Denali Yukon Traction Active Readout on Display

26 messages, Last post on Oct 19, 2009 at 5:57 AM

You are in the GMC Yukon Forum. Your Hosts are steve_ & tidester

#24 of 26 response to misionnortena by wingtzun Sep 21, 2009 (11:07 am)
On mine it turned out that the front left wheel hub was loose and needed to be replaced. Once it was replaced the problem was fixed. Dealers want about $450 for the hub and another $200 for labor. It was interesting that my rear brakes were worn as well and needed to be replaced, however the fron still had over 50% of the pads left. The problem with the wheel hub was kicking in the ABS shutting down the front brakes so the rears were doing all the work.
#25 of 26 Re: yukon denali 2003 traction active and abs kicking in [denaligirl] by aaronwi Oct 16, 2009 (5:57 am)
Replying to: denaligirl (Sep 20, 2009 10:13 am) I have an '06 with the exact same issue. I'm out of warranty so they won't pick up the bill, but my service manager just told me it's a $70 repair (per axle) to fix the corrosion. That sounds fair to me!!!!!
#26 of 26 Wheel Speed Sensor Repair by wrencherrr Oct 19, 2009 (5:57 am)
Have had the corrosion issue with my '99 on 3 separate occasions now, so am familiar with the cleaning procedure. I went to remove the R/H sensor, but the plastic body cracked off, and is still stuck in the bearing. Main body and coil/magnet assembly is out, so just the remaining shell is left in the bearing/hub. Am looking for suggestions on how to remove the shell without introducing debris into the bearing/reluctor. Any ideas? Thanx!