You are here: Forums Coupes & Convertibles Chrysler Sebring Chrysler Sebring Warning Lights and Problem Codes

Chrysler Sebring Warning Lights and Problem Codes

112 messages,  Last post on Nov 04, 2009 at 2:35 PM

You are in the Chrysler Sebring Forum. Your Host is claires

What is this discussion about? Chrysler Sebring, Convertible, Sedan

Messages Page 11 of 12 1 ... 6 7 8 9 10 11 12 Prev Next Last

Go To Msg # Search This Discussion

#93 of 112 Re: Solid (not blinking) engine light [qwestgirl] by azzura Apr 22, 2009 (5:54 pm)
Replying to: qwestgirl (Apr 22, 2009 1:13 pm) thank you so much for the information. I don't think we have an advance auto in new york. is that the same as pep boys. Replies to this message: qwestgirl (May 05, 2009 12:58 pm)
#94 of 112 warning lights, AGAIN!!! by jbug1964 May 05, 2009 (9:12 am)
I recently posted about the engine light and gascap light staying on. Now the airbag light keeps coming on. Any advise?
#95 of 112 AIR BAG LIGHT ON by light731 May 05, 2009 (9:28 am)
I get this message off and on. I have had my steering column replaced and my seat belt tensioner replaced at a cost of over $1,000.00. None of the work was covered by my so-called warranty that I bought. Neither fixed the problem. I notice when I move the passenger seat back and forth the light will come on the remain off and on for a while then I might not see it again for months. I still don't know what the problems is either but I don't trust Chrysler to look at it again the charge me more money that should be covered by my warranty. And, yes, I did fight that but lost.
#96 of 112 Re: Solid (not blinking) engine light [azzura] by qwestgirl May 05, 2009 (12:58 pm)
Replying to: azzura (Apr 22, 2009 5:54 pm) Unfortunately, Advance Auto is not the same as PEP Boys. If you have an Auto Zone in your area they will also reset the check engine light for you. I am sure that there are other "chain" auto stores that will also reset this light. You may need to just check around until you find one.   It amazes me how many people think that if the problem is fixed, the light will just go off by itself. Don't we wish!...The light has to be reset. You can also disconnect the positive side of your battery (about 10 minutes or so) and reconnect after that time. This will reset the light. However, you could end up with chugging and sputtering problems for a spell because the "memory" will also reset. Probably not something to recommend unless you have done this before.   Good luck!
#97 of 112 speed problem and code P0605 ,airbag light,and engine light by mperea May 23, 2009 (10:02 am)
My 2001 chrysler sebring LXi starting w/ speed problem after fueled ,dont want to change the overdrive and still rnning slow. The computer revealed code P0605 ,also the airbag and engine lights still on ,need some recommendations ,its that related to trasmission problem,im very worry Please help me!
#98 of 112 Re: Air Bag Light and fan control [jenniferlynn] by tchado1 Jun 04, 2009 (11:20 am)
Replying to: jenniferlynn (Jul 13, 2005 12:30 pm) Hey, where did you go to get the blower motor fixed? Just wondering if a dealer is cheaper than someplace like pep boys...
#99 of 112 Re: Air Bag Light [blue02conv] by tchado1 Jun 04, 2009 (11:30 am)
Replying to: blue02conv (Jul 01, 2005 6:44 am) Hi Just wondering if you could tell me about fixing the climate control fan ....my air bag light also just came on this week.... Thanks, Chad tchado1yahoo.com
#100 of 112 Engine Light On by shoethke Jun 18, 2009 (3:38 pm)
I have a 2005 Chrysler Sebring convertible, 6 cylinder with 100,000 miles on it and recently the engine light came on and the code is p0302 which i was told was the 1/1 oxygen sensor, so i changed the sensor and the spark plugs and cleared the code but the enging light came back on and stays on, what can i do? Replies to this message: qwestgirl (Jun 18, 2009 4:56 pm) qwestgirl (Jun 18, 2009 5:16 pm)
#101 of 112 Re: Engine Light On [shoethke] by qwestgirl Jun 18, 2009 (4:56 pm)
Replying to: shoethke (Jun 18, 2009 3:38 pm) It could be something as simple as a gas cap issue. I recommend going to either Advanced Auto or Auto Zone and having them run the scan to get the latest code. They will do this free of charge and even clear the code for you if that is what you choose. However, clearing the code is not recommended if you plan on taking it to a mechanic to fix. If the code is cleared they will not be able to determine if a problem in fact exists. Most places here, in Florida, won't guarantee that the work performed will fix the problem if they don't in fact know what that problem was. They will not diagnose the problem simply based on info supplied to them. They cannot even run a diagnostics test to determine the problem until that light comes back on.   I hope this info helps...Good luck!
#102 of 112 Re: Engine Light On [shoethke] by qwestgirl Jun 18, 2009 (5:16 pm)
Replying to: shoethke (Jun 18, 2009 3:38 pm) I am also thinking that the P0302 code may actually be a misfire...It could be any one of the following and in my case it was the camshaft position sensor.       * Faulty spark plugs or wires     * Faulty coil (pack)     * Faulty oxygen sensor(s)     * Faulty fuel injector(s)     * Burned exhaust valve     * Faulty catalytic converter(s)     * Stuck/blocked EGR valve / passages     * Faulty camshaft position sensor     * Defective computer (highly unlikely)

Messages Page 11 of 12 1 ... 6 7 8 9 10 11 12 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Coupes & Convertibles Chrysler Sebring Chrysler Sebring Warning Lights and Problem Codes