Last post on Apr 02, 2011 at 3:27 PM
You are in the Isuzu Rodeo
What is this discussion about?
Isuzu Rodeo, Truck
#6 of 13 Re: Program instructions for keyless remote [02rodeo]
Jul 03, 2008 (8:30 am)
On my 97:
1: turn ignition on ( don't start )
2: under driver's seat is the control box. To the rear of the box is a hole with a green button ( easier to see from rear passenger floor ). Depress this button with a screwdriver or similar tool until light on dash goes on, then release.
3: press button on remote, light should go out.
for more remotes, repeat from step #2
4: turn ignition off.
#7 of 13 Programming 2004 Huyndai Sonata keyless remote
Jan 13, 2009 (9:06 am)
I recently purchased (2) Hyundai Sonata keyless remotes. The numbers match up. Now I need to programm the remote for the vehicle. I have the basic instructions which requires me to access the "central locking signal control module" located behind the center "fascia". What specifically is the center fascia ? Is that the area below the steering column or is it located on one side or the other of the steering column ? If anyone that has any input concerning this, would appreciate the feedback.
#9 of 13 Re: Programming 2004 Huyndai Sonata keyless remote [danasal]
Feb 25, 2010 (12:18 pm)
I was wondering if you ever found this out I also have a 2004 Hynuadi sonata and trying to program remotes. Do you have instructions on how I cant find them..
#12 of 13 Romote Programming Mode
Feb 22, 2011 (3:24 pm)
I bought a 99 Rodeo LS and it did not have the remotes with it when I purchased it. I Believe it should have remotes since it has power locks, etc. But not sure. I did buy a fob and instructions and I have tried several times to get it into programming mode but when it is supposed to cycle the lock/unlock signifying it is in programming mode, it doesn't cycle the locks. Can anyone tell me how to tell if the car should have remote keyless entry and how to get it into programming mode. Or if some unit on the vehicle is out and I just have to replace it (and which unit that would be)
#13 of 13 Isuzu Rodeo remote program
Apr 02, 2011 (3:27 pm)
I have a 99 Isuzu Rodeo and followed the instructions to program my remote. I got to the programming mode, but when I click the lock/unlock on the transmitter, it does not respond. I have even replaced the transmitter batteries. Can anybody help? Thanks.