You are here: Forums Pickups Dodge Ram Dodge Ram Cummins Diesel Questions

Dodge Ram Cummins Diesel Questions

647 messages,  Last post on Dec 04, 2009 at 5:09 PM

You are in the Dodge Ram Forum. Your Host is kcram

What is this discussion about? Dodge Ram Pickup 2500, Dodge Ram Pickup 3500, Diesel, Truck

Messages Page 64 of 66 1 ... 60 61 62 63 64 65 66 Prev Next Last

Go To Msg # Search This Discussion

#626 of 647 transfercase problem by donavonk Oct 05, 2009 (3:57 pm)
i have a 2002 4x4 diesel yesterday it wouldn't engage into 4 wheel drive this is a manuel transfer case hooked to a automatic tranny any sugestions? 111000 miles never any problems w/ transfercase Replies to this message: ramcharger (Oct 05, 2009 6:02 pm)
#627 of 647 Re: transfercase problem [donavonk] by ramcharger Oct 05, 2009 (6:02 pm)
Replying to: donavonk (Oct 05, 2009 3:57 pm) Not sure what transfercase is in your truck, but unless you forced the shift lever, chances are the axles may have a disengage vacuum on it and may be your problem. On older cases the shift forks bend or wear out, usually from lack of oil, so good luck.
#628 of 647 Re: Fuel economy [jellisndnlvr] by ramcharger Oct 05, 2009 (6:08 pm)
Replying to: jellisndnlvr (Aug 17, 2009 11:52 am) first of all don't even believe that in truck milage meter, it's crap. Test your milage by dividing the miles driven by the fuel used. My 04 gets terrible milage. Wish I knew how to improve it.
#629 of 647 Re: Turn signal failure for trailer hookup [lonnie13] by ramcharger Oct 05, 2009 (6:13 pm)
Replying to: lonnie13 (Aug 17, 2009 1:24 pm) My first question would be how you know that the wire from the fuse to the trailer plug is ok? There is a fuse to each side in the fuse box. Check ton make sure it has power on both sides.
#630 of 647 valve adjustment by fxstb09 Oct 07, 2009 (10:08 am)
I'm a 310T tech. I would like to find the valve adjustment prosedure for a 2003 ram 2500 diesel
#631 of 647 04 2500 ram pull start only by gast Oct 14, 2009 (4:51 am)
I have a 04 2500 cummins manual trans . It turns over fine with adiqite speed to start but wont. If we pull start it it fires right off. After its warmed up the same problem still persist. Will only start if its pulled. When it starts it runs fine. No check engine lights. Have not checked for codes. Replies to this message: kcram (Oct 14, 2009 6:49 pm) mckenzie101 (Oct 15, 2009 4:42 am)
#632 of 647 Re: 04 2500 ram pull start only [gast] by kcram HOST Oct 14, 2009 (6:49 pm)
Replying to: gast (Oct 14, 2009 4:51 am) First, check your batteries. Even if only one of them is low on voltage, you will have enough juice to run the engine and all the electrical accessories, but not enough to start the engine (that's why it needs two high-output batteries - just to get the engine started). The old mechanical 12-valve Cummins that was used until early 1998 could run without any electricity once it was started.   If the batteries test ok and the problem persists, check the cables and starter.   kcram - Pickups/Wagons Host
#633 of 647 Re: 04 2500 ram pull start only [gast] by mckenzie101 Oct 15, 2009 (4:42 am)
Replying to: gast (Oct 14, 2009 4:51 am) My guess is a Cam or Crankshaft position sensor. By pull starting it you my be turning the engine over faster than the starter therefore allowing the sensor to read and communicate with the ECM. This is just my guess. Let me know what you find out...   Randy
#634 of 647 cummins smokin by warlord3 Nov 06, 2009 (5:36 am)
last week our 08 3500 started smokin, black, huge clouds, and progressively worsened with a tapping or clicking from engine. replaced an injector from cummins, but no change and looked like now fuel in oil. pulled replaced injector and one next to it for compare and they are different size at seals. Also looked at the modulator valve on top of charge air piping and it was completely garbaged with soot and not closing completely. suggestions?
#635 of 647 change over exhaust by rightairwing Nov 06, 2009 (3:54 pm)
is it any way to get rid of the epa stuff on the 6.7 (2008 2500)?i don't care about the warranty any more.this thing has had the cheeck engine light on so many times i lost count.it has been the exhaust system every time.it has only 13,000 miles on it.i am ready to get the buy back thing going with it.i heard that it was a kit that you can get to get rid of this problem.IE remove the stock exhaust system.any info on this kit is welcome.

Messages Page 64 of 66 1 ... 60 61 62 63 64 65 66 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Dodge Ram Dodge Ram Cummins Diesel Questions