Last post on Aug 03, 2013 at 3:10 PM
You are in the Toyota Camry
What is this discussion about?
Toyota Camry, Electrical, Sedan
Go to NHTSA to file a safety complaint.
Or call Monday-Friday (8 am to 8 pm ET) (888) 327-4236 TTY: (800)424-9153
#300 of 1159 Re: 1996 Toyota Camry -changing tail lights [dorothy04]
Dec 31, 2007 (7:43 pm)
If you have the owner's manual, it will tell you (toward the back). Otherwise, you'll have to remove the trim inside the trunk to access the bulbs. There should be a kind of "trap door" for the outer bulbs (the ones not mounted on the trunk). Remove the door or trim, then twist the appropriate bulb socket one quarter turn counterclockwise, then pull straight out.
Then to remove the bulb itself, either twist slightly counterclockwise while pressing inward on the bulb, then pull straight out OR just pull straight out (I'm not sure what kind of socket the '96 model uses). Installation is the reverse. Try not to touch the new bulb with your bare hands -- use a cloth or tissue.
#301 of 1159 Re: Camry 03 Earth Wire connection [kiawah]
Dec 31, 2007 (10:09 pm)
I finally found a sheet metal screw behind a small plastic lid below and right to the steering wheel. It worked fine.
#302 of 1159 Frozen tape player
Jan 05, 2008 (10:30 pm)
03 Camry...While rewinding tape, suddenly system "froze". word "tape" shows on screen. No buttons work, not even on/off switch. System remains "on" even with engine turned off, dial remains lit showing "tape".
Went to dealer who had no time to diagnose but removed and replaced SAME fuse and everything worked normally once again.
Later tonight, I was fast forwarding and exact same thing has happened. I have not removed fuse.
Any ideas? Is it electrical? Is it the unit? Should I take it to the dealer? Should I take it to a radio shop?
Appreciate any advice, Thanks
#303 of 1159 2006 toyota camry electric window
Jan 06, 2008 (2:08 pm)
The right rear electric window went out on my 2006 Camry CE. I was going to try the obvious things like checking the fuse. Unfortunately, I can't make sense out of what the owners manual indicates for fuses. To make sure I had the right fuse, I pulled the fuse that said it was for the window on the left door. With the fuse out, that window still operates. I realize this is unrelated to my original problem, but it is hard to troubleshoot when you can't rely on the information you have. Anybody have a vowel I can buy?
#304 of 1159 Re: 2006 toyota camry electric window [krruss]
Jan 07, 2008 (7:08 am)
There's actually 3 fuses which feed different parts of the power window circuitry.
- 30 Amp Power#1
- 10 Amp ECU-B
- 10 Amp ECU-IG
Check your krrusscarspace.com email. Go to Mailbox tab in the grey bar upper right corner.
#305 of 1159 Re: 2006 toyota camry electric window [kiawah]
Jan 07, 2008 (9:21 am)
I know from removing it that the first fuse you listed (30 amp Power #1) controls all 4 windows plus the moonroof (if equipped). I had to do this to "initialize" the moonroof in my 2004 Camry (easier than disconnecting the battery).
#306 of 1159 2002 Toyota Camry Interior light fuse locations
Jan 13, 2008 (5:01 pm)
I have a 2002 Toyota Camry and the interior lights don't work. The overhead light, the door lights do not work. I checked most of the fuses and they were good. Is there anything else to check ? The overhead light bulb is good so it is not the bulb. Help please.......
#307 of 1159 Re: 2002 Toyota Camry Interior light fuse locations [arortiz]
by MrShift@Edmunds HOST
Jan 14, 2008 (11:45 am)
Must be the switch in the door/door jamb. If you can pry it out you can pull off the two wires and touch them together and see if the lights then work. That would by-pass the switch.
How did you test the fuse and the bulb? Visually is not good enough. You should use an ohm meter to test for continuity through the fuse or through the bulb.
#308 of 1159 96 Camry - All Door Locks and power windows do not work
Jan 27, 2008 (4:03 pm)
I have read all the previous posts regarding this particular problem. However, I believe mine is a bit more unique. I have replaced the fuse, and as soon as I turn the ignition switch to accessory, or on, I can watch the pink 30A fuse glow red, and then fail. Takes about 2 seconds. Further research, shows approx 12 volts on the 3 volt fuse when power is applied. I feel there is a short in the system, or a window that is stuck in the up position, but not sure how to begin troubleshooting the issue without taking off all the door panels and disconnecting the window motors on all 4 doors.
#309 of 1159 Re: 96 Camry - All Door Locks and power windows do not work [rviles]
Jan 27, 2008 (4:48 pm)
Which 30Amp fuse are you blowing, AM2?
If so, then AM2 feeds the keyswitch, and then feeds 2 downstream fused circuits:
- a 5 amp fuse for ignition coils
- a 5 amp fuse for starting circuit, feeds first a clutch switch, then starter relay, then starter primary.
If this AM2 fuse is blowing immediately, try pulling the two downstream 5 amp fuses (they are in the circuit AFTER the ignition switch). If it still immediately blows (which undoubtedly it will since the fuses downstream are only 5 amp each and would have blown), your ignition key switch is probably bad.