- #835 of 1283
-
Re: 46re trouble [xscooba]
by dustyk
-
Feb 08, 2009 (12:18 pm)
-
|
|
Replying to: xscooba (Feb 08, 2009 12:03 pm)
Check the operation of the Transmission Throttle Valve and cable at both ends for binding. The Throttle Valve Lever on the tranny should return all the way when the Throttle Valve in the Throttlebody on the engine is in the idle position. Check for a missing or broken return spring.
Are you having trouble removing park rod or the manual lever? There's an E-clip on the end of the park rod. You need to rotate the valve body in order to release the rod. The manual lever shaft simply pulls through the case.
Regards,
Dusty
|
- #836 of 1283
-
Re: 46re trouble [dustyk]
by xscooba
-
Feb 08, 2009 (12:40 pm)
-
|
|
Replying to: dustyk (Feb 08, 2009 12:18 pm)
there is a linkage on the outside of tranny above throttle body where the return spring is and it holds up the valve body when trying to remove.
|
- #837 of 1283
-
46re front band repiacement
by xscooba
-
Feb 08, 2009 (1:24 pm)
-
|
|
|
- #838 of 1283
-
46re front band replacement
by xscooba
-
Feb 08, 2009 (1:25 pm)
-
|
|
can the front band be replaced without dropping tranny?
|
- #839 of 1283
-
1997 Trans stall
by stemper57301
-
Feb 08, 2009 (4:14 pm)
-
|
Hello,
I have a 1997 dodge ram 1500 with the 360 in it. I'm not sure of the trans. 46 or 47. My problem is that once in a while, mainly when its cold or wet, it will almost seem like it's slipping. Also along with this problem it stalls in drive and shakes like it wants to die. If I shift into 2nd it works no problems. There is a check engine code for low output speed sensor, I replaced the output speed sensor on the trans and it did nothing.Light is still there Any help or ideas are greatly appreciated.
Thanks
|
- #840 of 1283
-
transmission dodge ram 1500
by jeriz
-
Feb 09, 2009 (9:06 am)
-
|
|
my husband has a 1500 dge ram 1998 p/u. It is in the trans shop for repair. They said that the transmission cooler failed and it let transmission fluid into the radiator and anti freeze into the transmission - is this possible. They are saying to repair could cost up to 2,900.00. Does this seem right? Once the truck gets hot it won't go into gear except for reverse. Once it cools down it does go into gear. Thanks,
|
- #841 of 1283
-
1996 5.9L 4X4 - Trans won't shift/engine just revs
by jrthomas81
-
Feb 09, 2009 (1:55 pm)
-
|
HELP! I have an issue with my father-in-laws truck. I borrowed it to tow my camper (6000lbs) and had a trans line blow on my way home. I replaced the line on the side of the road and could only get my hands on about 75-80% of dex-4 trans fluid. I had to use about 2-3 qts of type F crap to get the truck home. The truck was been sitiing for about a week or so before I could get it to a trans shop. Now it won't move or if it does, it crawls and revs motor. Any advice? I know the trans was HOT when the line blew, but it drove home with no issue once the line was fixed. Should I drop the pan and change the filter? Is it ok to blow the remaining fluid out of the aux cooler with compressed air so I can assure that there is no type F in the trans when I start filling it back up?
|
- #842 of 1283
-
Customer No Service - Dodge Transmission
by frustrated2500
-
Feb 09, 2009 (6:21 pm)
-
|
Have I got one for everyone - I have a 2006 2500 Diesel with 35Ks and I am having to replace my transmission! Because it is 5 months past the 3 year (obviously not the 100K) they will not stand by their product. Any suggestions or has anyone else had issues with their transmission with so few miles?
|
- #843 of 1283
-
Re: -06 Ram also no overdrive? [makinja]
by wsswv
-
Feb 11, 2009 (9:56 am)
-
|
|
Replying to: makinja (Nov 08, 2008 11:34 pm)
I have an 02 with same cause and problem. I replaced the od solenoid and tps still nothing, I being told to rebuild or replace the od unit. Also having same problem as pontiacfb69 with p poor cold running. If you find out anything please let me know. Thanks, wsswv
|
- #844 of 1283
-
Re: Transmission problem related to PCM? [skkat]
by akkiller
-
Feb 11, 2009 (8:10 pm)
-
|
|
Replying to: skkat (Nov 08, 2006 9:14 am)
no it does not need PCM .first 3 gears are manual only over drive uses electronics sounds like the governer could be stuck or they left a check ball out of the valve body could be a few things PCM is not one
|