Last post on Jul 14, 2013 at 10:18 AM
You are in the Kia Sedona
What is this discussion about?
Kia Sedona, Van
Go to NHTSA to file a safety complaint.
Or call Monday-Friday (8 am to 8 pm ET) (888) 327-4236 TTY: (800)424-9153
#235 of 250 Re: Sharing My 2005 Sedona story [mary05]
Jul 23, 2012 (11:11 pm)
This interference problem has nothing to do with the belt you say broke and the water pump breaking. The only belt that has anything to do with the "interference" part is the timing belt. Interference means that the pistons are timed so that the valves open up a VERY specific times adn if the timing is off the pistons will run "interference" with your valves. Very unfortunate that this happened to you. Belt should have been replaced at 60,000 per the manufacturer specifications (If I remember right). KIA won't be held responsible because as the owner, you are left holding the peices to have them do the work for you based on your owner's manual recommendations. It sucks, the automotive industry has a ton of gaps for this type of thing. Always follow your owner's manual recommendations. I'm gambling with mine right now. Just passing 100K and I just don't want to do it. I hate working on KIA's and I think they are the "bic" lighters of automobiles meaning they are disposable after they run for so long. Might as well toss it and get another one. Will never buy another KIA again. Sorry to hear of your worries.
#236 of 250 Re: Sharing My 2005 Sedona story [rellison0267]
Jul 24, 2012 (7:03 pm)
When we bought it, it already had 70,000 miles on it. Since we were planning a ig trip, we looked in the manual to see when belts should be replaced, etc. When I asked the salesman why they didn't replace our belt at the recommended interval, he said they don't replace them unless they're broken. that sounded legit at the time- but we decided to have it replaced- and the water pump, the tension pulley, serpentine belt, etc- we had all of it done- nothing had broken yet. The point is, that even though we replaced all that stuff, at only a little over 40,000 miles later, the tension pulley to the water pump broke, and the service guy said our timing belt didn't break, but it was "frayed"- he said the it frayed because the tension pulley to the water pump broke and put the strain on the timing belt or something like that because it is an interference engine. He replaced everything, but the engine would no longer hold compression. I also though it was funny- in an irritating way- when I found out to even just replace the spark plugs the manifold had to come off. Sheesh.
#237 of 250 Re: 2004 Kia Sedona shutting down [daveofphilly]
Jul 28, 2012 (3:48 pm)
Hey Philly Dave. I recently bought a 05 Kia Sedona and it has the exact same issues as yours I have only changed the TPS but it still is running the same. Could you please give an update on wether or not your sedona is still running good after all you have done?
#238 of 250 Kia sedona 2002 stalling, no start
Aug 18, 2012 (9:21 pm)
Having the same problems as everyone else here, van will start when cold, run's great for 10-15 mins then engine shakes, stalls, loses power, will not start till cooled down (30-45min's later) engine then starts and shuts off right away, I have read the comments about the service bulletin for the high heat, did changing the TPS throttle position sensor work? I just changed the plugs and oil, so this will be a hopefully easy fix... any thought's?
#239 of 250 Re: 2004 Kia Sedona shutting down [kianightmare]
Aug 18, 2012 (9:24 pm)
Sorry to hear that the TPS did not fix it, I am going to try it on my 2002 kia sedona van, did the plugs and oil change, run's great until hot... then all hell brakes loose. By reading the other comment's have you changed your plugs or wires(wires only get changed if needed, not cheap, $184 up here in Canada)!!
#240 of 250 Re: 2005 kia sedona wont start [guidoj]
Aug 21, 2012 (12:13 pm)
I read your story and here is mine. Did you deal with any of this?
have a 2004 KIA Sedona. I recently took the car in because it would not start. I let it sit for awhile, tried it again and it started however, the check engine light came on so I took it to my KIA dealer for service. I was told, the code that came up had something to do with the fuel system. That repair was made and I drove the car off the lot only to have the same issue happen again. Upon returning to the dealer, although the same codes were coming up, I was told that it had something to do with the harness and the wiring. That was fixed. I drove the car off the lot again only to have the exact same issue occur again. I took the car back to the dealer and after two weeks of back and forth, they replaced the computer. I drove the vehicle for approximately 100 miles in order to get the inspection sticker and guess what, tried to drive it from my driveway and again, it would not start. My vehicle is now at the dealer again, and I have no idea what is wrong, and neither do they. Please help?
#241 of 250 Re: 2005 kia sedona wont start [fixmycar2004]
Aug 21, 2012 (5:28 pm)
Hi, well I have ran into the same problems as you. Here is what I did to fix it I hope:
1. Changed the oil
2. Changed the plugs, and inspected the wires for cracks and signs of worn out ect, put bosch plugs in platinum style.
3. New intake gasket, cleaned everything that I could, TPS (throttle poistion sensor and MASS Air Flow sensor, and what ever else looked dirty (intake too)
4. Took van to Canadian Tire, scanned the cold, code 109, MASS Air Flow.
5. Now replacing the mass air flow sensor and going from there.
This should fix the problem, the van is already running better, google Mass Air flow sensor and it will tell you exactly what it does for the vehicle, pretty important ect.
Check your coils, see if there is 12 volts at the wires where they plug into the coils, if they are cracked in any way or were hot and got wet, more than likely are done, but not cheap to replace, about $104 each here in CAN.
If your hand and can get into a garage or a buddies, taking the intake is easier than it looks, hardest part is the back 4-6 bolt's which you will need a 10mm and a 12mm 1/4 drive socket and the rest of the plug ins are plug and play, make note of the two coolant hoses on the bottom of the coolant sensor that go into the intake ect. If not let the mechanics do it.
But it sounds like they don't know what they are doing, seek another KIA garage or go to Hyundia since they make them.
#242 of 250 Re: 2005 kia sedona wont start [guidoj]
Sep 09, 2012 (10:57 pm)
Experienced the same ignition problem 4 days after purchasing a 2011 Sedona. The engine won't start...or won't start at random times...because the security system is not recognizing the key properly. Take your vehicle to a Kia dealership and ask them to check for a faulty ipm module. I say go to Kia because Kia has to reprogram your key if the module is replaced so the security system will work.
#243 of 250 Re: Sharing My 2005 Sedona story [rellison0267]
Sep 15, 2012 (1:54 pm)
With most OHC engines water pump runs off timing belt. If water pump fails for some reason, it could cause the timing belt to skip or break which causes the engine damage. The only way to avoid the issue of interference engines is to buy a non-interference engine (i.e., Chrysler vans with 3.3 or 3.8 V6; GM Astro, Safari with 4.3 V6; GM Venture, Montana, Uplander, Montana SV6 with 3.5 or 3.9 V6). The Chrysler and GM vans with these engines are all out of productiion and can only be bought used. GM does not make a minivan anymore. New Chrysler vans are OHC.
#244 of 250 Re: 2005 kia sedona wont start [fixmycar2004]
Nov 01, 2012 (5:52 pm)
I have seen a no start condition in a neighbors 2005 Kia Sedona. Turn the key and nothing. It had a brand new starter installed just a little over a month ago and ran until now. Since the starter did not operate checked battery voltage-battery was bought recently- good battery voltage and clean and tight connections - ok, checked starter relay( in box towards drivers side next to battery, clicking and upon applying 12 volts between 85&86 continuity occured at 87&30 working proper : ok, Starter connections checked-tight and clean, jumped starter, solenoid kicked and spun ( whining sound) with no start. Moving large wire around from battery to starter obtained a start condition. Replaced battery to starter wiring, problem solved.
Since this repair I have seen another sedona with same problem and same solution.