Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Pickups Dodge Ram Dodge Ram Gasoline Engine Questions
159 messages, Last post on Nov 09, 2009 at 1:38 PM
You are in the Dodge Ram Forum. Your Host is kcram
|
Replying to: nws683 (Jan 28, 2007 2:35 pm) |
|
| I have an 01 Dodge 4x4 with 5.2ltr Truck worked fine one day stopped for lunch came out ran like I was running out of gas. Gas gauge said 1/4 tank but filled it up anyway. Still acted up but not as bad. Got it home thought it was not getting fire so changed the plugs and changed the oil and filter and changed the air filter. Still no luck so then changed the fuel pump because go figure dodge put the filter in the tank but this did not work. Changed the igntion coil and the crank shaft sensor still no luck. So bad now it had to be towed to a shop and I am not getting any check lights and the dio cant get any fails either. Mechanic has had truck for 2weeks and cant figure it out | |
|
|
|
|
| My 75000 mi 4.7 has very poor acceleration from idle to 2500 and it also surges under acceleration but not when maintaining speed, any clues? | |
| I have a 2001 dodge ram 1500 quad 4x4 with the 5.9L engine. On occasion under full speed it would flutter and lose power for a few seconds, appear to want to stall, all of the gages dip, and then regain normal operation. This happened a few times over the last year. The last time this happened it completely lost power and stalled, no power steering, no power brakes, but electronics such as wipers and radio continued to function. After coming to a stop, the truck immediately started right back up with no problems. The MIL light has been on. I checked it at autozone and the code was P1491 which was for a blown fuse for the AC condensor fan. No other fault codes appeared. Please help. Anybody else have this problem? What should I check? | |
|
I posted to the transmission problem forum and did not see any activity...I hope I can post it here too... Thanks, , I baby this truck. I have a 2001 Dodge Ram 4x4, 360 motor, 5.9 with 46RE, I think. Automatic Tranny. I have 180,000 miles on the truck and motor. I replaced the tranny with a Jasper about 90,000 miles ago. About 30,000 miles ago I had the tranny flushed by a machine. The tranny started shifting funny a few weeks ago. I would give it the gas and it would shift up normally then sometimes it would not shift up, without letting off the gas a bit. I could sometimes take it easy and it would shift fine through the gears. Sometimes I could stand on it, and it would shift fine. The other day it started as normal and will not shift up past 1st gear. I can go in reverse too without a problem. I can put the shifter into 1 and 2 and D and the truck will go but not past 1st gear. I get NO codes but "P doNe." "My first tranny went out with NO notice or acting funny at all. It just quit and the engine kept winding." For the last year or so...If my truck would sit for a day or so, when I went to start it up, the transmission would have to build up pressure for a few seconds before it would finally grab hold and go after putting it in drive...I was told this was normal and not harmful. I was told to change the filter and fluid, along with the governor pressure solenoid and sensor… Does this sound right? When I get the pan off can I do anything else that needs to be done like band adjustment, and to what spec? Taking into consideration the pan is not filled with debris. I guess a CLEAN pan is a GOOD pan. Can I tell if the right fluid has been used in it? Thanks for any help you can give…
|
|
|
I have a 2001 Dodge Ram 360 with 46RE tranny. I am having tranny problems... Doing the On-Off-On-Off-On test I get no codes other than "P doNe." Can I use another type of scanner and get codes...OR is this way of getting codes the same? Thanks, Cwiseguy
|
|
|
Replying to: cwiseguy (Jun 24, 2009 2:47 pm) Regards, Corkscrew |
|
|
Replying to: cwiseguy (Jun 24, 2009 7:40 am) I had the Governor solenoid and Governor sensor replaced...I had the fluid and filter changed and the bands adjusted... It did not fix anything...$400 and the same problem... The tranny guy said I had the normal stuff in the pan for 80,000 miles and a little more than the average... Does anyone have any other ideas... My next one will be a manual tranny... Thanks, Cwise
|
|
|
|
|
Replying to: cwiseguy (Jun 29, 2009 5:21 pm) |
|
You are here:
Forums
Pickups Dodge Ram Dodge Ram Gasoline Engine Questions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Dodge Ram Pickup 1500
2010 Dodge Ram Pickup 2500
2010 Dodge Ram Pickup 3500
Browse by Board
Browse by Topic
Today's Chats
