Isuzu Trooper Maintenance and Repair

385 messages,  Last post on Jun 13, 2013 at 2:32 PM

You are in the Isuzu Trooper Forum.

What is this discussion about? Isuzu Trooper, Isuzu Trooper II, SUV

    
 
Go to NHTSA to file a safety complaint.
 
Or call Monday-Friday (8 am to 8 pm ET) (888) 327-4236 TTY: (800)424-9153

#366 of 385 Re: 2001 Isuzu Trooper rough sounding under 35 mph [jmie] by lilypad1

Apr 16, 2012 (4:09 pm)

Replying to: jmie (Jun 12, 2010 3:05 pm)
I think I bought her Isuzu trooper and I want to get it fixed, I have taken it to every mechanic I know. We had it scanned at a transmission shop and they said no problems with the tranny. We put a new used drive line in it, rotated tires, new brakes, It makes a noise like you driving over a grid between 30 and 35 and then goes away after you get higher in speed. If I put in Power drive (its only two wheel drive) it doesnt do it until it reaches 40 to 45. Any ideas would be hreatly appreciated.

#368 of 385 Clutch going out by micahboz

Apr 16, 2012 (6:13 pm)

I have a recurring problem on my Isuzu Manual Transmission. Once every three months or so, my clutch goes limp and I can't get it to shift at all. I then take it into a mechanic who tells me he replaces my clutch cylinder, and it seems to work again for a bit.
 
Why is my clutch going? Is there some sort of hydraulic pump with a leak perhaps?

#369 of 385 Re: 2001 Isuzu Trooper rough sounding under 35 mph [lilypad1] by molylepke

May 02, 2012 (5:30 am)

Replying to: lilypad1 (Apr 16, 2012 4:09 pm)
Its the heatshields over your exhaust. They are cracked and when air goes through them the make a terrible noise. Fix: leave it alone or take them off.

#371 of 385 Pic by rsst

May 08, 2012 (7:25 am)

Could somebody send me pictures of a 96 trooper engine. Need to look at thermostat housing. Have a extra hose an it's been plugged off an don't know where it goes. Chiltons manual is garbage!!!

#373 of 385 1994 trooper 4x4 5 speed manual wont go into 1st or 3rd or 5th by advcomps

May 09, 2012 (9:07 am)

I just changed the clutch last week and it drove OK for a few days. It will go into 2nd , 4th and reverse. The clutch is working fine because it will not roll on a hill when the clutch is engaged. I have removed the shift lever and the plastic peice on the bottom is OK. I tried to shift it into 1st 3rd or reverse with a screwdriver and it will not shift into those gears. Any Ideas?

#374 of 385 Rough Running 2000 Trooper codes p0300 and p0401 by jsteren

May 11, 2012 (10:47 am)

2000 Trooper with 177k miles. Car was running fine but needed new EGR. I had the EGR replaced, new plugs, and new valve cover gaskets. Now it is running poorly, mis-firing, especially under load. It first was displaying the p0401 code for insufficient EGR Flow, then a code for misfire in cylinder #1, and now is throwing the p0401 code and p0300 code for random/multiple misfires in all cylinders. The check engine light will occasionally start flashing, usually at freeway speeds. Any help would be greatly appreciated. Thank you, Jacob.
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement