Sign In Join 



Dodge Ram Transmission Problems

1279 messages,  Last post on Nov 25, 2009 at 4:21 PM

You are in the Dodge Ram Forum. Your Host is kcram

What is this discussion about? Dodge Ram Pickup 1500, Dodge Ram Pickup 2500, Dodge Ram Pickup 3500, Transmission, Truck


Messages Page 123 of 129
1
...
120
121
122
123
124
125
126
...
129
Prev
Next
Last
Go To Msg #
Search This Discussion

#1215 of 1279
Tranny Woes by thordude
Oct 06, 2009 (10:18 am)
Reply
hey Guys, I've got a real problem with my truck. Here goes..I have a '03 3500 4x4 that I purchased for my hotshot company. I bought the truck used in '07 with 25,000 miles. Thinking that this unit was almost new. At 75,000 miles the original 5 spd manual tranny gave up on me. Chewing both upper shaft and lower shaft front gear teeth. Really ugly inside. Okay, had Dodge replace with new, 13,000 miles later...same thing. I had that tranny rebuilt, Dodge would not warranty the 2nd. Two months later, I lost 5th in Louisiana and then drove it home. Okay, I heard the NV5600 6spd is good for a 2 ton truck. So, $5,500.00 later the truck was converted to the 6spd. That lasted, 1 month and now has the 6th tranny in the truck. At this time, I am now starting to have problems with the truck again. I quit my business due to repair cost. What the heck is going on !?! I can not find anybody who can tell me why this has happened to my truck...i.e. me. Can you help? Thanks
#1216 of 1279
Tranny Woes #2 by thordude
Oct 06, 2009 (10:49 am)
Reply
I bet one of your questions is what are you pulling? My trailer is 40ft x 102" dove tail, goose neck hitch. The trailer weighs around 8100 lbs. The load weights varied with the average around 10,000lbs. Now, I bet you're going to say that the truck is at its limit for weight...explain to me, why are there trucks here that pull a 32' cattle trailer, 7 days a week, fully loaded running up and down the road as fast as they can pull and not having problems?
#1218 of 1279
tranny slips out of gear by tboshart
Oct 07, 2009 (9:05 am)
Reply
i have a2000 Ram 1500 , going down the road 55-60 the tranny slips out and acts like its in low gear any thoughts whats going on
#1219 of 1279
any clue? by flyinshu
Oct 08, 2009 (5:46 pm)
Reply
I have a 2008 ram 1500 with the m/d hemi...not sure of the tranny model, but it is an automatic. the problem I am having is every once in a while, I will lose overdrive, when I stop and try to go...the tranny slips. If I shift from reverse and back to drive...no fix. the only way to fix it is to shut off the engine and restart. then everything works fine again. I even tried shifting through the tow/haul and overdrive off selection, but the only fix is a restart. could not get any codes from my code reader...ideas?
#1220 of 1279
1500 ram ,stalling motor by is72
Oct 08, 2009 (6:36 pm)
Reply
I purchased my 01 ram 1500- (5.9) 4x4 /125000 , about 4weeks ago,it drove fine at fisrt, but then it started to slip,from 1 to 2. i did check the fluid and i was low, so i filled it with atf+4,did not fix the problem,so i dropped the pan and change the filter and fluid atf+4,that did not fix the problem and on top of that i got a ( trans temp ) light on the dash,i trew some lucas in it, and now every time i shitf in gear drive or reverse it kill the motor,to the point that its not driveble, did I mess my trans up???? any comments
#1221 of 1279
transimission by bossier
Oct 09, 2009 (12:40 pm)
Reply
1996 Dodge 135000 miles, with what dealer says is a 46RE transimission. System leaking substanically through bell housing. Removed trans. & I am having problems removing torgue converter. Looking for suggestions on how to do this with out cracking housing. Also should I just change front seal or completely break down trans. ?
#1222 of 1279
1998 Dodge Ram 1500 Tranny Problem by helphelphelp
Oct 11, 2009 (4:34 am)
Reply
I have a 1998 Dosde Ram 1500, V6fine into higher gears Magnum with 227,000 miles on it I just purchased. Seller said tranny was rebuilt prior to sale. Truck had slite hesitation from 1st to 2nd gear but drove fine into higher gears or when accelerated. Today I was driving at 45 mph when the vehicle totally went out of gear and either would not shift into gear or stay in gear. Very weak reverse to no reverse too. Fluid was clean and full. No leaks. Was told might be the torque converter, not by a mechanic. Truck makes a whining sound when shifted into a gear. Seller also removed the OD Shifter and put in a regular shifter, truck is automatic. He said it just need to be plugged back in, thought that was odd. Is this a difficult fix if it is the torque converter and will this solve the problem if the tranny is screwed. Not sure of the maintenance or fluid type used. THANK YOU FOR ANY HELP!!
#1223 of 1279
Re: 2000 Ram 1500 w/5.9 95,000 miles won't shift [pdrconst] by is72
Oct 12, 2009 (4:06 pm)
Reply

Replying to: pdrconst (Nov 29, 2007 12:54 am)

use only atf+4 ,using dex-merc will kill trans.
#1224 of 1279
trans problem by cooky134
Oct 13, 2009 (2:44 pm)
Reply
2001 ram 5.2 had the trans rebuilt works fine in town ,but when we take it out on the highway and stop it wont go back to first the engine light comes on we changed the sensers in the trans three times had the comp updated still wont work

Messages Page 123 of 129
1
...
120
121
122
123
124
125
126
...
129
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics
Advertisement