You are here: Forums Pickups Dodge Ram Dodge Ram Transmission Problems

Dodge Ram Transmission Problems

1274 messages,  Last post on Nov 21, 2009 at 4:42 AM

You are in the Dodge Ram Forum. Your Host is kcram

What is this discussion about? Dodge Ram Pickup 1500, Dodge Ram Pickup 2500, Dodge Ram Pickup 3500, Transmission, Truck

Messages Page 81 of 128 1 ... 78 79 80 81 82 83 84 ... 128 Prev Next Last

Go To Msg # Search This Discussion

#797 of 1274 Re: 02 2500 wont stay in lock up TC [git_r_done02] by git_r_done02 Jan 06, 2009 (7:22 pm)
Replying to: git_r_done02 (Jan 04, 2009 6:09 pm) Ok man, got the tranny fixed! Thanks for the info on what to try. You will never believe what was causing the problems. I went around to a couple of more rtanny shops and the last one told me to check the battery terminals to make sure its making a good connection, if that doesn't fix check the wire loom going to the tranny from the alternator and that doesn't work its the TPS. So i went home we cleaned the battery terminals and tightened them up and now the tranny works like brand new. Its the craziest thing I've ever heard of but it worked. And whats bad is the terminals weren't gunked up or anything. So anyone else having shifting problems and can't figure it out, check those battery cables!                                                                                 Thanks again dustyk
#798 of 1274 Manual - finally! by FlyDay Jan 07, 2009 (6:03 pm)
http://dodgeforum.com/forum/2nd-gen-ram/41924-merry-christmas-guys.html   Found a complete shop manual here, almost 60 MB. It's for 2001's but alot of the info applies to years around there.
#799 of 1274 Noise from Ram 2500 5 speed manual trans by silverado65 Jan 08, 2009 (4:27 pm)
I have a 98 Ram 2500 with Cummins engine and 5 speed manual transmission. When the temperature is cold outside, I hear a "squishing" noise coming from the transmission when I start out. It sounds like oil being forced out through the gears. This only happens when it is cold and when you first start out, at less than 10 mph. Once it is driven a block or so the noise goes away. I have changed the transmission oil and still have same problem. The clutch was replaced about 5000 miles ago. This is a recent problem, within the last couple of weeks. Any ideas?
#800 of 1274 overdrive kicking in and out by waynek5 Jan 10, 2009 (8:37 am)
I have a 2001 ram 1500,occasionaly the transmission will stutter while in overdrive.I have 65k on the truck.Could it need a new filter? Adjustment?    Any ideas would be appreciated.         Wayne K Replies to this message: dustyk (Jan 10, 2009 10:45 am)
#801 of 1274 Re: [fuddodge] by dustyk Jan 10, 2009 (10:40 am)
Replying to: fuddodge (Jan 05, 2009 5:17 pm) Assuming you've checked the fluid level, my guess is the transmission is losing hydraulic pressure, possibly from a clogged transmission filter, transmission cooling lines or anti-drain back valve, or you are losing the transmission pump, or you've got a valve body malfunction.   Regards, Dusty
#802 of 1274 Re: overdrive kicking in and out [waynek5] by dustyk Jan 10, 2009 (10:45 am)
Replying to: waynek5 (Jan 10, 2009 8:37 am) If you have a V8, you've got a 46RE transmission.   At 65,000 miles you should've had at least one transmission maintenance (filter and fluid), and I would have recommended the bands be checked and adjusted.   If you've got torque converter chatter, a transmission filter and complete fluid change may resolve this issue. If this problem is accompanied by and or manifests itself as the torque converter coming in and out constantly, I would suspect a bad Throttle Position Sensor, especially because of the year and miles.   Regards, Dusty
#803 of 1274 Stupid Trannie by MikaybiZ Jan 10, 2009 (11:31 am)
Hi, I am new to this forum and I was reading a few of the posts. I own a 2000 dodge ram 1500 5.9L gas 360. Anyway I just had the transmission replaced, however I think the repairman put the wrong one back in. The paperwork says it is an A618 or a 47RE, from what I have read so far I should have the 46RE, the 47RE was for the 5.9L cummins and the 8.0L V-10. Is this a big concern or will the transmission be okay. The only reason I ask is that I now have a check engine light with the code of P1740 something to do with the TCC or OD solenoid. Anybody have any words of wisdom. Replies to this message: dustyk (Jan 11, 2009 12:42 pm) MikaybiZ (Jan 11, 2009 2:25 pm) dustyk (Jan 17, 2009 11:31 am) and 1 more...
#804 of 1274 Re: Stupid Trannie [MikaybiZ] by dustyk Jan 11, 2009 (12:42 pm)
Replying to: MikaybiZ (Jan 10, 2009 11:31 am) Hmmm. Well, yes, a A618 is the previous nomenclature for the 47RH, and the basis for the 47RE. You are correct that the 47RE was used on the V-10 and earlier Cummins motors. A 47RE is essentially the same as a 46RE, but uses additional clutches and has extra pinions in the planetary gearsets. It is a heavier version of a 46RE, if you will.   Can a A-618/47RE bolt up to your 2000 360 motor. Yes. Is there a problem with this? Not in my opinion. I'm guessing that who ever did the work for you did not rebuild or work on the original transmission, but bought an off-the-shelf rebuilt from a supplier. If so, the supplier is probably hedging for the sake of warranty coverage knowing that truck trannies often get abused and poorly cared for and a stronger version would hold up better, or at least that's their theory. Since the difference between rebuilding a 46RE and a 47RE is rather minuscule, it logically provides an increased cost/benefit ratio for the supplier.   I'll have to check, but it is possible that a 47RE was available as an option for the 360, and maybe even the 318 in those years.   By any chance is this a 4x4 RAM?   Regards, Dusty Replies to this message: MikaybiZ (Jan 11, 2009 2:25 pm) dustyk (Jan 17, 2009 11:31 am) MikaybiZ (Jan 17, 2009 6:17 pm)
#805 of 1274 Re: 1998 RAM 24 valve won't stay in lock-up [Newtomopar] by rrhnz1 Jan 11, 2009 (1:13 pm)
Replying to: Newtomopar (Jan 05, 2009 6:40 pm) suggest you look at you belts, had similar problems that turned out to be idler pulley bearings was bad allowing the belt to slip when electrical load caused by AC Replies to this message: Newtomopar (Jan 18, 2009 6:44 pm) 99dodge1 (Jan 25, 2009 6:30 am)
#806 of 1274 Re: Stupid Trannie [dustyk] by MikaybiZ Jan 11, 2009 (2:25 pm)
Replying to: dustyk (Jan 11, 2009 12:42 pm) As a matter of fact it is, the odd thing is I had this trannie replaced in Utah in October and the drove to Alabama at the beginning of November without a problem. It wasn't until recently that it started acting up. The most notable problem has been it shifting itself out of overdrive and not letting me put back into overdrive. Even with the check engine light it seems to be driving okay, I would rather not press my luck and be stuck somewhere. Also has anybody had any problems with their dashboard basically fall apart? If so what can I do? I it a pain to replace by myself? I'm not Mr. Goodwrench by any means but I can do some basic stuff. By the way thanks for your help Dusty.   Mike Replies to this message: dustyk (Jan 17, 2009 11:31 am) MikaybiZ (Jan 17, 2009 6:17 pm)

Messages Page 81 of 128 1 ... 78 79 80 81 82 83 84 ... 128 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Dodge Ram Dodge Ram Transmission Problems