Sign In Join 



Dodge Ram Transmission Problems

1258 messages,  Last post on Nov 10, 2009 at 11:21 AM

You are in the Dodge Ram Forum. Your Host is kcram

What is this discussion about? Dodge Ram Pickup 1500, Dodge Ram Pickup 2500, Dodge Ram Pickup 3500, Transmission, Truck


Messages Page 27 of 127
1
...
24
25
26
27
28
29
30
...
127
Prev
Next
Last
Go To Msg #
Search This Discussion

#255 of 1258
Tranny #2 problems by kcndd
Oct 18, 2007 (8:21 am)
Reply
Got an '06 2500 d-sel 4x4. With 88K on the odom we are having tons of transmission problems. (Bought October of 07)Local dealer replaced 1st unit due to slipping & said clutches were fused. 2nd unit started slipping after about 20K miles on it. Seems to me it may be a heat issue as it doesn't slip nearly as much when transmission is cold. We haul campers 3x times a week ranging in weight 4,000 - 12,000 lbs each thru West Virginia mountains. Dealer isn't sure what to do next. They want to replace valve body. Anybody out there had similar problems? Can't get much info from Chrysler about any transmission problems/service notices. HELP
#256 of 1258
Transmission slipping? by joemc1
Oct 20, 2007 (5:14 am)
Reply
I have a '95 Dodge 2500 w/ Cummins and 196k on the odometer.At 160,000 my tranny started to shift/fluctuate 200-300 rpms at highway speed55-75mph.This is an intermittent problem I have no symptom or warning when it is going to happen I took it to the Dodge dealer and they replaced it with a reman ($2500.00). The warranty was 3yrs/36,000 for the reman. Well at 35,400 and 4 years and 196k the same condition returned. I took it to a highly recommended tranny shop and they rebuilt it ($2400.00). I left for Florida, not towing,got two hundred miles away from home and the same situation occurred.Turned around took it back they went through it checking soleniods etc.I took it back, drove around for a week, planned to leave for FL (1280miles)on Sunday 10/21 when lo and behold on 10/19 I am traveling down the Interstate and the same conditon occurs!
It shifts and runs well in all gears but at highway speeds it seem to slip in and out of overdrive. I'm so disgusted right now that I'm thinking of going to FL anyway. I will be towing 8k on the way back. I'm thinking throttle position sensor. Am I correct?
#257 of 1258
Re: 2nd gear start at operating temp [dustyk] by wolfer3
Oct 20, 2007 (6:04 am)
Reply

Replying to: dustyk (Aug 23, 2007 4:57 pm)

Hi,
 
 Well I finally got around to changing the governor pressure solenoid and governor pressure sensor. Works like a charm now. YAY! If I had to point the finger at one component I would blame it on the bracket thats holds the sensor in place. The senor was VERY loose because the bracket wasn't holding it tightly in place. When I replaced the sensor the new one was loose also. I slightly bent the tabs in and now the sensor doesn't move. Thanks, Wolfer
#258 of 1258
Re: Transmission slipping? [joemc1] by kcram HOST
Oct 20, 2007 (1:43 pm)
Reply

Replying to: joemc1 (Oct 20, 2007 5:14 am)

I'm assuming you got a new torque converter each time with the reman and rebuild. Your symptoms sound a lot like the TC having problems staying locked in the upper gears (it only locks in 3 and 4). Yes, the TPS can affect that and would be the first thing to check - if that doesn't solve the problem, I'd want the TC looked at as well after spending all that $$.
 
kcram - Pickups Host
#259 of 1258
1999 Ram 1500.. Won't shift into second gear!! Help! by tincup72
Oct 26, 2007 (11:06 am)
Reply
I have a 1999 Ram 1500 with a 360, automatic transmission and the tow package. The truck has 125,000 miles on it with the original tranny. Here is my problem. About two weeks ago I got a check engine light. This was followed by a very slight transmission slippage. Sometimes it was from a dead stop, but if I babied the throttle it would take right off. A good friend of mine recommended that I disconnect the battery to clear the engine light. He felt the light was most likely an O2 sensor. This worked for about a day and the light came back. Two days ago the truck would start out fine in 1st gear, but would struggle with shifting into 2nd gear. The shift would occur around 3000 rpm with it then shifting through all the gears. No problem with reverse. The problem seemed to be worse on colder days. Today, though, it will not shift into 2nd gear at all no matter how high the rpm's. When I hit 25-30mph and let up of off the throttle I can feel it shift all the way into high gear. When I step back on the gas it is slipping as if the gear is to high for the vehicle speed. If I let it coast, it downshifts very smoothly through all the gears. Once it is in 1st gear it takes right off again, but still will not shift into 2nd gear. I flushed and changed fluid and filter. The pan was void of any metal and the pan magnet had a slight amount of sludge on it. This, unfortunately, did not fix the problem.
 
I am going to take it to a parts store and have them run a diagnostic on it. Is there a specific analyzer they must use for this year and model? I am not convinced this is a mechanical problem with the transmission, but an electrical control problem. What types of things should I be looking at? From reading through this thread I feel my problem may be as simple as a throttle position sensor. Please Help. I'm desperate. I fear that a tranmission mechanic will recommend replacing the transmission as "cover-all" solution to this problem. Any help is greatly appreciated.
#260 of 1258
Re: 1999 Ram 1500.. Won't shift into second gear!! Help! [tincup72] by danv1
Oct 26, 2007 (12:50 pm)
Reply

Replying to: tincup72 (Oct 26, 2007 11:06 am)

My '99 did a similar thing (erratic shifting, check engine light, etc..). Took it to Autozone and the put a code reader on it free of charge. It was the speed control sensor. It is located on the driver's side of the tranny. If that is the problem, I recall it being less than $20 and ten minutes to replace. Just make sure to check and re-tighten after a day or so, as it will back out a little from the heat. Good luck.
#261 of 1258
98 3500 4x4 won't go into gear by alanbell
Oct 28, 2007 (5:16 am)
Reply
Having a hard time getting my manual tranny into gear. Also, have no 4x4, cruise, and the A/C vent is on defrost. Any suggestions and approx. how much will it cost to remedy?
#262 of 1258
Re: 1999 Ram 1500.. Won't shift into second gear!! Help! [tincup72] by rambo57
Oct 28, 2007 (6:41 am)
Reply

Replying to: tincup72 (Oct 26, 2007 11:06 am)

My transmissions has the same symptoms and has for about a year. Last December the local maintenance shop recommended I put in a new transmission but I was determined it wasn't mechanical. It seems that after they connected diagnostics to it last December, it shifted fine for the next several months. Electrical connections possibly? After several months it started having trouble shifting from 2nd to 3rd again and I continued to baby it until recently when my check engine light came on. I took it in and it indicated it was the speed control sensor. They replaced this and I had my hopes up that this was going to resolve my problem but my shifting problems remain. It did seem to help though....
 
My problems seem to get worse as the transmission gets warm. It shifts fine for the first 10 - 15 miles of stop and go. I'm going to attempt to replace the throttle position sensor next. If you have any success with your transmission, please let me know since it sounds we have the exact same problem. I'll do the same...
 
Good Luck and Thanks!
#263 of 1258
Re: 98 3500 4x4 won't go into gear [alanbell] by alanbell
Oct 29, 2007 (8:46 am)
Reply

Replying to: alanbell (Oct 28, 2007 5:16 am)

Just wanted to add that the problem I have is from a stand still. It shifts when moving but that is getting a bit harder to do. I have been down shifting as I come to a stop and leaving it in gear when I park to avoid the issue. I think it will shift through the gears when the engine is turned off (at least it did the other day) with no problem. Alan
#264 of 1258
Dodge Ram Auto Trans Overdrive Slipping? by davelyon
Nov 01, 2007 (7:42 am)
Reply
My 1998 Dodge Ram 1500 (5.2 liter, 46RE Auto trans) is slipping in overdrive. When I let my foot off the gas and coast, then put step on it again (gently) the engine revs will climb 500-600 rpms then settle down to a constant mark. It will also do this with the cruise control on, so it's not just me. If I turn off the OD the trans shifts great. The truck only has 65k miles (verified!).The tranny shop says it needs to be rebuilt (of course!) but is there a way to adjust the electronic OD? Is there a solenoid or some other electronic part I can replace before I spend $2000 on a new tranny?

Messages Page 27 of 127
1
...
24
25
26
27
28
29
30
...
127
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement