Encoder Motor Problem for 97 GMC Jimmy

40 messages, Last post on Oct 26, 2009 at 4:26 PM

You are in the GMC Jimmy Forum. Your Hosts are steve_ & tidester

What is this discussion about? GMC Jimmy, SUV

Outline

Messages Page 5 of 5: 1; 2; 3; 4; 5; Prev; Next; Last

#39 of 40 Re: 99 jimmy 4x4 [michael79] by michael79 Oct 26, 2009 (3:41 am)
Replying to: michael79 (Oct 24, 2009 5:40 am) ok men, thank you, i think i read enough to understand that most likely it is the encoder motor. if not, i'll be back. michael Replies to this message: michael79 (Oct 26, 2009 4:26 pm)
#40 of 40 Re: 99 jimmy 4x4 [michael79] by michael79 Oct 26, 2009 (4:26 pm)
Replying to: michael79 (Oct 26, 2009 3:41 am) i did find a bare wire under the brush guard that goes to the encoder motor, next to the connection it was rubbing on the shaft, going to the shop now they help me out, can not do it laying down with my neck. you all have given alot of insight for this problem. thank you

#39 of 40: Re: 99 jimmy 4x4 [michael79] by michael79; Oct 26, 2009 (3:41 am)

Replying to: michael79 (Oct 24, 2009 5:40 am)

ok men, thank you, i think i read enough to understand that most likely it is the encoder motor. if not, i'll be back.
michael

michael79 (Oct 26, 2009 4:26 pm)

#40 of 40: Re: 99 jimmy 4x4 [michael79] by michael79; Oct 26, 2009 (4:26 pm)

Replying to: michael79 (Oct 26, 2009 3:41 am)

i did find a bare wire under the brush guard that goes to the encoder motor, next to the connection it was rubbing on the shaft, going to the shop now they help me out, can not do it laying down with my neck. you all have given alot of insight for this problem. thank you