Last post on Aug 03, 2013 at 3:10 PM
You are in the Toyota Camry
What is this discussion about?
Toyota Camry, Electrical, Sedan
Go to NHTSA to file a safety complaint.
Or call Monday-Friday (8 am to 8 pm ET) (888) 327-4236 TTY: (800)424-9153
Nov 07, 2011 (8:38 am)
Most likely cause is the switch on the back of the transmission---could just be a loose wire.
#1134 of 1159 Re: Issue with Power Door, Window, Sunroof [kiawah]
Nov 14, 2011 (9:57 pm)
i have 1995 toyota camry and i can open all doors with the switch but i cant lock please help iam going crazy and sometime my reverse lights want to come on and sometimes they don't
#1135 of 1159 2007 camry inside wiring harness replacement
Nov 15, 2011 (10:13 am)
the wiring harness burned out. would the ECU need to be replaced and where is it. i had to replace the wiring harness inside the camry. first of all the battery doesnt stay charged, when i crank it it turns but it doesnt start. the wipers dont work nor the power windows to include the A/c. also i have to push down the over ride button to get the car to shift. i need help in figuring out the problems are. Can anyone help me. and thank you in advance.
#1136 of 1159 Re: 2001 Toyota Camry Relay Flasher [kiawah]
Nov 23, 2011 (8:44 am)
Hello, I have the same problem with my Camry 2001. Please send me the flasher1, flasher2, flasher3 pictures to prowebdevyahoo.com Thank you.
#1137 of 1159 camry 2009 can't start
Dec 25, 2011 (2:06 am)
My camry 2009 can't start. I hv few questions to ask:
1) Do adjusting the steering tilting lever when the ignition is on caused this?
2) The battery was jump-started but the engine just don't turn on, I put the cable +ve to+ve, -ve To -ve but no earthing connection,
3) when change to new battery, still can't start, no panel ilumnition light, no power window, the brake can be released, can't move the gearshift from P, but car light is there, cd can be on, though i didn't wait to hear the audio,
4) mechanic checks all the fuses, ok, but suspect the 2 certical long fuses (blue color) under the hood the main culprit.
#1138 of 1159 Re: camry 2009 can't start [limswebg]
Dec 25, 2011 (2:07 am)
sorry, no brake as well. (typo error)
#1139 of 1159 Engine check light on 1999 4-cylinder Camry, code P0446. Needs help.
Jan 01, 2012 (9:48 pm)
First I have to thank many people who posted possible causes on back light not working. I had similar problem and went back to look inside the trunk on the driver side. Immediately I saw 5 of 6 wires were broken. After reconnecting the wires, all the lights worked. Many thanks.
My Camry has another problem. The "engine check light" is on. I used a reader and got the P0446 code "EVAP system, vent control malfunction." I looked around the hoses for cracks. They all seem ok. A manual said it is a bad VSV for vapor pressure sensor. I replaced the old one near the charcoal canister in the back with a new one. The light won't go away. Then I took out the VSV for EVAP near the air filter in the front and tested it. I cannot blow air through it. When I connected a 12-volt battery to it, it clicked and I can blow air. So I assumed it is good. I disconnected the electrical connector to the VSV for EVAP and measured the DC voltage across its 2 pins, when the key was turned to "ignition on" and when the car was started. In both cases, there was no voltage measured. Does this mean it is an electrical problem? What can I test next to locate the problem?
Thanks for the help.
#1140 of 1159 2008 Toyota Camry power outlets not working
Mar 28, 2012 (5:23 pm)
I purchased the car from a dealer in November. Neither outlet worked when I got home so I took it in they changed the fuse and wala until now. Now neither work again suddenly. I have checked the two 20 amp fuses in the fuse panel under the steering wheel, they were fine and brand new looking.
What else could this be. Also not that they should be related but as of a couple weeks ago my trunk release inside doesn't work either.
Any suggestions would be greatly appreciated.
#1141 of 1159 cigarette power outlet under dash-2002 camry
Jul 29, 2012 (3:55 pm)
The power outlet was not working. I pulled the outlet and saw it was not pulled into any wiring. The outlet has two male ends on it. How do I get to the female end ofthe wiring?