Last post on Oct 25, 2013 at 7:32 AM
You are in the Chevrolet Blazer
What is this discussion about?
Chevrolet Blazer, Transmission, SUV
#375 of 384 2000 blazer wont shift on its own, have to shift manually!
Feb 09, 2013 (1:44 pm)
i have a 2000 chevy blazer that is 4x4 automatic! the transmission will not shift automatically but if you shift it mamually it does fine! it only pulls on its on in low and second! if you try to take off in 3rd or overdrive its like its in neautral! have to take off in low or second and manually shift thru the gears! changed the solonoids and fluid and filter and didnt change anything! NEED HELP PLEASE! REX rexmccoysaol.com
Feb 23, 2013 (10:18 am)
I just bought a 00 Blazer. drove home ok just shifted hard from 1st to 2nd. Next day shifted fine then it wouldnt go into 3rd then nothing. on startup i can get it to 1st and 2nd for few mins then it wont go into any gear but park. i can shut off and restart and it will start process over. what can cause this?
#377 of 384 Re: trans. shift issues [00chevyblazer]
Feb 23, 2013 (11:08 am)
This is just an educated guess but it might be your filter getting plugged up from debris from clutch wear in the oil pan, try changing the filter, you might get more life out of the transmission that way. Is it too late to get out of the purchase or have them repair it? If there is debris in the pan most transmission shops will try to sell you a rebuild and it probably needs it but just changing the filter might give you a working trans for many years. a fresh rebuild could improve your gas mileage depending on how bad it is slipping.
#378 of 384 Re: trans. shift issues [jmccann]
Feb 23, 2013 (11:19 am)
I'm up for the challenge! lol time to go buy a filter.
#379 of 384 Re: trans. shift issues [jmccann]
Feb 24, 2013 (12:46 pm)
ok changed the filter and now when in drive it stays in 1st so i have to manually change to 2nd. when i try for 3rd it acts like in neutral still. what's next to try????
#380 of 384 out of ideas
Feb 24, 2013 (5:17 pm)
Well, the filter was my only suggestion, I looked at some forums after replying to your message and there was talk of solenoids there, was there much sediment in your oil pan?
#381 of 384 Re: 2000 BLAZER TRANSMISSION PROBLEM [tcroft49509]
Apr 07, 2013 (3:42 pm)
Check the transfercase to see if it engaging run it through neutral 4hi and 4 lo and back into 2hi
#382 of 384 02 chevy blazer xtreme
Apr 12, 2013 (9:12 am)
i have an 02 chevy blazer xtreme that seems to rev up to 3000 before it shifts like if its in nutral anyone got advise
#383 of 384 Re: 2003 Chevy Blazer Tranny Problems [dne_thompson]
Oct 16, 2013 (10:52 am)
When you are replacing the transmissions are you also keeping the original transmission control module or using the one on the used trannys? I ask cause I have had this issue on many older vehicles not just a chevy blazer and an transmission shop told me that my control module was bad and they will keep burning up trannys till you replace them. I did that and footed the bill for a new tranny with a 3yr 36000 mile warranty on my blazer and other vehicles and no problems since then for over two yrs on my blazer
#384 of 384 1996 Chevy Blazer 4x4 Transmission problems
Oct 25, 2013 (7:32 am)
as I am driving, keeping the pedal held down slightly, it runs and shifts fine. If i press the pedal down about 1/3 of the way, the rpms drop and coasts. if i push the pedal to about 2/3 of the way, the rpms pick back up and moves forward, but with less power than normal and i have to let off the pedal for it to shift.. Also when i stay at a constant speed, the transmission slips. If i press the pedal down any farther, the rpms go up but there is no acceleration.