Sign In Join 



Dodge Ram Transmission Problems

1258 messages,  Last post on Nov 10, 2009 at 11:21 AM

You are in the Dodge Ram Forum. Your Host is kcram

What is this discussion about? Dodge Ram Pickup 1500, Dodge Ram Pickup 2500, Dodge Ram Pickup 3500, Transmission, Truck


Messages Page 23 of 126
1
...
20
21
22
23
24
25
26
...
126
Prev
Next
Last
Go To Msg #
Search This Discussion

#220 of 1258
Re: 2nd gear start at operating temp [dustyk] by wolfer3
Aug 26, 2007 (12:26 pm)
Reply

Replying to: dustyk (Aug 23, 2007 4:57 pm)

Hi,
 
 The transmission has 98,000 miles on it. When I changed the oil it was a little dark, but not for 98,000 miles I suppose. There was very light fuzz on the magnet and no metal of any size anywhere in the pan. The transmission has been malfunctioning for about 2 months now. I just manually shift into first anytime I stop and all is good. Line pressure is 56 psi(0 throttle) to 92 psi (tv wide open). 7 psi at 0 mph in drive is not normal I know. I'm thinking governor pressure sensor, governor pressure solenoid, or PCM. If anyone has the proper voltages for the sensor and solenoid to the PCM it would sure help me isolate the problem. The only reference voltages I have are for a 42RE.
Thanks, Wolfer
#221 of 1258
Re: trans trouble [dusty] by ksey
Aug 27, 2007 (1:28 pm)
Reply

Replying to: ksey (Aug 24, 2007 10:37 am)

Dusty the hold is make that way it just look like it's closed. is the tcm part of the pcm will it keep me from get codes
#222 of 1258
Wedge-shaped piece of metal in the transmission fluid pan by abboq1
Aug 30, 2007 (11:47 am)
Reply
Hello,
 
Thank you in advance for any help you can provide. I have a 1995 Dodge Ram with a 360 and an automatic.
 
Two separate issues affect it:
 
1. Last time I changed the fluid and filter, I found a wedge-shaped piece of metal laying in the pan. It had a notch on one end. Can anyone tell me what this is, and how missing it will affect the transmission?
 
2. Recently, the transmission would not shift from first to second. I was told that the throttle position sensor may be faulty. After removing the throttle position cable from the linkage on the throttle body, the transmission would shift through all of the gears.
 
Thank you again for any insights you can provide. ~Joel (abboq1)
#223 of 1258
Re: Wedge-shaped piece of metal in the transmission fluid pan [abboq1] by ksey
Aug 30, 2007 (3:24 pm)
Reply

Replying to: abboq1 (Aug 30, 2007 11:47 am)

The wedge-shaped is off the front band adjustment with out it you don't have 2nd
#224 of 1258
hard shift 1st to 2nd & speedometer reading by jdunigan
Sep 01, 2007 (3:24 pm)
Reply
I have a 98 Ram 1500 2wd with automatic transmssion. There are about 130K miles on the truck and the transmission has had regular fluid and filter change. When the check engine light came on some time ago, the mechanic who read the code said it was the sensor that tells the speedometer what speed the truck is going. I didn't repair it. All was well until yesterday when the truck wouldn't shift from 1st to 2nd until it reached a speed of about 35 or 40 mph. I then noticed that when starting out from a dead stop, the speedometer needle didn't move until about the same time the transmission shifted when it would jump to 35 or 40 mph or so. To complicate things, sometimes both speedometer and transmission work normally. Any idea what;s wrong and how to fix it?
#225 of 1258
Re: hard shift 1st to 2nd & speedometer reading [jdunigan] by dustyk
Sep 01, 2007 (9:35 pm)
Reply

Replying to: jdunigan (Sep 01, 2007 3:24 pm)

The prime suspect is likely a defective Vehicle Speed Sensor, also known as a Rear Wheel Speed Sensor, or the associated wiring going to it. This sensor is located on the rear differential housing and is easily replaced from the outside of the differential housing.
 
Regards,
Dusty
#226 of 1258
Re: hard shift 1st to 2nd & speedometer reading [dustyk] by jdunigan
Sep 03, 2007 (4:03 am)
Reply

Replying to: dustyk (Sep 01, 2007 9:35 pm)

Thanks, I'll try that tomorrow.
#227 of 1258
1997 Ram 1500 4x4 goes to neutral by tubugs
Sep 04, 2007 (6:21 pm)
Reply
I have a 1997 Ram 1500 that starts and drives fine but after 10 minutes goes to neutral. If I stop the car shut it of and restart I can drive a few miles. The in goes to neutral again. I stop and restart again and all is fine again.
 
I drove 30 miles today and just made it home.
 
Any Ideas. I just bought it a week ago.
#228 of 1258
Re: 1997 Ram 1500 4x4 goes to neutral [tubugs] by dustyk
Sep 05, 2007 (2:32 pm)
Reply

Replying to: tubugs (Sep 04, 2007 6:21 pm)

Have you checked the transmission fluid level?
 
How many miles?
 
What is the transmission maintenance and service history?
 
Regards,
Dusty
#229 of 1258
01 ram 2500 1st gear troubles by rickthehick
Sep 05, 2007 (3:14 pm)
Reply
so heres the deal, and i'm hoping someone out there has a real simple fix. i have a 01 ram 2500 diesel with 140,000 on it. and probly with in the past week it has not wanted to shift from first to second gear unless i really rev the engine. then it shifts fine for the rest. once warmed up it refuses to shift down to first at all when copletely stoped unless i manually put it there. its a 47re trans i believe. and keep in mind that i've never had to change or add any fluid to it. i've checked it everytime i changed the oil and it was always full and nice and clean. also, just for the heck of it i did change the fluid and filter and still its no better. any ideas would be greatly appreciated. oh, and just so you know, i'm no tranny guy, so when it comes to line pressures and that kinda stuff, i have no clue.

Messages Page 23 of 126
1
...
20
21
22
23
24
25
26
...
126
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement