement unit at a salvage yard for $20. Took me about 2 hrs. including pulling the part from the salvage yard. I think others had paid $350 for a new replacement unit from Chrysler. Also had the resistor problem along with the fan unit. Replace two resistors and finally the blower fan before replacing the resistor for the third time. Overall I have ~150K miles on this 2000. While I have done some repairs - also the heater core, it has been a good car for 10 years+
#99 of 110 Re: heater fan resistor [ardvark02]
Jan 28, 2013 (4:28 pm)
Might want to check out replacing the fan unit at the same time. I replaced two resistors and then finally the fan unit along with the 3rd resistor. (2000 Sebring Conv.)
#100 of 110 Problem with sebring a/c heat control switch
Jun 03, 2013 (6:55 pm)
I have a 2001 sebring. The a/c and fan work but not the heat,rear defrost, and the air directional knob.When I turn on the a/c the air comes out strong but then settles down a lil.Is this normal?Nothing happends when I turn on heat ,rear def or directional air knob.Can or should I take it apart and fix the control switch first or do I need to buy new one? Can it be the resistor or something else? Thanks !!!
#101 of 110 AC and Heater issues in 2002 Sebring
Jun 15, 2013 (7:02 am)
We had the car in the shop and got the air flow direction door fixed on my wife's 2002 Sebring so that's ok. But there are still issues with the climate control. When she's driving at faster speeds, the AC (or heat, when needed) seems to work fine, putting out good cold (or warm, if heating) air. But when she's driving at slower speeds such as in city traffic or stopped at signal lights, the air coming out when using AC doesn't feel cool at all, and when using the heater, it doesn't feel warm. Should engine rpm affect the climate control output? It doesn't seem to in other vehicles.
Also, and this may be related or not, when she parks and turns the car off, the coolant often boils into the reserve reservoir and out an overflow tube. Does this indicate a faulty thermostat? We did have that replaced but it still happens. The wife says this has been going on since we bought the car.
Trying to get these issues fixed has been a thorn in my wife's side since none of the local garages seem to be successful at it, and it costs a bunch each time we take it in.
#102 of 110 Re: heater fan resistor [ardvark02]
Jul 01, 2013 (7:56 am)
Was wondering if you could offer a little guidance on how to find/access it. the fan works in my 04 sebring convertible, but not the a/c. Just had it checked for $75 & they said it was full.
#103 of 110 Re: heater fan resistor [crimsonred]
Jul 01, 2013 (9:48 am)
If your fan works,it must not be the resistor.First check panel control switch then thermostat.I had problems with mine.Bought a used one junk yard changed thermostat.Like new.
#104 of 110 a/c switches vents...all by itself
Jul 02, 2013 (2:17 pm)
Hi. I think my a/c has a poltergiest! It blows cold air from the front panel venr, then all by itself, it starts blowing thru the defrost vents. .. then moves to the floor vents. .. switches to warm air. ..then back to cold air. ..then back to the front panel vents. ... etc. .. anyone else? ??? I would love some feedback... Thank you. ..
Its a 2007 sebring convertible
#105 of 110 Re: a/c switches vents...all by itself [danyll]
Jul 03, 2013 (10:27 am)
Take out the control panel switch and disconnect and connect if that doesn't do it then sounds like you need a new control panel switch
#106 of 110 Sebring A/C prolem
Jul 08, 2013 (12:36 pm)
I have a 2001 Sebring LXI with the 3.0 engine. The compressor will only run in fan position 1. The fan doesn't run while in that position. As soon as you move the blower switch to any higher speed position the fan runs, the ac light goes off, and the compressor shuts off. The compressor doesn't run in defrost either. Anybody have any ideas??? Thanks!!