Sign In Join 

Chevrolet Lumina Maintenance and Repair

133 messages,  Last post on Sep 04, 2009 at 4:02 PM

You are in the Chevrolet Lumina Forum. Your Hosts are pat & karens

What is this discussion about? Chevrolet Lumina, Sedan


Messages Page 9 of 14
1
...
6
7
8
9
10
11
12
...
14
Prev
Next
Last
Go To Msg #
Search This Discussion

#80 of 133
Re: Bad Transmission [niso30091] and Code 42 [wzbzjmn] by masterson89
Aug 05, 2008 (1:29 pm)
Reply

Replying to: wzbzjmn (Jun 11, 2008 3:50 am)

if your cat needs to be replaced because it's rattling there is a good possibilty that your exhaust has excessive back pressure, which is hard to diagnose without running a back pressure test. your exhaust my seem fine, by listening and feeling but without doing a back pressure test u won't know. u should be n the area of around 2-6 psi backpressure much more than that will cause stalling and hesitation . if u have no access to back pressure testers you can remove your o2 sensor in front of the cat to let the exhaust escape or unbolt ur exhaust at the manafold. it'll be loud but if it runs better that was ur problem. also back pressure will cause the computer to belive that your other sensors mey be feeding fals info when really there fine, such as throttle position sensors, M.A.P. , M.A.S. O2. this will in turn cause erratic shifting of your tranny and also a huge loss of power and fuel economy. now after this is determind, u still have to know what caused your cat to be fried n the first place. don't replace it untill u fix the problem or u'll fry your new one .check out that EST problem that can casue rich fuel mixtures that will fry ur cat. also engine coolant will fry a cat in minutes. if you have had head gasket problems of allowed coolant into your combustion chamber that may have been your problem.never diagnose a bad tranny untill your engine is running good. hope i helped. good luck
#81 of 133
94 lumina euro radiator fill procedure by mattchuu
Aug 11, 2008 (7:56 pm)
Reply
at a gas station my bottom radiator hose got a hole so i replaced it and filled the radiator back up with coolant. there was a sticker in the engine compartment saying that there is a certain way to fill the radiator back up it said to refer to my owners manual for instructions. but it didn't give me a procedure to follow just info about how to mix the coolant and water. so i just filled it normally and now the low coolant light keeps coming on but radiator is full and the over flow tank is full. so dose anyone know the proper procedure?
#82 of 133
Re: Bad Transmission [niso30091] and Code 42 [wzbzjmn] [masterson89] by luminaguy93
Aug 12, 2008 (7:44 am)
Reply

Replying to: masterson89 (Aug 05, 2008 1:29 pm)

Yes you have help alot now i know where to start, i have worked on lots of car but most of the problems have been simple, altenator, starter, ect thanks for your time
#83 of 133
Re: 94 lumina euro radiator fill procedure [mattchuu] by luminaguy93
Aug 12, 2008 (7:48 am)
Reply

Replying to: mattchuu (Aug 11, 2008 7:56 pm)

It is possable that the sencer is bad that tells the computer that you are low, another think may be there is a bubble around the sencer, my low coolent light recently came on and i checked my coolent lvls and they were full so i started it back up and drove down a really bumpy road and about 5 minuets later the light turned off, try that first and then check the sencer.
#84 of 133
lumina transmission problems by brian78
Aug 18, 2008 (4:46 pm)
Reply
My 2000 chevy lumina with 151400 miles jerks when shifted in to gear. It also jerks hard when shifting 1/2 the time through all gears. I can hear it whine most of the time as well. I have just bought the car from a dealer "as is" and they wont help me at all. What is the problem? And do I need it fixed imedently? The problem is no worse or better than when I bought it about 1000 miles ago.
#85 of 133
lumnia transmission problems by brian78
Aug 18, 2008 (4:49 pm)
Reply
My 2000 chevy lumina with 151400 miles jerks when shifted in to gear. It also jerks hard when shifting 1/2 the time through all gears. I can hear it whine most of the time as well. I have just bought the car from a dealer "as is" and they wont help me at all. What is the problem? And do I need it fixed imedently? The problem is no worse or better than when I bought it about 1000 miles ago.
#86 of 133
Car cutting of while driving by tagregory
Aug 29, 2008 (5:28 pm)
Reply
I have a 1999 Chevy Lumina with over 200,000 miles. It will cut off while I am driving. The word VOLTS and picture of oil can will light up.
Sometimes I will feel the car jerk so I will ease off of the gas pedal and it won't cut off. The fuel line was repaired about a month ago and the mechanic recommended replacing spark plugs and wiring. Any ideas as to what the problem could be? Thanks.
#87 of 133
Re: lumnia transmission problems [brian78] by woodyone
Aug 30, 2008 (3:51 pm)
Reply

Replying to: brian78 (Aug 18, 2008 4:49 pm)

I have a 2000 Lumina. It also will whine at times and jerk when shifting. It is related to the transmission. Check the level of fluid. I have put an additive in the transmission fluid which thickens the fluid. It has helped my Lumina. It could be more trouble in your case but I chose the least expensive treatment first.
#88 of 133
96 Lumina Coolant Leak by hjcfz
Sep 10, 2008 (7:29 pm)
Reply
Leaking coolant from right hand side of motor(belt side) close to bottom of motor where all the pulleys bolt onto block appears to be some gasket top to bottom of the motor and my leak is near where the oilpan bolts to block, any ideas what this gasket is called, the water pump and Ac appears to be bolted to this plate.
 
hjc
#89 of 133
1996 lumina by bob1953
Sep 13, 2008 (7:28 pm)
Reply
the other day my wife's car over heated she pulled over and called me .It was about 1gal.low on antifreeze i filled it .drove home aprox.,15 mi. sat in garage all night no leaks.next day heated up again this time only about 1 qt.low today I got a chance to check it out.
has 3.1 engine
no antifreeze in oil.
white smoke coming from exhaust
is this a head gasket
i would like a second option before I tear into it
thanks

Messages Page 9 of 14
1
...
6
7
8
9
10
11
12
...
14
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?
Connect with Facebook Sign In Using Your Facebook AccountNew!

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement