Ask the Car People.SM


FWD Chrysler 81-95 Performance Tips

18 messages,  Last post on Jan 12, 2011 at 12:19 AM

You are in the Speed Shop Tuning and Modification Forum.

What is this discussion about? Chrysler Le Baron, Dodge Daytona, Plymouth Laser, Performance Mods

Messages Page 2 of 2

#11 of 18 Daytona switches by angelscowboy

Mar 27, 2008 (4:38 pm)

I finally got a picture of those switches. I have my doubts that they're original equipment. The toggle on the far left lifts the lights. The one on the right is rigged up to the carburator to lock out the 4 barrel as a fuel saving option. I still have yet to find any function for the 3 in the middle.

#12 of 18 No Heat by kayfuslee

Jan 20, 2009 (7:26 pm)

Anybody know why it would take almost a 1/2 hr of driving before getting heat in the car?

#13 of 18 Re: No Heat [kayfuslee] by PAman

Jan 26, 2009 (7:49 am)

Replying to: kayfuslee (Jan 20, 2009 7:26 pm)
Check two things; your thermostat and the radiator fans.
 
On some cars, when you use the defroster setting, it automatically turns on the A/C compressor. That is due to the fact that dry warm air clears a windshield faster than warm moist air. If the A/C compressor comes on, most cars these days automatically turn on the radiator fans in order to keep the compressor from being overpressurized on the high side. However, if the fan is on, it could keep your car from warming up quickly.
 
Also, your thermostat could be the wrong one, coming open too soon, or be stuck in the open position. If it is open and coolant is flowing all the time, it will take a LOT longer for the heater to put out any heat. Most manufacturers call for a 185, 190 or 195 degree thermostat. A good parts store can tell you what your car should have.
 
BTW, do NOT buy a Robert Shaw thermostat. Go with an OEM or a Stant thermostat.

#14 of 18 1989 lebaron turbo by redbarron00

Feb 01, 2009 (1:04 pm)

my 1989 chrysler le baron turbo has poor acceleration any fixes

#16 of 18 coil by pogen

Aug 18, 2009 (5:21 am)

no power to coil on my chrysler lebaron 2,5 88 mod help

#17 of 18 Re: No Heat [kayfuslee] by thingfish42

May 29, 2010 (1:02 am)

Replying to: kayfuslee (Jan 20, 2009 7:26 pm)
Your cooling fans are turned on and off automatically via a temp sensor and/or relay swtch. You can locate this sensor either near the intake or sometimes on the radiator itself (usually near bottom). If you "jumper" the pins your cooling fans should kick on (key in access. on position). If they do you prob have a bad sensor. If they don't you may have either bad wiring or a bad relay switch (fuse block under hood driver's side - 1st relay in upper right corner).

#18 of 18 88' Lebaron reving up while shifting by superman8193

Jan 12, 2011 (12:19 am)

Hello. I am a noob around these parts, and to my newly acquired 1988 Lebaron Convertible. It is a 4 cyl. 5 spd. Manual. It has just over 111,000 miles on it. My problem is that when it's cold out, (like now) if the car is not warmed up, (which I have been told not to do) when shifting gears, it revs up really high! It doesn't matter what gear I am in, as soon as I engage the clutch & pull it out of gear into the neutral position, or just normal shifting, the engine revs so high that it is starting to freak me & the wife out. And since it revs so high, once the stick shift is set into the next gear, the car "lightly" lurches forward. But then the RPM's go down to normal levels until the next shift, then up it goes again. Now, if I let the car warm up like 10 to 15 minutes, (which I have been told is hard on the engine) it is fine. Any ideas on this one? Any help will be greatly appreciated! Thanks.

Messages Page 2 of 2

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement