Last post on May 29, 2013 at 4:07 AM
You are in the Chrysler Sebring
What is this discussion about?
Chrysler Sebring, Convertible, Sedan
#129 of 160 engine light and oil light
Nov 17, 2010 (1:30 am)
Driving to work and my car stalls. Oil light has been coming on and off the last day or so. Have put oil in my car the last few weeks. Then my check engine light came on and before I could get to a safe spot, it stalled.
Thankfully I was near a gas station, added 2 quarts of oil. It sounds like it wants to turn over but nothing. It's like something isn't sparking for it to start up. I will admit I am overdue for an oil change, so could this have anything to do with it?
#130 of 160 washer fluid leak
Nov 17, 2010 (3:38 am)
when i put windshield washer fluid in my car, it is gone right away. i don't use it often. but the other day when i put some in, i saw something leaking from under the car. i think there might be something wrong with the container that the washer fluid goes in . what should i do.
#131 of 160 chrysler sebring engine missfire
Jan 16, 2011 (6:53 pm)
I have a 98 sebring convertible engine misfire when pass 3500 rpm if I go to lower rpm engine is fine I already change crank and cam sensor also change fuel pump and filter that any one have this problem before or have what could be the problem
#132 of 160 Re: "Change Oil" indicator reset? [08_slvr_sea]
Apr 29, 2011 (7:13 am)
To reset the indicator of oil change on Sebring 2008 : turn ignition key on (do not start the car) then press on the gas 3 times, the indicator will be rest.
#133 of 160 Re: 2001 Chrysler Sebring LXi Engine Light [trac82]
Jun 09, 2011 (5:41 am)
To reset your check engine light disconnect the NEGATIVE battery cable. Leave it off for about 5 to 10 minutes then reconnect the cable. It may take a couple of trys for the car to start and it may run a little rough for a minute or two while the computer resets but your light will be off.
#134 of 160 engine light and code
Sep 13, 2011 (2:41 am)
i have a 2006 sebring convertible v6. have had main computer board changed in 2008. i have had check engine light on for almost 2 years. was coded as miss fire cyclinder 5. needed new fuel injector. replaced and went 1000 miles no problem then light back on. replaced spark plug and moved the new fuel injector to another cyclinder, 70 miles check engine light on still saying misfire at cyclinder 5, tried to reset wouldn't. also have no swish when i remove gas cap. i seem to think a vaccum line has problem but not showing up. fuel milage has decreased with this. techs think i'm crazy and don't know about autos because i'm a woman. i used to help my dad with the cars, so do know autos. HELP!
Sep 18, 2011 (6:38 pm)
I have a light on, on my dashboard it is an exclamation point it is under the D where you put the car in Drive what would that mean i don't have a manual with this used car. Help
#136 of 160 Re: 2007 sebring [gcassity]
by Claire@Edmunds HOST
Sep 18, 2011 (9:28 pm)
Pretty sure it's your tire pressure notification.
Automotive News & Views | Coupes & Convertibles
#138 of 160 Re: 2007 sebring [claires]
Sep 19, 2011 (11:43 am)
you were right it was the tire pressure notification thank you so much.