Chevrolet Blazer GMC Jimmy Transmission Problems

382 messages,  Last post on Apr 12, 2013 at 10:12 AM

You are in the Chevrolet Blazer Forum.

What is this discussion about? Chevrolet Blazer, Transmission, SUV

#367 of 382 replaced trans; no gears by mtmtntop

Apr 14, 2012 (12:01 pm)

95 blazer 4x4 4.3; seal went out while my wife was driving, ran it dry, but it still shifted into 1 and 2nd. i bought a used trans, which was identical but now i have no gears at all. I have checked to make sure flex plate is on right, pulled a radiator cooling line to make sure front mount pump working. when i installed, i had to pull the converter back out about a quarter inch to bolt to flexplate. i have run it to check the fluid. all these things check out. i hear a whirring noise no matter what gear i have it in, but the vehicle does not move. any ideas?

#368 of 382 99 Blazer LS auto 4wd no reverse by jayarmbar

Aug 06, 2012 (1:41 pm)

First off I am new to the forum. I did spend a couple of hours searching for my problem. I found a few that were close and I tried some of the solutins that were posted.
 I have a 99 Blazer automatic with the auto 4wd, 4 buttons 4.3 vortec.
  
Last night I was driving home and heard a loud squeal and felt like I lost power. The engine was still running it just didnt feel right. So I parked it and left it overnight.
  
This morning I got in started and Reverse does not work at all. I can go forward in all four gears 1,2,3 and D. I checked the fluid both hot and cold and it is fine. I disconnected the battery and tried to find the trans. fuse as was suggested in another post. I couldn't find the trans fuse so I just checked the onesthat the owners manual said were engine, selenoid etc. Still no reverse.
  
I looked for the plug and neutral button but couldnt find them. There is what appears to be a kevlar plate from the front bumper almost all the way back to the back 2 doors. It has some type of oily fluid all underneath it.
  
I am not a mechanic and don't know a whole lot about newer cars. I am not in a huge rush but I would like to use my only car.
  
Thank you all in advance.

#369 of 382 Re: 99 Blazer LS auto 4wd no reverse [jayarmbar] by jmccann

Aug 06, 2012 (4:19 pm)

Replying to: jayarmbar (Aug 06, 2012 1:41 pm)
I don't have any suggestions for you except to suggest you take it to a transmission shop to have it diagnosed and possibly repaired, I have had similar problems with my Blzer but I lost all forward gears but still had reverse, I tried to pull the transmission myself and I did get it out but I had no confidance in putting it back in after it was repaired so I had a local shop do it, the bill was over 3,000 dollars and in hindsight I should have put the money into a newer truck in the first place. The transmission went out three more times after the rebuild but it was repaired under waranty, the final fix was turning up the pump pressure for firmer shifts, I am still driving it.

#370 of 382 hard shift when cold??? by w_hoeksema

Sep 22, 2012 (7:16 pm)

I have a 99 blazer 4wd. Just had the transmission and transaxle rebuilt maybe 6 months ago. Here recently I have had issues first thing in the morning. To me it feels as if it's not catching gear right away, but once it warms up the problem seems to go away. Fluid level is where it needs to be. I have talked to a few mechanics, the only thing I have heard is possibly the shift solenoid. Does anyone have any ideas or suggestions?? Will be much appreciated.

#371 of 382 1995 Chevy Blazer troubles by billy19702

Oct 30, 2012 (6:34 pm)

I have a '95 Blazer 4.3 Vortec, and everything seemed to be fine until recently the transmission started to slip. It seems when you gas harder on it it does not slip. There is also an approximate 2 or 3 second delay when shifting into drive...anyone have any suggestions?

#372 of 382 Re: 1995 Chevy Blazer troubles [billy19702] by jmccann

Oct 30, 2012 (6:52 pm)

Replying to: billy19702 (Oct 30, 2012 6:34 pm)
I think changing the filter might take care of the problem for awhile.

#373 of 382 Re: 97 Blazer Issue [skstn34] by rcbusiness

Nov 27, 2012 (3:35 pm)

Replying to: skstn34 (Feb 05, 2010 5:55 pm)
try filling the truck with 93/94 octane for 1 or two tanks. i had the exact same problem whenever the truck tried to auto shift down. while USING CRUISE CONTROL, , as i started up the highway incline at 70 mph and the speed started slowing down, when the truck rpms at 2k didnt match up with the over drive speed it tried to shift out of overdrive, the truck started sputtering like it was running on 4 cylinders, or loss of compression the service engine light comes on, etc etc.
 next week i only used 93 octane, and octane boost (once) to clean out the engine. It worked,
same highway, the truck slowed to 65 on the same hill while in cruise control. It made the hill at 65 without any problems.
if the truck is not in OD it doesnt seem to happen. ANy way. its a defect with the truck, but its a cheap fix.

#374 of 382 2003 Chevy Blazer Tranny Problems by dne_thompson

Jan 06, 2013 (8:24 pm)

I have a 2003 Chevy Blazer 4dr LS 4X4. I am the 2nd owner and knew the 1st owners, an elderly couple that lived next door. I bought it in 2006 with 33,000 miles on it and have owned it for the last 7 years. Last year, my transmission went out with no warning, just slipped a couple of times, and poof, I suddenly lost my D & 3 gears, but still had R, 2, &1. I was in a rural area when it went, so by the time I got anywhere near civilization, you could definitley smell it burning. At the time, it had 117,000 miles, so I thought that it had earned the right to go. However, was a little disappointed that it didnt last longer, considering I've had the local GM dealership doing all maintenance on it as did the last owners! Since it had that many miles and due to age and limited budget, I purchased a salvaged transmission with a 1 year warrenty. All went well for 13 months, then again, in the middle of no-where, the vehicle starts doing its familiar "missing" which was actually the tranny slipping. Again, sure enough, this transmission as well as the first, both burnt up with little to no warning at 130,000 miles. I again, due to budget, mileage, and age went with another salvage tranny, and it immediately slipped and burnt up at 135,000. Keep in mind, I do no towing with vehicle, it is driven around my little city and I am single, so there is no hauling of anything but me. I am now on tranny #4 and would like to try and figure out why these trannys keep burning up. A friend of mine told me that the radiator on some vehicles help aid in cooling the transmissions. I dont know if its true, but it kindof makes sense to me, because mine always has smelled like "hot" antifreeze everytime a tranny has went. I also have always checked fluids in the vehilce regularly. They are always full and the color they should be, no leaks have been noticed or found, as it it always parked on pavement. Any words of advice????

#375 of 382 2000 blazer wont shift on its own, have to shift manually! by realmccoy70

Feb 09, 2013 (2:44 pm)

i have a 2000 chevy blazer that is 4x4 automatic! the transmission will not shift automatically but if you shift it mamually it does fine! it only pulls on its on in low and second! if you try to take off in 3rd or overdrive its like its in neautral! have to take off in low or second and manually shift thru the gears! changed the solonoids and fluid and filter and didnt change anything! NEED HELP PLEASE! REX rexmccoysaol.com

#376 of 382 trans. shift issues by 00chevyblazer

Feb 23, 2013 (11:18 am)

I just bought a 00 Blazer. drove home ok just shifted hard from 1st to 2nd. Next day shifted fine then it wouldnt go into 3rd then nothing. on startup i can get it to 1st and 2nd for few mins then it wont go into any gear but park. i can shut off and restart and it will start process over. what can cause this?
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement