- #547 of 647
-
have no 4 wheel drive
by jason97
-
Apr 12, 2009 (8:51 am)
-
|
|
97 2500 5.9 cummins 5 speed n/v4500 trans 4wheel drive had some tranny work done.went to use 4 wheel drive.it did not work light would not come on front axle would not engae please help?
|
- #548 of 647
-
Re: have no 4 wheel drive [jason97]
by red777
-
Apr 12, 2009 (10:38 am)
-
|
|
Replying to: jason97 (Apr 12, 2009 8:51 am)
the cheapest start would be to check your vaccum hoses and the vaccum horn on the front axle. dont just look and see if they are connected, make sure they dont leak, as well the vaccum horn on the front axle could be bad.
good luck
|
- #549 of 647
-
have no 4 wheel drive
by jason97
-
Apr 13, 2009 (3:58 pm)
-
|
|
whay do you mean by vaccum horn? how would you check for leaks?
|
- #550 of 647
-
Re: 04 Ram Idling rough [emdenton]
by jason97
-
Apr 13, 2009 (4:12 pm)
-
|
|
Replying to: emdenton (Mar 31, 2009 7:12 am)
I know someone that was running off road fuel(heating oil) in a06 that they bought new they put 44k on it and was hard starting burnt up a starter changed fuel filters still the same. took it to a dealer they said clogged injectors from off road fuel.Had to replace all of thee injectors.
|
- #551 of 647
-
Re: Fuel Problem ??? [rudybaker]
by jason97
-
Apr 13, 2009 (4:23 pm)
-
|
|
Replying to: rudybaker (Apr 04, 2009 5:33 pm)
may be losing its prime when it sits was there ever any injector work done to it?
|
- #552 of 647
-
06 dodge cummings oil leaks
by eric456
-
Apr 15, 2009 (2:34 pm)
-
|
|
i have 06 cummings,which has oil accumalating on front of transmission a very little amount happens only when running .doesnt LEAK Over nite like oil pan leak a FEW OIL PAN BOLTS HAVE OIL ON AND WET oil appears when you drive truck is that oil coming from blowby tube
|
- #553 of 647
-
Re: 06 dodge cummings oil leaks [eric456]
by jond09
-
Apr 15, 2009 (8:05 pm)
-
|
|
Replying to: eric456 (Apr 15, 2009 2:34 pm)
I also have an 06. My blowby tube extends just past the pan bolts an even if it leaked it would not show on the pan bolts. You could get a piece of tube just big enough to press onto the blowby tube to extend it past where you are seeing the oil build up to prevent any leakage from getting on anything. Then clean everthing off really well. Then if the problem continues you can atleast elliminate the blowby tube.
|
- #554 of 647
-
Re: cummns temp. [barrc_ranch]
by roland3
-
Apr 16, 2009 (4:34 am)
-
|
|
Replying to: barrc_ranch (Apr 02, 2009 7:20 am)
... I might start an argument, but these numbers would not bother me; especially with synthetic oil. If we go any further you might have to install an old mechanical bulb type gage to make the discussion worthwhile.
|
- #555 of 647
-
Re: 2007 DODGE RAM 2500 6.7 DIESEL [oldtech]
by steve194
-
Apr 17, 2009 (8:50 am)
-
|
|
Replying to: oldtech (Jan 22, 2008 12:43 pm)
I have an 2008 Ram 2500 megacab which now has 22,000 miles. The check engine light started coming on after 6,000 miles. The first solution was that a sensor needed to be replaced. That lasted for a little while before I was back to the dealer with check engine light on again. This time the turbo needed to be cleaned. That lasted about 2 weeks before so then the dealer replaced the turbo at 12,000 miles. Now at 22,000 miles the engine light is back on again and the truck is in the shop. Their answer this time is cleaning the exhaust system and possible sensor replacement. All of this is covered under warranty now, but what happens after 36,000 miles and you are still having problems with the exhaust system?
|
- #556 of 647
-
Re: 2006 dodge3500 ram [nascarcamper]
by tds566
-
Apr 17, 2009 (3:21 pm)
-
|
|
Replying to: nascarcamper (Mar 14, 2009 5:33 pm)
I have same problem had update done on 2006 and mileage went downhill. I disonnected my battiers one day and mileage went from 16 to 19.5 then did battiers again and went back down no body can explain dealers not interested dodge customer service same thing did you find out anything. I think batteries sent ecm back to orginal not sure but no one can explain
|