Encoder Motor Problem for 97 GMC Jimmy

40 messages, Last post on Oct 26, 2009 at 4:26 PM

You are in the GMC Jimmy Forum. Your Hosts are steve_ & tidester

What is this discussion about? GMC Jimmy, SUV

#38 of 40 99 jimmy 4x4 by michael79 Oct 24, 2009 (5:40 am)
i read alot of the post's about the problems of failed 4x4, mine was stuck in 4x4 for awhile and always thought it was a cv joint, i finely got it out of 4x4 but i found there was that atc blown fuse, put a new one in and it blew, i got to the tccm and checked the wires, did seem fine, i plugged the little cable in first and the fuse did not blow, hooked up the big one and pop, where is a good place to check. i have checked wires and seem good, i did not drop the gaurd under the encoder motor to check anything there, help would be appreciated. thank you all Replies to this message: michael79 (Oct 26, 2009 3:41 am) michael79 (Oct 26, 2009 4:26 pm)
#39 of 40 Re: 99 jimmy 4x4 [michael79] by michael79 Oct 26, 2009 (3:41 am)
Replying to: michael79 (Oct 24, 2009 5:40 am) ok men, thank you, i think i read enough to understand that most likely it is the encoder motor. if not, i'll be back. michael Replies to this message: michael79 (Oct 26, 2009 4:26 pm)
#40 of 40 Re: 99 jimmy 4x4 [michael79] by michael79 Oct 26, 2009 (4:26 pm)
Replying to: michael79 (Oct 26, 2009 3:41 am) i did find a bare wire under the brush guard that goes to the encoder motor, next to the connection it was rubbing on the shaft, going to the shop now they help me out, can not do it laying down with my neck. you all have given alot of insight for this problem. thank you