Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Sedans Toyota Camry Toyota Camry Fuse and Electrical Questions
874 messages, Last post on Dec 07, 2009 at 9:06 AM
You are in the Toyota Camry Forum. Your Hosts are pat & karens
|
Replying to: titus_pullo (Jul 07, 2009 8:03 am) 25A Door, is the 4th column over, the middle of 3 10A Gauge, is the 1st column, third up from the bottom 30A Power, is a big fuse off to the lower right. There are 3 bigger fuses in a column, it's the middle one.
|
|
|
|
|
Replying to: kiawah (Jul 07, 2009 9:33 am) You were absolutely positively 100% correct! As per my post #598, I did check all of the small fuses in the main fusebox. What I didn't check was that 30A Power one because of that small plastic hose in the way and due to the bad angle that fuse is in. Today, I immediately went to that fuse and guess what.....it was blown. I temporarily replaced it with a 40A one from the top.....and the windows started working again. In your post #599.......your last sentence was absolutely on the money. To make this a permanent fix, I will make sure to repair those exposed wires. I am so glad I was able to come across this forum. I tried so many different forums with no luck. Thank you Kiawah for your kind help in resolving my issue.
|
|
|
Replying to: titus_pullo (Jul 08, 2009 6:55 pm) I've only done a rewire job once on an old vette I used to own many years ago where I had this problem. It's just a very tedious job cutting and soldering wires. Be sure to use stranded wire as a replacement, and I'd suggest taking the door panel off so that the new wire extends from inside the door, thru the flexing area, and then over to where it's past the flexing point in the dash area. If you use solid core wire, it will soon break, as solid wire can't stand the flexing like stranded wire can. Good luck.
|
|
|
|
|
Replying to: kiawah (Jul 08, 2009 10:31 pm) |
|
|
|
can anyone help? I don't have any tail lights, the bulbs and fuses are ok and they do turn on when i hit the brake pedal its just that at night i don't have any tail lights except side lights.
|
|
|
Replying to: berthag2730 (Jul 12, 2009 12:45 pm) |
|
I am looking for advice on how to fix the power to the power locks and windows on my 96 Camry. I have checked all the small fuses and they are good. Any suggestions would be appreciated.
|
|
|
Replying to: tim131 (Jul 13, 2009 2:40 pm)
|
|
|
Replying to: kiawah (Jul 13, 2009 2:51 pm)
|
|
|
Replying to: tim131 (Jul 13, 2009 4:02 pm) Pull the drivers door panel switch, check that you have power there.
|
|
You are here:
Forums
Sedans Toyota Camry Toyota Camry Fuse and Electrical Questions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Toyota Camry
Browse by Board
Browse by Topic
Today's Chats
