Ford F-Series Electrical and Lighting Problems

136 messages,  Last post on Feb 03, 2013 at 2:22 PM

You are in the Ford F-Series Forum.

What is this discussion about? Ford F-150, Lights, Truck

#86 of 136 Re: odometer display intermittent [sfechtig] by crawdoogie

Apr 11, 2009 (1:54 pm)

Replying to: sfechtig (Apr 06, 2009 5:27 am)
This is a very common problem with 1999-2000 F-150's. The dealer charges several hundred dollars to replace instrument cluster circuit board. Fortunately it is fairly easy to fix yourself. Links below to a couple of "how to's".
 
http://www.ford-trucks.com/forums/196821-odometer-blackout-problem-fixed.html
 
http://www.f150online.com/forums/electrical-systems/126765-intermittent-odometer- -repair.html
 
Doug

#87 of 136 Bad FUSE? by platinummike

Apr 20, 2009 (6:36 pm)

Replying to: crawdoogie (Apr 11, 2009 1:54 pm)
I have a Ford F150 Platinum. Everything was working fine, until my electric tilt, electric foot pedal adjustments, and my power seat would not work. When you puch the buttons, you can hear the relay clicking under the seat. Went back to Ford and they said they replaced a fuse that was bad behind the glove box.(not accessible to regular people). They fixed it and it happened again about 1 week later. Same symptoms. Going back to dealer tommorrow. Any ideas whats wrong?

#88 of 136 1992 f150 by josh92f150

Jun 20, 2009 (10:13 am)

Both turnsignals frotn and back do not flash unless I continuously flip up and down, and only while I press on my breaks. Fuses in the dash and under the hood are good and the emergancy lights work fine. Any Ideas?

#89 of 136 headlight problems 1985 F 250 by gene50

Jun 21, 2009 (10:34 am)

My headlights went out suddenly. I replaced the switch and this didn't help. I replaced the voltage regulator, and lights and there is still not enough juice.

#90 of 136 Re: 1992 f150 [josh92f150] by kcram HOST

Jun 21, 2009 (6:21 pm)

Replying to: josh92f150 (Jun 20, 2009 10:13 am)
Check the flasher itself... it's usually on the backside of the fuse panel under the dash. Swap in a new one (very inexpensive) and see if that cures it.
 
kcram - Pickups/Wagons Host

#91 of 136 door open light stays on by jeannep

Jul 08, 2009 (9:53 am)

2002 F250 dash light stays on indicating doors open. Overhead and cargo light stay on about 10 minutes after closing doors, Tried the WD 40 on the door hinges, whats the next step?

#92 of 136 Re: 01 F150 Supercrew electrical issue [madison4] by chaptom

Jul 08, 2009 (6:15 pm)

Replying to: madison4 (Aug 13, 2008 6:45 pm)
hi, i am having the same issue and tried the plastic 30 amp fuse also and it did not work. I was wanting to know if you figured out your problems yet because i am confuzed on this one. thanks tom

#93 of 136 Re: 2008 150 Towing Vibration [jdr5] by dakotaski

Jul 20, 2009 (11:57 am)

Replying to: jdr5 (Nov 18, 2007 6:47 am)
Regarding msg #30.I had the exact same thing happen while driving my friends '08 ford f350 while pulling an empty horse trailer. As soon as you lift your foot off the gas pedal the shake stops. The speeds are only around 45 mph and as you start to accelerate past that point the shake increases. Please tell me there is an easy fix for this problem??

#94 of 136 2002 F250 lights/ door's ajar by jeannep

Jul 20, 2009 (11:10 pm)

Seller had it fixed at the Dealer. " Part: XF2Z 14018 AA switch asy - alarm
removed defective passenger door ajar switch / SCIT CH came out in 2 pieces. Installed New. (Parts: $29.58, Labor $155)
Don't forget to pay yourself for your hard work!

#95 of 136 '98 F-150 Dash Lights by newdelman

Aug 26, 2009 (6:57 pm)

I've owned my '98 F150 for almost 3 years. The lights on the instrument panel haven't worked since I purchased the truck. I have pulled out the light switch and cleaned it using compressed air. This didn't help. I checked and confirmed that all wires are attached. Would this be a defective switch?
 
Also, the door alarm counds every time I open the door. It sounds as it would if I left the key in the ignition and exited the vehicle. I suspect that the problem may be in the steering column. By shaking the key switch will stop the alarm bell for a few seconds and then the ringing comes back. I tried tightening the steering column housing and this didn't work. Does anyone know about this problem and how to fix it?
 
Thanks for your help.
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement