21 messages,
Last post on Jan 25, 2009 at 8:49 AM
You are in the
Chevrolet Cavalier Forum.
What is this discussion about?
Chevrolet Cavalier, Exterior, Interior, Sedan
#2 of 21 Pimping...
by morfusaf
Sep 04, 2006 (10:05 pm)
I want to change the style of my cavalier
. I am currently considering... these... Body kit(MUST)(including side fenders), Paintjob (simple but not plain), lambo doors, entire interior redone.. (blue and black or blue and orange)(currently ugly tan color on blue car), and possible turbo or nos kit..
Here is my questions..
1.)How hard is it to paint over the plastic type material (dashboard, door handle, steering whell, and such)and what kind of paint will iI need? and what preperations? I want every peice of the inside either Black, Blue, Orange... Including carpeting.
2.) I don't nessesarily want to buy new seats but i want to change the material on them... is this expensive to have done and where could i have it done(i live in OKC)(would i have to send them off?).. I want a Small custom design (super simple) if possible.
3.)I found blue carpet for the interior, However it just covers the floor board not the carpet in the rear dash or on the doors... Where could i find these?
3.)I want the roof to also be changed what type of place might do this and how expensive?
4.)And last question of today... I heard it was possible to have a NOS kit added to a car.. say a "100 shot" that only is used when you have the gas pedal fully pressed. (this 100 shot i heard about does that means it adds 100HP? and how expesive is this to buy/have put in. and where can i find this...
I have a friend who owns a shop and will be able to help with lots of the installs say the nos kit or turbo.. and body kit.. but the paint i gota do or have done.. I really want to do the painting of the interior my self if it isn't to hard to do a good job..
Thanks... Morfusaf *just hanging in the desert*
#3 of 21 Pimping...
by morfusaf
Sep 05, 2006 (6:19 am)
I want to change the style of my cavalier . I am currently considering... these... Body kit(MUST)(including side fenders), Paintjob (simple but not plain), lambo doors, entire interior redone.. (blue and black or blue and orange)(currently ugly tan color on blue car), and possible turbo or nos kit..
Here is my questions..
1.)How hard is it to paint over the plastic type material (dashboard, door handle, steering whell, and such)and what kind of paint will iI need? and what preperations? I want every peice of the inside either Black, Blue, Orange... Including carpeting.
2.) I don't nessesarily want to buy new seats but i want to change the material on them... is this expensive to have done and where could i have it done(i live in OKC)(would i have to send them off?).. I want a Small custom design (super simple) if possible.
3.)I found blue carpet for the interior, However it just covers the floor board not the carpet in the rear dash or on the doors... Where could i find these?
3.)I want the roof to also be changed what type of place might do this and how expensive?
4.)And last question of today... I heard it was possible to have a NOS kit added to a car.. say a "100 shot" that only is used when you have the gas pedal fully pressed. (this 100 shot i heard about does that means it adds 100HP? and how expesive is this to buy/have put in. and where can i find this...
I have a friend who owns a shop and will be able to help with lots of the installs say the nos kit or turbo.. and body kit.. but the paint i gota do or have done.. I really want to do the painting of the interior my self if it isn't to hard to do a good job..
Thanks... Morfusaf *just hanging in the desert*
#4 of 21 Re: Pimping... [morfusaf]
by halsca
Sep 05, 2006 (11:30 am)
I don't know much about the other stuff but I would think twice about adding NOX unless you do some major reworking to the motor's lower end.
Remember GM did not design this motor for racing only 'freeway commuting'. It has potential but I don't think it could handle that sort of added stain for very long.
#5 of 21 Re: Pimping... [morfusaf]
by gmoudy
Sep 08, 2006 (3:56 am)
Since you didn't inform us as to the year and size of engine you have in your Cavy, it is hard to say that you can run a 100 shot on a stock engine. I do know a few folks that have done it, but they had Ecotec engines and one person had a 2.4L. To give you a safe answer, you need to tell us your engine year and size.
To answer your other question, yes 100 shot gives about 100hp.
#6 of 21 Re: Pimping... [gmoudy]
by morfusaf
Sep 08, 2006 (6:21 am)
Its an EcoTec 2.2L, year 2003.what is the price for the 100 shot while gas pedel fully depressed system?
#7 of 21 Re: Pimping... [morfusaf]
by gmoudy
Sep 13, 2006 (3:35 am)
If that 2.2L Ecotec was kept in great condition, you should be able to run a 100 shot with stock internals. The price varies from system to system. It also depends on whether you do a wet system or a dry shot. Search the internet for the information you need and then make an informed decision on what to buy. Most people that go with NOS use a wet system. It's safer at the higher shot range. Again, search and research before you buy a system.
#8 of 21 can a sunroof be added to a hard top 2001 cavalier
by gypsyrose
Mar 08, 2007 (6:13 pm)
i have a 2001 cavalier its a hardtop four door cavy, but i've always wanted a sunroof not those retractable kind just the solid glass. all i want is to let the sun in . so my question is if it's possible to do that, do they sell kits for that and how much would it cost me.
#10 of 21 Grille and interior mods..?
by car1902
Jul 09, 2007 (11:05 pm)
I just got my 2002 cavalier, and I have seen on car domain a bunch with colored dashboards and colored vent covers and random crap that is modified to the interior, how could I do that to mine, do I have to buy it that way somewhere or do I have to take it off and paint it that way? and if so what paint do i use because the ones i looked at didn't look like vinyl they looked like plastic, I have no idea! and also does anyone know how to get the grille off...they look like they come off but I don't know how, I wanted to put a mesh one in...and finally I need to know how to get the back speakers out...help!!