Sign In Join 



1996 - 2001 First Generation Honda CR-Vs

61 messages,  Last post on Nov 23, 2009 at 9:47 AM

You are in the Honda CR-V Forum. Your Hosts are steve_ & tidester

What is this discussion about? Honda CR-V, Car Buying, SUV


Messages Page 7 of 7
1
2
3
4
5
6
7
Prev
Next
Last
Go To Msg #
Search This Discussion

#55 of 61
vibration when car is not moving by faz3168
Dec 22, 2007 (5:49 am)
Reply
my 1998 CR-V (mileage 85,000 miles) vibrates continuously when I stopped at traffic light. It vibrates even more in "P" than in "D". Can anyone help me with this problem???
#56 of 61
Re: vibration when car is not moving [faz3168] by dtstof
Dec 22, 2007 (9:56 pm)
Reply

Replying to: faz3168 (Dec 22, 2007 5:49 am)

Perhaps you've got a bad engine mount.
#57 of 61
Re: 2000 CRV with Transmission Trouble [drive62] by amcanoe
Feb 15, 2008 (3:56 am)
Reply

Replying to: drive62 (Sep 28, 2006 6:57 am)

You are not the only person experiencing transmission problems. The original transmission lasted 52,000 miles (replaced under warranty) the second lasted 68,000 miles and I had to eat the third one at a cost of $1600.00, rebuilt. I have a 2001 model but it is the same transmission.
#58 of 61
Re: Older Honda CR-V's [lisan] by stevegio
Feb 23, 2008 (2:19 am)
Reply

Replying to: lisan (Sep 12, 2006 4:14 pm)

have an 01 with 74k - you would think it is a brand new car.
these are 200 to 300k cars. IF MAINTAINED CORRECTLY.
its not a question of the milage but was it taken care of?
if so 123k is nothing to a honda - an american car NEVER- but a honda, no problem.
change the timing belt get new belts, hoses, fulids ect - should be OK - again "IF IT WAS MAINTAINED"
steveg
#60 of 61
CRV stalls when put in gear by tiwica
Nov 22, 2009 (11:13 am)
Reply
My fiancee has a 1999 CR-V that stalls and will not idle when put into gear. It starts and idles just fine at first but after the stall it will not start unless you really hold the gas down hard. I changed the fuel filter and the air filter but that didn't help. Car recently overheated due to a coolent leak. (no coolant in the oil) Engine light is also on all the time. I could not find any vacuum leaks. Car will run in gear as long as engine is revved with foot on the brake but as soon as you let off the gas it dies.
#61 of 61
Re: CRV stalls when put in gear [tiwica] by blueiedgod
Nov 23, 2009 (9:47 am)
Reply

Replying to: tiwica (Nov 22, 2009 11:13 am)

My fiancee has a 1999 CR-V that stalls and will not idle when put into gear. It starts and idles just fine at first but after the stall it will not start unless you really hold the gas down hard. I changed the fuel filter and the air filter but that didn't help. Car recently overheated due to a coolent leak. (no coolant in the oil) Engine light is also on all the time. I could not find any vacuum leaks. Car will run in gear as long as engine is revved with foot on the brake but as soon as you let off the gas it dies.
 
So, the CEL is on and the car is trying to tell you something, but instead of listenning to it, you post on the internet?
 
Check the CEL and see what it says.
 
My question would be when were the valves adjusted last time? And chances are the code is going to say "misfire on one or all cylinders."
 
But, read the codes first, before you do anything else. The car is trying to tell you what is wrong.

Messages Page 7 of 7
1
2
3
4
5
6
7
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement